Self-design Led Light String for Stage Holiday and Home Decoration
- Ref Price:
-
- Loading Port:
- China main port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 300 set
- Supply Capability:
- 10000 set/month
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
You Might Also Like
Item specifice
IP Rating:
IP44
Body material:
other
Working lifetime(Hour):
2000hour
Power(W):
125
Certification:
BV,CCC,CE,UL,VDE,SAA
Input voltage(V):
110/220
Working Temperature(℃):
-40-40
- Q:How much is the voltage across the 20 LED lamps in series?
- Don't know what kind of LED, if it is ordinary bright LED words, according to different colors, the rated voltage between 3.6-3.8V (current allowable level <20mA), you can be calculated according to the amount of estimates, as long as the control current should not exceed 20MA no problem
- Q:LED lights string broken, how to repair?
- As an emergency treatment, you can also short-circuit the open circuit of the LED lights. Used to restore normal work.
- Q:Section LED lantern, no controller, can shine principleTwo now reduced brightness string string
- Led 2 polar tube inside chip oscillator circuit, and the general appearance led 2 polar tube without distinction, only connected to the power supply of two kinds of color turns light, 1 seconds, I bought the 5MM red, blue autoflash. From the appearance of the series, but not necessarily in series
- Q:Rated voltage of LED lamp string
- When normal luminescence, each LED voltage drop is more than 2 volts, the current is about 15mA, to use 220V direct current should be connected in series with nearly one hundred led, or in the LED circuit series resistance, so that the series circuit current is about 15ma.
- Q:Hanging on the tree string lights, each one is 10 meters long, with a controller, I asked the factory with the AB protection, but the manufacturers say that only do the general anti rain, no water, even the rain stop, I want to use plastic wrap, don't know? Which expert can give advice and advice? emergency
- You can use the plastic wrap, mouth down, so even if again under the rain is not bad. Or glue the entire controller to the point where the water is likely to enter the water.
- Q:220vled water lamp string how to connect, that is, 220 of the electricity
- The triode acts as a switch in the circuit, and when the circuit is through, the left LED is first lit. The base is connected with a capacitor to connect the collector of the next triode.
- Q:I want to do a string of LED lights that can use batteries. About 55 or so. The lights are 5MM blue. How can I work? Urgent urgent!!
- If it is a general common blue LED working current is 20 mA, voltage of about 2.5V can be lit, the battery power can be used in parallel, the benefits of this connection is one of the damage does not influence the normal operation of other LED. And each LED string to a current limiting resistor, LED protection lamp, prolong life, calculation formula of the resistance for V / 0.02A=: voltage current resistance: 3V, battery powered =3 / 0.02=150. You want to supply 55 LED batteries to work together, the total current is up to 0.02x55=1.1A, i.e. 1AH (ah) capacity of the battery can work 1 hours or so.
- Q:How does the LED light string flash?
- Because of the special volt ampere characteristics, LED can not use constant voltage driving mode, but is driven by cross flow. The direct drawback of cross flow drive, however, is heat. So people invented the drive mode of pulse drive. For example, 0.5 seconds per second, so that the amount of heat in the LED is reduced by half. Then turn the frequency up to 100 times per second, lighting for 0.005 seconds each time. At this point, the power of the LED is not the same, and people do not feel blinking. What's more, in this driving mode, an approximate cross flow drive (that is, the current is not necessarily precise) can be simplified, which simplifies the drive circuit (the precise cross flow source is very complex)
- Q:What are the power connections for the LED light string?
- This advantage can be centralized control, inconvenience is unable to achieve a single LED light string lighting effect and switch control, which specific way can be measured by their own. I use the LED lamp string is Zhongshan Greenman with total power and parallel connected to
- Q:Why are there three lines for the controller of the LED light string? What are they?
- The LED pipe positive string is connected with 4-5 1K2W resistance strings, and the other end of the resistor is connected with the common positive pole of the controller. LED tube controller's direct bright output (Huang Xian), if the LED tube brightness is not too bright, minus a resistor. Remember not to short-circuit, short-circuit, burn out the controller. The less string LED, the more resistance string.
1. Manufacturer Overview |
|
|---|---|
| Location | |
| Year Established | |
| Annual Output Value | |
| Main Markets | |
| Company Certifications | |
2. Manufacturer Certificates |
|
|---|---|
| a) Certification Name | |
| Range | |
| Reference | |
| Validity Period | |
3. Manufacturer Capability |
|
|---|---|
| a)Trade Capacity | |
| Nearest Port | |
| Export Percentage | |
| No.of Employees in Trade Department | |
| Language Spoken: | |
| b)Factory Information | |
| Factory Size: | |
| No. of Production Lines | |
| Contract Manufacturing | |
| Product Price Range | |
Send your message to us
Self-design Led Light String for Stage Holiday and Home Decoration
- Ref Price:
-
- Loading Port:
- China main port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 300 set
- Supply Capability:
- 10000 set/month
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
Similar products
New products
Hot products
Related keywords
