Voltages up to 35kv PVC/XLPE Power Cable

Ref Price:
Loading Port:
China main port
Payment Terms:
TT OR LC
Min Order Qty:
200 m
Supply Capability:
20000 m/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Specifications

PVC/XLPE power cable up to 35kv
1.Professional supplier
2.Reliable quality,best price
3.Strong capacity,fast delivery
4.ISO

Voltages up to 35kv PVC/XLPE Power Cable

 

Brief Introduction

PVC/XLPE power cable is used to transmit and distribute power in power transmission and distribution system of 35kV or lower. It is generally applied to the fields including power, construction, mines, metallurgy, petrochemical industry and communication in complete replace of oil immersed paper insulated power cable and in partial replace of PVC insulated power cable.

 

Standard

The products can be produced according to our factory specification which is equivalent to the standard IEC60502.The factory can also design and manufacture special power cable according to the other standards required by the customers.

 

Properties of  PVC Power Cable

 

1.The long-time permissible working temperature of cable conductive core is not more than 70 degrees.

 

2.During short circuit (max permanent time is not more than 5 seconds), the max temperature of cable conductor is not more than 165°C.
3.The difference level of laying cable is not restricted.When laying the cable,ambient temperature is not lower than 0°C.
4.They have good chemical stability,and properties of acid resistance,alkali resistance,salt resistance,oil resistance,solvent resistance and flame resistance.

 

Properties of XLPE Power Cable

1.The highest allowed operating temperature of conductor for long-term working is 90 degrees.

2.In short circuit (Max long term is no more than 5 seconds). The highest temperature for conductor is no more than 250 degrees.

3.The cable is laid without horizontal drop limit. The environment temperature should be no lower than 0 when lay. Otherwise it should be preheated.

4.Excellent electrical performance, resistance to chemical corrosion.

5.Can stand advisable traction when laid.Can stand traction from Outside.Left low smoke halogen-free after burned.Retard the burning of the cable.

 

Nominal Cross-sectional Areas

1.5 mm2 , 2.5 mm,4 mm2 , 6 mm2 , 10 mm, 16 mm2 ,25 mm, 35 mm2 , 50 mm,70 mm,

95 mm,120 mm,150 mm2 ,185 mm,240 mm2 ,300 mm  400 mm2  , 500 mm2  ,   630 mm2  , 

800 mm2

 

Production range

Single core cable: from 1.5 mmto 800 mm2,

Multi-core cable: from 1.5 mm2 to 400 mm2

 

 

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:"Cable laying" cable cross-sectional area refers to the cable cross-sectional area, or refers to the copper core cross-sectional area
Low-voltage power cable, also known as: low-voltage power cable. The voltage rating is 0.6 / 1KV. National Standard No .: GB / T-2008. The voltage rating of the control cable is 450 / 750V. National Standard No .: GB / T9330-2008. The voltage rating of these two cables, the country has a clear standard. Can not be changed.
Q:Is there a compatable power cable for Advent AW10 printer?
If there is extremely some complicated pics and colorations then definite it is achieveable. The shopkeeper from Curry's had pronounced it prints as much as 250 pages consistent with cartridge notice what he pronounced *as much as* 250 pages.
Q:Data Cable functions?
The power cable will just power up the CD drive but NO music goes to motherboard and its sound port. Even just connecting the small audio connector between the CD drive and motherboard will produce sound output. Connecting the data cable to motherboard enables Windows to read and play the music files.
Q:shoulkd i get a new set of ground and power and rca cables?
The first consideration is how much power can your speakers handle without self destructing? My opinion is that few can productively handle more than a couple of hundred, and that would be for very brief peaks. The average listening level in a domestic situation is on the order of a few watts - 10 or less. If you really have speakers that can handle that amount of power, and you want to deliver it efficiently, then you need to keep the 2-way resistance of the wires from the amps to the speakers at less than 10% of the speaker impedance. So for 4 ohm speakers (worst case) you want the line resistance to be below 0.4 ohms. For a 50 ft (100 ft 2-way) cable run, that suggests 16 AWG minimum wire gauge for each speaker. Your existing RCA cables should be OK assuming they only carry low level signals. If your present power service and grounding are on a 15 or 20 Amp branch circuit (US) , and no other heavy appliance loads (refrigerator, washer, airconditioner) are on that branch, then it is OK for the new amps.
Q:ATX power cable missing pin?
are u talking about the 4 pin connectors on the power supply if so there should be more then 1 and interchangehable. if your talking about the pins on the ide cable slot on the board then u might be able too straighten them with tiny needle nose pliers or jewelers screw driver but be very careful u break a pin the board is done.if u can maybe be more specific ill try too help!!!!!!!!!!
Q:This graphics card doesn't need power cables right?
it depends on which 750ti you buy some dont need power some do but if you have a 450w psu then you should have a 6pin pcie on it anyway
Q:Power cable for Seagate Expansions 500GB External Desktop USB 2.0 Hard Drive ?
Radio Shack or any computer store can sell you a generic replacement power cable for the drive. You can also get a replacement USB cable for it while you're at it in case that cable is wearing out. - Stuart
Q:COMPUTER POWER SUPPLY SPECIALISTS I NEED HELP!?
That Xbox power supply cable is pretty cool! I've never seen those before. Ok, as for the power supply questions: Peak power is the maximum amount of power the unit can supply for a short period of time (a few seconds at most). A computer, during start-up, will use quite a bit more power than once it has achieved steady state. This is because drives have to spin up, semiconductors have to power up, etc. Once everything is up and running, the power draw drops to nominal or steady-state Sustained power is the amount of power the unit can supply non-stop. When purchasing a power supply, always give yourself leeway. If a supply indicates it is 650 watts sustained and 80% efficient (gotta look at that efficiency!) then it can supply 520 watts of power continuously. Even at that, I wouldn't want to run it past 450 - 475 watts continuously. 12v DC is the high rail on a power supply. Different parts of the computer require different voltages to operate. Drive motors typically need the 12v DC, where as memory needs less than 3 volts. A computer power supply has different rails or supply wires which supply the following voltages: +12 volts DC, +5 volts DC, and +3 volts DC (there are some others but those are the key ones). I don't know what the power requirements are for an Xbox 360, but it obviously needs the 12 volt and 5 volt DC rails to power it. Anyway, the power supply you've listed above is more than adequate.
Q:What does an AMD Radeon HD 7850 power adapter cable look like?
I have never seen one in my life! But have you researched it on google?
Q:can i use my PC power cable for my xbox 360. (plugging it into the power brick)?
Don't do it. The power brick is what powers the console and you need it to properly run it smoothly. Just get a power brick. If you don't have one, go on OKorder.

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range