Widely used in the fields of post office,store,elevator,hospital,school,publishing house and stock exchange where normal voltage is in need,and also can be used in the factories of large and middle-scale industrial and mining corp,it is very much suitable for some important devices and supporting single machine.
Three-phase four-line system phase voltage:220±20%
line voltage:380±20%,or phase voltage:220±30%
line voltage:380±30%(can be selected.Please specify when ordering)
Single-phase:220±20% or 220±30%(can be selected.Please specify when ordering.)
Phase voltage:220V Single-phase:220V Line voltage:380V
Output voltage accuracy
1-5%(can be adjusted)Frequency:50HZ/60HZ
≥98%(Power grade over 50KVA)
The voltage for electrical strength and power frequency sinusoidal is 2000V without breakdown and flash over when lasts 1minute
It can last 1 minute at the rated current of two times
Wave form Distortion
No additional waveform distortion
it offers the protections against over voltage,over current,phase shortage and phase-sequence(The single-phase offers no protection against the phase shortage and phase-sequence)and mechanical failure
≤1s(in the condition that the external voltage changes is 10%)
- Q:How to use digital multimeter to detect the quality of 36 volt low voltage lighting transformer?
- General digital multimeter has a capacitor (some of the files with a million capacitance test table of Jack, some use pen)
- Q:What type of low voltage transformer should be adopted for safety lighting power supply?
- Isolated transformer, once 380V or 220V, two voltage, 36V, 24V, 12V, several categories, do not allow the use of autotransformer.
- Q:Why is elevator lighting transformer installed?
- 3 a power outlet shall be provided at the bottom pit.4 the cables and wires laid in the hoistway shall be flame retardant and damp resistant, and shall be protected by a nonflammable wire, conduit, or wire slot, with no use of wires, conduits, or wire slots made of combustible material.5 an elevator attached to a building whose wiring, materials and methods and electrical components used shall take into account the effects of climatic conditions and shall take waterproof measures.Lighting transformers in order to obtain 36V voltage
- Q:Can the 500 volt lighting transformer be changed into an electric welder?
- 500 VA transformer should not be used as an electric welding machine, so it is very difficult to reform the system, so it is better to buy a new electric welder
- Q:Is the substation separate from the power and illumination transformer?
- There is only bus in the substation, and the station is connected with the transformer from the bus. If there is no electricity even in the bus, then the substation should not be considered active.
- Q:Power and lighting transformers, lighting quality will be affected much?
- The quality of transformer itself, coupling coefficient, overload capacity, as well as the impact current of the bulb, the cold resistance of the filament and the starting factor at the same time, it is better to choose the 400VA transformer.
- Q:Lighting, lights, transformers, bulb brightness is too low, what's the matter?
- Line light for safety light, voltage 24 volts and 36 volts, pay attention to the bulb and transformer voltage matching.
- Q:Who knows how big transformers and lines the 36V transformer uses in lighting?
- No matter how many volts the output / input voltage of the transformer is, the size and the amount of the core of the transformer, the wire diameter of the winding lead and the lead thickness must be determined by the transformer capacity. Example: input 220V, output 36V load is 36v/40w light bulb 6, so the primary needs 0.72, secondary use 1.81 diameter enameled wire winding system. The transformer capacity is about 250VA.
- Q:Why is the two side of the lighting transformer grounded?
- In the three-phase transformer, the neutral point of the three-phase transformer and the metal case are always reliably connected, and the utility model has the advantages of reliable grounding, both working grounding, protection and earthing, and protection of personal safety and equipment safety.
- Q:What transformer can be used in a safety voltage lighting transformer?
- 220V/36V or 24V isolation transformer. Double winding, high and low voltage coils, not connected.
We have set up stable trading cooperation with customers from the Middle East, South Africa, North America, Europe and other areas worldwide. We gain a good reputation among customers and lay solid foundation for our development. And we believe that we can be your faithful friends and reliable partner forever.
1. Manufacturer Overview
|Annual Output Value
||US$50 Million - US$100 Million
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||Shanghai Port,Ningbo Port,Guangzhou Port
||81% - 90%
|No.of Employees in Trade Department
||English, Chinese, Spanish, Arabic, French, Russian
||3,000-5,000 square meters
|No. of Production Lines
||OEM Service Offered Design Service Offered Buyer Label Offered
|Product Price Range