|Lamp luminous flux(lm):
||Aluminum + PC transparent cover
600MM 9w T8 Led Tube
600MM 9w T8 Led Tube for the market and the family Office, bank, hospital, hotel, restaurant, entertainment and other public places.
The lamp specifications is 9W , its technical parameters as follows:
Light Source Type
Isolated Power Pass CCC,CE Certification
220--240V50 / 60Hz
100LM / W or more
20square meters - 25 square meters
|market , family Office, bank, hospital, hotel, restaurant, entertainment and other public places.|
Our business philosophy is"people-oriented, technology-first", "quality first, service-oriented" . environmental care into product designs - create a bright and beautiful, and dedication to provide customers with cheap and quality lighting products service, warmly welcome new and old friends at home and abroad patrons.
- Q:The various specifications of LED fluorescent tubes
- LED daylight lamp tube routine parameters: 1, fluorescent lamp specifications: T8, T5, T4 difference and length of tubes, power description: commonly used with T8 and T5 fluorescent lamp specification, T4 lamp, with three tubes of a set of usually is T5 tube, commonly used fluorescent lamp specifications have T10, T12 long ago. "T", represents the "Tube", said the Tube, the Numbers behind the T Tube diameter, T8 is eight "T", a "T" is 1/8 of an inch, one inch is equal to 25.4 mm, then each of the "T" is 25.4 present 8 = 3.175 mm
- Q:What is the distinction between led fluorescent tubes and ordinary daylight bulbs?
- The final thing is that leds don't need a regenerator and a rectifier, and ordinary fluorescent lamps need to be used. There are a lot of different details
- Q:The T8 nominal 36W standard daylight bulb is only 18W
- Do you know your own design is what reason. Now in the market is almost not not qualified fluorescent lamp, fluorescent lamps (CFL) so I said is rubbish products. By doing a lot of LED torch is take waste products such as the contrast of the object, in fact only take the LED of the measured power and comparison of the nominal power of the fluorescent lamp to do, just can have what 18 w instead of 40 w theory and practice,
- Q:The output of the led lamp is low
- See appearance, 100-150 - v 18 w 0.12 0.18 mA more precise look at the arrangement of lights and the number Look at rated lamp power estimated the actual power/(see number divided by the number of parallel light by 3.2 V) = output current to 220 V, * current * power switch power supply is ok (see appearance should be burned the IC not bad basically can be repaired, it remains to be seen whether the LED is good)
- Q:Buy LED fluorescent tubes to see which parameters
- Power efficiency, power factor Output power (the voltage * output current of the output LED)/the input power. This parameter is especially important if the low efficiency means that a large portion of the input power is converted into heat. If it is installed inside the tubes will generate a very high temperature, and the led chip will generate heat, and would have a higher temperature, the superposition of all electronic parts within our power supply will increase with increasing temperature and shorten the service life. So the efficiency of power supply are decided life the most fundamental factor, efficiency is not too low, otherwise consume too much heat on the power supply. Power factor on the value, the power factor is the ratio of active power and apparent power, namely the cosine Φ = P/s. low power factor, can produce a large amount of reactive power, power efficiency and will also cause disturbance to the grid, it will be high to the requirement of engineering and the factory! General requirement efficiency is above 80, power factor is above 0.8. Brightness, longevity The current led lighting tube is 90-100lm/watt, and the life span is more than 20,000 hours, and the chips and power supply should be paid attention to. We adopt a 3-ampere, long power supply to ensure the quality of the lamp.
- Q:20wled bulbs are more energy-efficient than 20w fluorescent bulbs
- LED power, which USES electricity at the same brightness, is 80 per cent of other appliances.
- Q:Are the old daylight bulbs worth recycling?
- If directly the trash, they directly of fate is crowded broken last school in trichromatic lamp, hundreds of root powder halogen bulbs all into the trash can, garbage, directly sent to the car, and then crushed, hundreds of light tube is less than half a minute into a pile of white powder, some still have a few days of the new tubes Two head didn't black.
- Q:The LED light bulb is more efficient than the daylight lamp
- In the same power, it's more efficient.I hope my answer is useful to you.
- Q:Fluorescent fluorescent lamp tube can replace led fluorescent lamp tube?
- The original circuit was an alternating current that was attached to the ballast, and the ballast two to the two sides of the fluorescent lamp; To install led fluorescent lights, remove the ballast directly, and the positive and negative poles of the exchange are connected to the two sides of the led fluorescent lamp.
- Q:What is the flux of the general led daylight light
- And you can do that, and you're going to have 7, 5lm per watt. If it's a 10W light, you're 75 * 10 = 750LM.And you can do that, and you're going to have 7, 5lm per watt. If it's a 10W light, you're 75 * 10 = 750LM.
1. Manufacturer Overview
|Annual Output Value
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
|No.of Employees in Trade Department
|No. of Production Lines
|Product Price Range