Q:Planer planer

Lift the knife board to be flexible, or planer back with the processing surface scratching, easy to lead to blade damage; also should not be too large, the gap is too large, planer will swing around, the return process will scratch with the processing surface, damage the blade.

Q:Planer Planer Mesh Keyway The direction of the knife should be up or down

the knife must be fixed to ensure that the cutting machine due to reciprocating movement caused by the knife back and forth beating,

Q:What is the working principle of the lower planer?

The rotary motion into a linear reciprocating motion, the main movement of the ram, the table to do the feed movement.

Q:What is the black planer ah? Can not planer and milling machine into one? I need a detailed answer, thank you

There are two ways to exist at the same time the gantry planing machine, the reason is the same.

Q:Machining of machinery

Some machines can be installed on the table too small, and some machine tools to build a special plant to accommodate the next.

Q:Gantry planer lift knife coil and diode in parallel what role? Lift knife coil always burn, there is no good way?

you can tell the question of whether the diode is open

Q:Why is milling easier to plan when machining in large quantities?

However, in the mass production of processing plane, because the planing is a straight reciprocating motion, the return is air return; milling can be installed disk cutter more than the blade at the same time cutting, cutting margins and high production efficiency.

Q:Lathe, boring machine, drilling machine, milling machine, slotting machine which can work with gloves!

As long as the equipment is running to prevent the hand into the processing office.

Q:Is the planer of the black shaver or the straight head?

There are elbows are straight, basically 60 degrees sharp planer, strong planer and many other elbow straight head planer.

Q:I participate in the work of the welding workshop dry planer, continuous enjoyment of more than 8 years of health care is not a special type of work?

In the welding workshop dry planer, enjoy more than 8 years of health care can not be considered special types of work, is not a special type of work, according to 1993 before the original Ministry of Labor approved and your industry authorities to develop a special list of types, some of which are special