Q:LED lamp with 180 beads, how many watts per meter?

The lamp lights with the general use of 20MA current, which is a is about 0.06W, so it is about 10W, but to consider a problem because there is resistance to limit the current, and therefore power resistance is not inside, if the use of low-voltage power supply (either 12V or 24V), its power 14.4W, which refers to the maximum power.

Q:How many light slots should I leave for the LED light belt?

LED light band is very small, broadband no more than 2CM, height is not more than 1CM, you can go to Taobao ask those stores, and then according to the size to stay! You've got enough 100*60 here, a lot more!

Q:Led how to install the lamp belt, LED lights with the installation process detailed

Please don't light the band when the 1.LED light is in a roll.2., only on the lamp belt with a scissors mark on the body to cut, otherwise it will cause a unit is not bright.

Q:What is the difference between T4 tube and LED lamp? What are their advantages and disadvantages?

T4 tube is fluorescent three primary color lamp tube. It has a diameter of 12MM.

Q:What is the difference between a flexible Led band and a hard lamp?

4, each three LED constitute a loop, you can according to the length of demand in the loop cut.5, power saving (energy saving to 90%), low heating, low energy consumption, pollution-free, beautiful.6, the surface of the glue or waterproof casing.

Q:How to distinguish the LED lamp belt is the high voltage lamp belt or the low voltage lamp belt?

Here only introduces the patch belt! The biggest difference is: the high voltage lamp belt is in a meter parallel to the core line (you can 100 a pass!) The low voltage is directly to the line power supply (due to the thin line), if the line is long, it is bound to cause the back part and the first half of the brightness is completely different!

Q:How about the power of the LED lamp?

LED has different chips that cause different currents. For example, there are 0.011A, 0.015A, 0.028A, and so on. It should be said that different batches of LED chips will have different values of current, so each batch should be measured by an instrument

Q:How to connect the LED lamp with constant current drive?

Both ends of the line is relatively early and also a common method, because of its convenient wiring, aging, simple and so on. So far, there are many LED lamp manufacturers. The two pins of the lamp cap are shorted together, then connected to the constant current power on the inside. Such a wiring method only needs to be removed from the traditional starter, so that it can work properly.

Q:LED lamp belt installation uneven lighting, how to do?

The light belt is one side luminous, and then the coil packing will distort. Ceiling inside the space is narrow, not fixed, so uneven lightThis problem will come with all the lights on.

Q:What's the brightness of the LED light band? Can I use it for lighting?

Brightness can be, you can buy that SMD 5050 high brightness, 15 lumens / grain, white light, three LED chip,.SMD 3528, 5 lumens / grain, white light, single chip per