It is both soft and lightweight. It consists of oilresistant synthetic rubber tube, one highly tensile steel wire layers, andrubber cover. The rubber cover features resistance to abrasion, oil, weatherand aging. Its oil resistant synthetic rubber made inner tube is air and oilproof. Besides, the black reinforced layer with textured surface is braidedwith copper ...
- Q:Stainless steel metal hose and flexible rubber joint which is easy to use?
- Stainless steel metal hoses and flexible rubber couplings are used for pump inlet and outlet to absorb vibration and noise during the operation of the pipe pump. The two products are common in the case of ordinary media.
- Q:The basement of submersible sewage pump outlet pipe installation need and flexible rubber joint is not installed? Can not?
- Gu called it a shock throat. It not only plays a role in noise reduction, but also protects the pump from the adverse effects of vibration. Rubber joints belong to GB products, the price is not expensive. Recommended installation.
- Q:Are the bridges, bellows and rubber tubes drawn out or are they drawn only? And the bellows are tensioned with the steel strand?
- It is relatively rare, usually corrugated pipe for zinc metal corrugated pipe, the construction unit may be in order to prevent pipe blockage, when pouring concrete, the corrugated pipe with rubber tube, after pouring completed final setting, you can pull out rubber tube. Bellows need not be drawn.
- Q:The difference between silicone tube and PVC tube?
- Silica gel tube, material and chemical properties of silica gel is stable, in addition to alkali, hydrofluoric acid does not occur with any chemical reactions, chemical resistance, good electrical insulation performance, not easy to aging weather resistant, soft material up to 330 degrees to -40 degrees, non-toxic material, colorless and tasteless, mainly by all family activities. Life tube will choose to use silica gel material, the main use occasions in household appliances, medical industry, industry, automobile industry and so on.
- Q:What are the types of cable metal hose connections?
- Mainly used for internal thread connection pipe and the hose thread cable.
- Q:Must the hose for the cooker be made of oil resistant rubber hoses?
- When the gas combustion equipment and gas pipeline for hose connection, the design should meet the following requirements: (1) the burner of household gas stove and laboratory use, the connecting hose length should not exceed 2m, have no interface; (2) industrial production with mobile gas burning equipment, the connecting hose the length should not exceed 30m, the interface should not exceed 2;...
- Q:What is a rubber core pulling method?
- The hose shall be filled with water or gas at a pressure of 0.5 0.8N / mm before pouring concrete. At this point, the hose diameter can be increased by about 3mm. When pouring concrete, the vibrating bar should not touch the hose, and should check the pressure of the water meter regularly. If there is any change, the pressure must be filled.Smoke tube longer than tube core pulling slightly later. Before the pipe is pumped, the water is lowered and the pipe section is reduced, and the pipe can be drawn away from the concrete. The order of pumping is usually first, then first, then first, then straight.
- Q:What's the rubber sleeve of the expander?
- The expansion device is also called expansion joint, expansion joint, compensator and expansion joint. The expansion device is divided into steel telescopic device, rubber telescopic device and stainless steel telescopic device according to the material. Expansion device capable of axial expansion in a certain range, the offset can overcome different axial pipe butt within a certain angle and produce, installation and convenient disassembly pipeline valve greatly, in the pipeline to allow expansion in free expansion, once over its largest expansion amount rise to limit, to ensure the safe operation of pipeline the. Mainly for the protection of the safe operation of the pipeline, has the following functions: compensating absorption pipeline axial and transverse and angular deformation; absorption equipment vibration, reduce the vibration on the impact of pipeline equipment; deformation of the pipeline, absorb seismic subsidence.
- Q:Production process and raw material of rubber
- The relationship between tensile strength and rubber structure: a large force between molecules, such as polar and rigid groups; the molecular weight increases, increasing the fan Edward force, the chain segment is not easy to slip, the equivalent of molecules formed between physical crosslinking points with the molecular weight increased, the tensile strength increased to a certain extent reached equilibrium; microstructure the molecular structure, such as the effect of cis - and trans structure;
- Q:The newly purchased natural rubber tube is too large. How can it be removed?
- When rubber is peculiar, it can be scrubbed by hydrogen peroxide. After drying, the odor will disappear. Or with waste tea sent to rubber products, tea has the role of adsorption odor.
1. Manufacturer Overview
|Annual Output Value
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
|No.of Employees in Trade Department
|No. of Production Lines
|Product Price Range