1. General inormation of Single/Double Stage Centrifugal Oil Pump:
Type AYS single stage double suction centrifugal pumps are designed and manufactured according to BB2 pump specification in API610-10TH.
2. Performance of Single/Double Stage Centrifugal Oil Pump:
Capacity: Q = 95~1740 m3/h
Head: H = 38~280 m
Working temperature: T = - 45~450 degree centigrade
3. Application of Single/Double Stage Centrifugal Oil Pump:
1) Petro transportation
2) Transport products at high or low working temperature in refineries and petrochemical industry
3) Power plants, heating systems or air conditioning systems.
4) Shipyard or offshore industry
5) Water supply, seawater desalting and salt refining from seawater.
- Q:Does the oil pump plug cause less oil?
- The oil pump plug will not cause any reduction in engine oil, which will only result in the following two results:1. oil pressure drop, oil flow decreases, the appearance of insufficient lubrication2., serious blockage will cause oil in the oil pipe can not flow, causing the normal operation of the components to form "dry grind", accelerating the wear rate of parts
- Q:What's wrong with the car oil pump?
- Pull in the water or burn the oil
- Q:What is the oil pump on the car? If it is blocked, how can I solve it?
- Providing lubricating oil and lubricating pressure for each friction pair of the engine.
- Q:The car leaked oil and replaced an oil pump
- Hello, no hot weather will flow down to say, in the repair work is completed, the oil will be on the left before the cleaning, is does not have that kind of the situation, I suggest you put the car into the garage rack up again and see if there is obvious for the maintenance of quality problems, can be put forward re construction to repair factory.
- Q:Is the engine speed the same as the pump speed?
- No. the speed ratio between the engine and the oil pump is 2:1. That is to say, when the engine rotates, the two turns of the pump rotate. The principle is that the engine completes the intake, compression, work, exhaust, the four useful hours to rotate two times. The oil pump works only when it is done. So, just one lap would do.
- Q:How to repair the Iveco oil pump
- The oil pump is broken, what is broken, gear or pressure regulating valve, if the gear is broken, it is best not to repair, change a new one.
- Q:The motorcycle oil pump is broken. Can the oil be added directly to the tank?
- You'd better not put it in the tank. Will affect the gasoline combustion, because the oil concentration and gasoline is not the same. And the functions are different. What is the place with what place, with a little or no big problem, but the exhaust pipe will take the blue smoke, the damage to the engine is not great. If so, I suggest going to the 4S shop to take down the tank and clean it.The oil is added to the tank, depending on the type of oil (burning or lubricating oil) and the amount added. If it's the engine oil that has minimal impact on the engine, the mixing ratio should be within 1:25.If the amount of oil added to the tank is more than 1:25, the possibility of carbon deposition in the cylinder head of the engine will increase. Below this value can be assured to use, the smaller the proportion, the smaller the impact on the engine.
- Q:Does the abnormal sound of Audi Q5 oil pump need replacing?
- Make sure the oil pump abnormal sound needs to be replaced.
- Q:How do I check if the oil pump is working properly?
- Look at the oil pressure,
- Q:Will it clog up the oil pump by cleaning the engine oil which is strong enough to clog up the oil circuit?
- Not recommended, if you want to deal with the best in time to repair the engine oil, the remaining half after adding detergent, appropriate to start the engine, but don't let the engine run continuously, repeated ignition immediately stop, the three stop 5 minutes during the three times, then stop for 1 hours, began to disassemble the bearing replacement of oil with high pressure gas to clean up, and then the parts are cleaned, the abnormal wear or exceed the wear limit of a replacement, beginning of assembly, assembly of lubricating parts with clean oil, oil filter assembly, oil filter oil filling. Start OK.The use of cleaning function of the engine oil will lead to dirt in the oil pipe to fall off, plug the oil on the part of the small hole, exacerbated by the need for lubrication parts of the abnormal wear and tear, serious machine scrapped. The loss outweighs the gain。I have seen the use of this detergent containing oil, after the use of the whole machine scrapped, the landlord carefully.
Our main products are all kinds of centrifugal pumps, displacement pumps and vacuum pumps, such as oil pumps, multi-phase pumps, single stage and double suction centrifugal pumps, horizontal split case pumps, multistage pumps, axial-flow pumps, mixed flow pumps, petrochemical pump and submersible pumps. Besides, our company also manufactures electric motors and sells electric motors, building materials, indoor decoration materials, civil electric equipment, devices and instrumentation, as well as exports our mechanical and electric products.
1. Manufacturer Overview
|Annual Output Value
||US$5 Million - US$10 Million
||59.00% Mid East
8.00% North America
8.00% Southern Europe
5.00% Eastern Asia
2.00% Southeast Asia
2.00% Western Europe
2.00% South America
2.00% Central America
2.00% Northern Europe
2.00% Eastern Europe
2.00% South Asia
2.00% Domestic Market
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||51% - 60%
|No.of Employees in Trade Department
||Above 100,000 square meters
|No. of Production Lines
||OEM Service Offered Design Service Offered Buyer Label Offered
|Product Price Range
||High and/or Average