Unique Design Temperature Control Colour Changing Led Bath Faucets 12" Showerheads

Ref Price:
$84.65 / pcs
Loading Port:
Shenzhen
Payment Terms:
TT
Min Order Qty:
200Pcs PCS
Supply Capability:
1000Pcs Per Month PCS/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Product Description:brass shower head,12" ,hydropower, LED color changes with water temperature       

Carton Size:73*49*39cm

About Product:

  1. Built-in LED light.

2. LED Power Source: a)4*1.5V AA batteries voltage supply, low power consumption; b)"bywater flow, described as "hydropower" in the Specification.

3.LED color: Red, Green, Blue.

4. All necessary installation accessories included.

5.Built-In durable ceramic valves ensure no water leakage.

6.Laboratory tested for up to 600,000 life cycles at 90 degrees.

7.Laboratory tested to withstand high water pressure of 1.7MPA.

8. 2 years warranty.

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:What is the best caulk for a sink and faucet fixture?
the silicone should be sufficient. you may not have installed it properly. you have to make sure that the area you are sealing is clean of previous caulking. you also have to make sure that the area is very dry prior to putting the seal. then once you put the caulking on make sure you don't use the sink for 48hrs. Avoid getting it wet. It should last after that. you could also put some plumbing putty into the space then put the caulking. You might want to check under the sink if there is a way for you to tighten the faucet down to get rid of the gap.
Q:How do I remove old kitchen faucet plastic fasteners that are screwed on too tight (attached to metal pipe)?
Try heating the plastic with a hair dryer. The heat will cause the plastic to expand and hopefully loosen the threads.
Q:What brand of basin is good?
I use the eagle bathroom, aftermarket is better, you can help repair
Q:Wash basin basin inside the two pipes how to split
First remove the two pipes, and then in the basin below the fixed faucet can be removed on the red cap.
Q:Wash basin faucet how to open
Try to unscrew it directly
Q:how do i change the stem and seat in bathtub faucet?
Your okorder.com Just click onto tub repair
Q:Basin basin faucet water hose position is too deep, how to screw down?
If you change the tube, then the tube can be cut with the pliers to take it off, with a pliers to clamp the tube will be able to dry down.
Q:Faucet doesn't "stop turning" HELP!?
It's best to just replace old faucets. Modern technology offers far superior valving than what you have. Call a plumber. Most plumbers will give you low cost or free estimate to repair or replace it and have enough experience to recommend what is best. Older faucets sometimes can be very difficult to replace, best to save your knunckles and let a pro take care of it. Avoid cheap faucets, ones that are made in Mexico or China. Expect to pay at least $ 100 for a good faucet. Good luck.
Q:Moen faucet is loose?
Just tighten it up from the bottom. You didn't say if it was a single lever or not so you may need a basin wrench to get up between the sink and the wall. If possible, have someone hold the faucet so it will be even when you have it tight.
Q:How would a chrome faucet look an a stainless steel kitchen sink?
It depends where it goes and what is its intended use. A standard stainless steel double sink for the kitchen. Why? You wash dishes on one side, rinse water on the other side and into dish-tray to dry. If there are too many pots and pans in the wash up, I drain the rinse water in the cleaner sink and leave the pots and pans in there to drip dry. After a couple hours everything can be put away as drying towel is not needed. So simple. Much more of a hassle with just a single sink. Also shows a "cheap builder" Sure a double "may" cost a few more bucks. The practicality outweighs the cost. And considering you have enough counter space. Why stainless steel? What are your knives, forks, spoons, and pots made out of? If you use them to cook food day after day, stainless-steel is the only way to go. And the sinks should be identical in size (for we are all not right handed - and if you wanted to sell the house later--the left handers will decide right there(because the plumbing would have to be changed for them to flip the sink around) Extra cost so they will try to have the price reduced by that much or so. No flexibility, no sale.
We are very popular with consummate skill, advanced workmanship, perfect after sales service in the world. From now on, our company devotes ourselves to enterprise construction and development, market is the guide, management is the basis, science is power.

1. Manufacturer Overview

Location Kaiping,Guangdong
Year Established 2004
Annual Output Value Above RMB5 Million
Main Markets
Europe and the United States, Australia

Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port Guangzhou
Export Percentage
No.of Employees in Trade Department 4 People
Language Spoken: English;Chinese;
b)Factory Information  
Factory Size: Above 3000 square meters
No. of Production Lines 2
Contract Manufacturing OEM Service Offered;Design Service Offered
Product Price Range Average