Silicon Polycrystalline Solar Panel 315W
- Ref Price:
-
- Loading Port:
- Guangzhou
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 200000 watt
- Supply Capability:
- 20000000 watt/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
ABOUT US
We are a high-tech group wich specializes in solar products design,research, manufacture, sales,solar projects design and installation.
We now provide Polycrystalline Silicon Solar Module;Thin Film Solar Module;Monocrystalline Silicon Solar Module
Depends on various demands from different customers, CNBM could supply any kinds of service to meet you, please feel free to contact us at any time.
INTRODUCTION
This installation Manual contains essential information for the electrical and mechanical installation that your must know before installing CUSTOMER PV modules. This also contains safety information you need to be familiar with .All the information described in this manual are the intellectual property of CNBM and based on the technologies and experiences that have been acquired and accumulated in the long history of CUSTOMER. This document does not constitute a warranty, expressed or implied.
CUSTOMER does not assume responsibility and expressly disclaims liability for loss, damage, or expense arising out of in anyway connected with installation, operation, use or maintenance of the PV modules. No responsibility is assumed by CUSTOMER for any infringement of patents or other rights of third parties that may result from use of PV module.
CUSTOMER reserves the right to make changes to the product, specifications or installation manual without prior notice.
WORK PRINCIPLE
GROUDING
All PV models must be grounded by electrical connection of the module frames to ground. Please be careful in arranging the system ground so that the removal of one module from the circuit will not interrupt the grounding of any other modules.
The modules should be grounded to the same electrical point as described below.
Each PV module has a hole on the side frame of either a bolt, nut and washer grounding the module to the frame, a ground lug fastened by bolt or screw, or appropriate screw(hardware not provided).An example of acceptable ground connection using a bolt, nut and washer retaining a ground lug is shown in figure 3,in a connection of this type, the hardware(such as a toothed locked washer/star washer) must score the frame surface to make positive electrical contact with the frame. The ground wire must be considered within the requirement of local and regulation at the site of installation.
DATA SHEET
Maximum power | 315W |
Cell type(mm) | Polycrystalline solar cell 156*156 |
Number of cell(pcs) | 72(6*12) |
Manufacture site | China |
Open-circuit voltage(voc) | 45.1V |
Maximum power voltage(vmp) | 37.3V |
Short-circuit current(isc) | 8.88A |
Optimum operating current(imp) | 8.45A |
Power tolerance | 0~+5W |
Module efficiency | 16.2% |
Dimensions(mm) | 1956*992*40 |
Weight | 27 kg |
Backsheet | Silver |
Frame Colar | White |
Frame | Anodized Aluminum Alloy |
- Q:In terms of efficiency and cost, what is the best solar panel. I am limited in the number of panels I can put up (probably 6-8) so they must be efficient, but cost is important also.What about these panels that can collect a wider range of light frequency?
- your initial outlay for a solar panel is very large in terms of output.......somewhere around $4 a watt......ie you want a panel that will run a 00 watt lightbulb? $400.00 please. enough panels to collect enough energy to recharge a battery bank to run the house overnight? well, I've been doing a lot of research for my condo project in St Thomas and it comes out to 0-20,000 US $ for a bedroom apartment. Now, after about ten years you have made your investemnt back.... and there are a lot of government rebate programs that lower the cost.. what I have found is solar is nice, but depending on how far north you live you may only have 4 usable hours of light a day. you may very well be better with a wind generator.wind blows all the time after all...Bergy and SouthWest Windpower make two good small home units...start there
- Q:I am learning all about heat radiation in Physics. There is a question I am doing about Solar panels. It asks, why do glass covers improve the efficient of solar panels? I dont really understand. How do they?? thanks :D x
- Clear glass will allow most of the electromagnetic energy of sunlight into the air-tight volume of the solar panel. The light strikes the black coated metal tubes and the black coated backing, and is absorbed as heat. Part of this heat will radiate as infrared radiation, and much of this will leave through the glass. But a great deal of it will initially remain in the metal as heat. This heat will be partially transferred to the surrounding air, but because the glass stops the mixing of this air with the rest of the atmosphere, this heat will stay mostly contained within the solar panel. If the glass were not there, there would be a huge loss of heat into the surrounding air.
- Q:Is there a material that is capable of absorbing enough UV radiation to make it worth using as a flexible solar cell?Not flexible as in aluminum, but a material such as plastic (polycarbonate).
- Homemade okorder /
- Q:I want to use this solar panel to hook up AC adapters. IM not sure what to do and how to use the solar panel. I want to be able to use a batter charger, a radio, and charge a GPS if needed. - Thanks, Zoo
- Research using solar panels on stock tank water pumps. Same concept - you use a solar panel to power a remote something or other, only you would have to use a battery charged by day to run the camera at night. It does not look like you would need too powerful of a solar panel, the camera server says it needs less than 5w, no idea on the cameras, so check that out, but the whole system looks rather low power. You could easily get the necessary panels, maybe the battery too, for... I would say $200 (not in one package, you would have to get separate things). Connection of everything would be simple, no electrician needed (but keep that to yourself, depending upon state rules and regs).
- Q:How do solar panels affect home resale value?
- Solar panels can increase the resale value of a home due to their potential cost savings and environmental benefits. Studies have shown that homes equipped with solar panels tend to sell faster and at higher prices compared to similar properties without solar installations.
- Q:Why can't they put solar-panels on the blades and sides of the 300-500 foot tall turbines? Wouldn't this increase effeciency? Therefore, boosting pay-back time, profits, energy-output?
- No. The solar panels would never be balanced. Those blades need to be very balanced. Additionally, how would the solar panels get the power from a rotating blade to the ground? It is better to have separate units. What we ought to be concerned with is having large solar panel farms. These are counter-productive to going green, as they still require long and harmful power transmission lines. Solar panels ought to be put on top of buildings which would be using that power. Any additional power not used could be added to the power grid. For those types of clean energy that are not practical on the roof might get space near the building, keeping the transmission lines as short as possible. Large farms ought to be owned by the nation, keeping the cost of the power to the customer as low as possible. Power companies rip off consumers with their price gouging. It is time to let the burden of making a few rich at the expense of the many end.
- Q:I have seen DIY software which explains everything for novices. Specifically, how to build your own solar panels and tie them into your home electrical system for about $00 in parts.Has anyone tried doing this? Was it easy?
- Solar power generation is still in its infancy. Solar panels are incredibly expensive (average of approx $25,000 to equip a house with roof top panels) and are incredibly inefficient. However, the economics and efficiency of solar electricity may evolve into a system of economic, efficient collection systems in time depending on the level of funding available in the future for the necessary research and development. We can only hope.
- Q:I have a shed that has wiring run for light bulb and a couple outlets. It is in a dark corner of my yard and at night is kinda creepy to go in with even a flashlight. I am weighing the option/expense of running electricity from the house on an overhead line versus putting up a 45 watt solar panel on the metal roof with inverter, battery etc. Sunlight is good to excellent at the location. Question is - will this be sufficient for the occasional use of light and an outlet? What can I expect? Pros and cons appreciated
- For okorder /... Electric power. Rather than an overhead cable you can bury a cable or PVC conduit and power the shed with 20AC. You can easily supply 5 to 30A of 20V AC that supply all of your power needs without the issues and limitations of the Solar system. If your shed is within 200 ft of your home you should be able to power the shed for less than $400 if you do the work.
- Q:but is that per day, per hour or minute?How much watts does the average AC unit use?How much does an energy efficient lightbulb use?All in all let's hypothetically say we no longer use the electric company for our energy source, How many of these panels do you estimate it would take to supply our small home?
- It's virtually impossible to estimate how many panels would be required, without knowing your electrical usage, and where the house is located. I'll give our house as an example, but it could be off by a factor of 0 (not kidding) from yours. We have gas heat, no air conditioning, and no pool. We live in a dry, sunny area of California, and our roof is ideally oriented for panels. We would need 25 such panels, but we are grid-tied. If we wanted to disconnect completely from the electric company, we would need 20% more panels to compensate for battery inefficiencies. So, the estimate is 30 panels. Here are some caveats: ) Air conditioning, especially central air, could double or triple the estimate. 2) An area that gets less sun per year (northern US, for example) would need more panels. 3) Typically, when a house has grid electricity, they keep grid electricity when they get solar panels. It's much cheaper to use both in tandem. 4) That's a horrible price for the panel in the picture. You can find a 200-watt panel for less than that. 5) Other equipment is required besides the panels to run your house off solar. You can read up on it on the internet, or ask a professional solar installer for a free quote.
- Q:can solar power panels installed at home provide enough electricity to power house hold appliainces and heat water.
- It will take about $44,000 to put enough solar panels to provide the same amount of power that you now have coming from a 220 v 00 amp power line to your house. You should also realize that you need some method of storage for use at night or dark days. This will add another $7,000 to the cost. The only real solution for the energy problem is nuclear power.
1. Manufacturer Overview |
|
|---|---|
| Location | |
| Year Established | |
| Annual Output Value | |
| Main Markets | |
| Company Certifications | |
2. Manufacturer Certificates |
|
|---|---|
| a) Certification Name | |
| Range | |
| Reference | |
| Validity Period | |
3. Manufacturer Capability |
|
|---|---|
| a)Trade Capacity | |
| Nearest Port | |
| Export Percentage | |
| No.of Employees in Trade Department | |
| Language Spoken: | |
| b)Factory Information | |
| Factory Size: | |
| No. of Production Lines | |
| Contract Manufacturing | |
| Product Price Range | |
Send your message to us
Silicon Polycrystalline Solar Panel 315W
- Ref Price:
-
- Loading Port:
- Guangzhou
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 200000 watt
- Supply Capability:
- 20000000 watt/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Related keywords
