Q:Want to wash your hair in the basin, but the leader is too low, how to do it?

If you want to install a shower faucet, you install a two-handle shower faucet, the cost of this is relatively low, but this shower to use G3 / 4 teeth, so that you can match the water pipe, you can also with shower Of the hose, it may be dual!

Q:I am getting pebbles clogging up the cold water side of my bathroom faucet, whats up with that?

If you have just had work done on the plumbing, you could be seeing sediment from the interior of the pipes that was dislodged during the work. I find it odd that you are seeing this only on the cold water side (assuming you mean you don't have a mixer, but separate taps?). Don't install a water softener, as softened water is very bad for you, your children, you pets, and your plants. See what a plumber has to say about it.

Q:Im installing a new kitchen faucet. I have disconnected all hoses and the sprayer from the kitchen sink. I have disconnected the handles and stem.My problem is Im not sure how to remove the two washers directly under the sink handles for cold and hot. Once I get them off I should be able to remove the remaining locking nut on each side.Any suggestions to get these rusted pesky washers off?I have the following tools at my disposal:Basin WrenchPliersScrewdriversDrillDremel Rotary ToolSmall ChiselHammerMallet (Metal and rubber)plus pretty much any other basic tools.Any help much appreciated.

The washers may actually be a set screw escutchon. Try to loosen the lock nut that is in the cabinet under the faucet. You then should be able to pull up the stem assembly. Look at the top washer and see if it has a set screw holding it to the stem. Loosen the set screw and unthread the washer off the stem. The remaining assembly would then be removed into the cabinet.

Q:Faucet with the basin of the screw how to take, no position wrench no place to put, hand and twist fixed

Go to the hardware store to buy socket wrench!

Q:Will the wash basin faucet installed after the demolition can still use it?

Who is it? If the future is broken on the scrapped it? Later can not be used again? Can be reused as long as no bad.

Q:Why washbasin washbasin faucet is a shower that sprinkles the faucet on the faucet

May be installed without installed

Q:I do not know much about handiwork but I am forced to do it anyway. I ordered a new hose (old one was leaky) for my kitchen faucet. I was able to attach the new hose to the faucet, but am having trouble connecting the other side to the water line.The line runs vertically and is in a tight corner which is preventing me from getting in there with plyers or a wrench. I try to turn the hose counter-clockwise against the water line it is attached to, but the awkward placement of the line is making it very difficult to exert direct forceI feel there is a special tool/ technique I can use to detach the old hose and attach the new onePLESAE HELP

you will need whats called a Basin Wrench to reach up into that small area and unscrew it. any hardware store will have them, and the cheapest one will be fine, the expensive ones are just more durable and adjustable for us plumbers that use them everyday. good luck

Q:Xin Si Lai faucet wash basin with a little more on the faucet

You said this brand but also three lines of the brand.

Q:What is the general supply of water supply basin? If the installation of the wash basin height of 800

Wash basin water supply height, you need to use the basin and faucet combination of choice.

Q:want to change the faucet of the wash basin, ask the steps. There are pictures

During installation, use a raw material tape at the interface to prevent future connections from leaking. I believe you can succeed. Give me extra points