Two-section long-reach boom excavtor long rech boom and arm
- Loading Port:
- Guangzhou
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1 set
- Supply Capability:
- 10 set/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Weight of Building Machine | 12T | 20T | 22T | 30T | 35T | 40T | 45T |
Parameters | |||||||
Total Length of Boom and Bucket Arm(mm) | 13000 | 15380 | 15380 | 18000 | 2000 | 2200 | 24000 |
Working Weight(Kg) | 3000 | 4000 | 4200 | 5200 | 6000 | 6500 | 7000 |
Bucket Capacity(m3) | 0.3 | 0.4 | 0.4 | 0.4 | 0.5 | 0.6 | 0.6 |
Maximum Excavation Height(mm) | 11300 | 12510 | 12610 | 13720 | 14920 | 16100 | 17300 |
Maximum Extension Range(mm) | 12500 | 15100 | 15100 | 17600 | 19600 | 21600 | 23600 |
Maximum Excavation Depth(mm) | 9000 | 11340 | 11370 | 13000 | 15000 | 16500 | 18000 |
Total Height(mm) | 2900 | 2980 | 3040 | 3210 | 3210 | 3400 | 3400 |
Additional Balance Weight(Kg) | - | - | - | - | 2000 | 2500 | 3000 |
- Q:Ask you, great God, excavator, fight wild, is the main Q, vice W, or the main Q, vice e!!!?!???
- The main Q W, first lord Q explained, Kiyono, gank damage is a large part of QDeputy W, W is the first AOE injury, can accelerate the Desolator, the main vice W lets hit fly cooldown reduced to 1 W, hit fly cooling for 10 seconds, 5 W cooling for 6 seconds, to enhance the success rate of gankE upgrade damage bonus is really too low, 1 level tunnel 20 seconds CD, 5 level is 18 seconds, and no deputy W effect is obvious
- Q:Can you dig down straight always in the same diameter? I mean if you dig down in 10x10, will you end digging in 10x10?Only theoretically. Only serious answers.
- Do you mean a rectangular, 10 x 10 hole? If so: No... at least not very deep. The excavation wall in most earth materials loses structural stability, and so excavation below some practical depth must be sloped to prevent failure. Even in a very competent rock, you cannot go very deep... I'm also neglecting the practicalities of the usual excavation equipment, like a backhoe or excavator, which are limited by the mechanical-arm length and geometry. I guess if you wanted to dig a 10 x 10 hole by HAND (or jackhammer or something), and you progressively reinforced the excavation walls above you as you went, then yes, I suppose you could go pretty deep. OSHA might have something to say about it, but I'm being theoretical as you asked, or semi-theoretical. Now, if you are DRILLING, so that your circular boring is 10 units (inches, feet, whatever) in diameter, then your hole stays more or less the same diameter, although there is wallow-out at the top, and maybe some small percentage of variability throughout- depending on the competence of the earth-material. Even then, you would case a deep boring to prevent wall-failure when you withdraw the augers. What you case it with depends upon your purpose- steel, PVC, cast in-place concrete, whatever. There are also cool boring machines that can drill lovely, round holes of consistent diameter through rock. There's probably plenty of other tech that I'm not experienced or familiar with with, too.
- Q:I've noticed that my female leos dish is always full. I've counted them, and she hasn't eaten any of her mealworms. I have her on excavator clay (I'm digging it out soon and doing paper towel sub. ).I checked her belly and theres no dark spots or weird lumps, so I think impaction is out of the question. I caught her drinking. Also, she looks into the bowl from time to time, however she doesnt eat the worms. Maybe she doesnt want them. I recently started adding carrot pieces and lil sprinkles of flukers cricket feed into the bowl with the worms. Does she not like that maybe?Tomorrow I'm going to try wax worms.She has not lost any weight in her tail...nor mid section (shes a chunky monkey). However shes been off feed for almost 3 days.I gave her a warm water bath and rubbed her sides.Also hasnt pooped since she last ate.Are leos known for going off feed for short periods of time?
- Leopard Gecko Eating Problems
- Q:I was just curious. Let's say I kicked a Rite of Replication to make 5 copies of the Halimar excavator. How many cards would that mill out? (assuming there is just a halimar excavator on the field to begin with.) Then let's say I twin casted the Rite of Replication how many cards would that mill out then? Assuming the same cards were out.
- Five Allies are coming into play. Each will trigger their own ability, and each will trigger off the others as well, so each of them is triggering five times. In addition, the original Excavator triggers five times (assuming it's the same player controlling both the Excavator and the Rite). So you have six Excavators, each triggering five times, for a total of 30 triggers. When each resolves (assuming nothing happens to any of them in between), they count six Allies and mill six cards, for a total of 180 cards milled. Twincasting the Rite is a little different (obviously). When the Twincast resolves, it makes a copy of the Rtie. The copy resolves and all the above happens - 180 cards milled. Then the original Rite resolves and five more Excavators come into play. So now you have eleven Excavators, each triggering five times, each milling eleven cards, for 605 cards milled. So you get a grand total of 785 cards milled if my math is right. Which, frankly, seems like just a teensy bit of overkill.
- Q:Last week I was driving down a local street at night and it been raining all day.I was going well below the 30 mph speed limit. (about 20-25)An excavator was responsible for doing what's called a quot;cutquot; in the road for the local water company.A cut is about 2 ft. wide, stretches across the road and normally is like driving over railroad tracks when gravel is packed in.They used metal plates to cover the road on one side, but didn't use anything on the other and left it exposed.With all the rain all day, it created a chuckhole about 3 ft deep.There were no warnings IE: flashing barricades, construction signs, etc.I hit it directly and it caused $300 to my suspension to my car.When I reported it to the city they were out there that night with stone to fill and a barricade.I talked to the excavating company owner about it.I was civil and the owner, but he was a complete jack ***.I hadn't even asked for anything. I was going to offer splitting the cost.Should I sue?
- good luck in trying to sue in order to sue i think you have to prove that they intentionally tried to damage your car, but I have been known to be wrong , at 300 damages it hardly seems worth a day in court
- Q:i live here in caloocan city..and wanted to know more on their services
- hahaha. MALABANAN is an empire of different owners:) just like Ferinos bibinka is owned and run by diff. relatives. here are some: manda531 9179 ortigas 6552876 qc 9151327 (ask em for their numerous other areas) win malabanan: 7137647 malabanan eboy: 833-2318 malabanan-rizon ed 9111107 there are numerous more in the yellow pages, all Malabanan. I guess this is worth checking it's history. are they really relatives? or did some just use the name coz it's a top-of-mind name?
- Q:Excavator slewing support which good?
- Is located in Shenzhen City Pingshan Pingshan Street No. six and fourth community in Baoshan Industrial Zone 17. Is the production of slewing bearings professional manufacturers, set design, manufacture, research and development in one, production and testing equipment.
- Q:I am buying a home that has a large shed in the back. The loan is FHA and the appraiser requires it be torn down or repaired. This is an old shed close to 100 years old and was built with all 2x4s with many rotting pieces so fixing it would cost the same as rebuilding a new one. The shed is approx 15x24 in an L shape. I'm working with a contractor for the other repairs and he quoted me at $7,500 for a full demo, I said leave the floors and he brought it down to $5,500. This seems like a rather large amount especially looking around online I was expecting 2-3k at most. Is his quote realistic? Im under a deadline so I had him write it up but I most likely will do it myself or find someone with a excavator to come in and just crush it.
- Cheaper to rent a mini bulldozer and drive it thru yourself Is the contractor also charging for waste removal in that cost ? Then it might be reasonable Hard to say without knowing your city. You could call your local dump and see what they charge for construction debris It would be per ton and if there is a slab of concrete under the structure then costs might be reasonable I would call other contractors for estimates good luck Lr
- Q:can someone tell me about the 11th century C.E.Jewish scrolls found in Samangan province,Afghanistan?
- The Catholic church first got here up with the theory of the Trinity...Father, Son and Holy Ghost. That has prevailed in many Protestant faiths to boot. Trinitarian denominations have faith that God, Jesus and the Holy Spirit are one and the comparable, all at the same time, inseparable. it fairly is asserted that there is not any scriptural commencing up for this, yet i'm no longer nicely versed in scripture, so i will't say. i discover it a confusing theory to grasp, because of the fact i've got faith that Jesus became into the Son of God, no longer God himself.
- Q:Is there any jobs available for equipment operaters in West Virgina or anything in the pipeline industry??
- Je ne sais pas ( I don't Know ) Bonne chance ( Good Luck )
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
Two-section long-reach boom excavtor long rech boom and arm
- Loading Port:
- Guangzhou
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1 set
- Supply Capability:
- 10 set/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Related keywords