Q:The maximum number of joints for a rubber hose is no more than

Shower hose, shower hose, two joints are nominal diameter of: 1/2 inch (4 thiophene) cylindrical pipe thread. Standard component. Hot and cold bath: take a bath with hot water before going to bed every day. The temperature of the water is within the limits of the body's tolerance. After washing, sleep in hot water for 15 minutes. After bathing was out of a sweat, after 3~4 minutes, and then into a basin of cold water or cold shower. Note that the hot and cold bath must be "hot before cold."".

Q:Laboratory condensate water pipe must use rubber tube, shall not use latex tube reasons

Bending test: after bending the hose to a certain extent, measure the minimum outside diameter of the bending part and the ratio of the outside diameter before bending, the passing capacity of the steel ball and the bending force when the tube is pressurized.

Q:Do you need a hose connection to connect the ventilation pipe to the exhaust fan? Under what circumstances? Under what circumstances?

Must be added, never heard without the place, the wind turbine operation produces vibration, and galvanized sheet steel pipe is fixed at a certain place, if not, fan vibration, wind pipe vibration, the wind tube life are not long.

Q:High pressure hose K type joints KJR32 and KJR31.5D what is the difference between ah, please give us a answer,

K type joint has the distinction between national standard and German standard. In general, 32 of the tubes are 1 1/4 inches, and the K type mine connections are also 1 1/4, but there are two methods of KJR32 and KJR31.5D. But KJR31.5D, D means that the inner diameter is 1 1/4 inches.

Q:How to remove the smell of gasoline in the car?

When filling, the filling is full - when the gas is filled up, it may cause the gasoline to go down the tube into the canister so that a large amount of gasoline vapor is released from the vent of the canister.Answer: turn on the air conditioner, use the internal circulation mode (the windows should be closed, air conditioning refrigeration), so, when the car runs for a while, the gasoline will dissipate.

Q:Why should the water stop strip be joined by heat instead of superposition?

Lap joint of rubber water stop belt is lap joint, this method is not allowed in engineering, glue glue and do not use overlay. In the case of splicing, it is equivalent to not doing any treatment at the joint. In the process of pouring, the sealing strip is prone to roll and twist.

Q:How to determine the tensile strength of GB rubber joint?

The tensile strength test specimen is dumbbell shaped and can be divided into 1, 2, 3 and 4 types, of which type 1 is universal, and the specific dimensions of each part of the sample are as follows:For non-standard specimens, that is, the maximum thickness of the narrow part of the sample taken from the finished product is specified as: type 1 is 3.Omm, type 2 and type 3 are 2.5mm, and type 4 is 2.Omm.

Q:How long is the service life of the gas hose?

The gas hose is connected to the gas pipeline and special gas hose with / out, according to the number of gas accident statistics analysis, because the gas hose aging or bitten by rats caused by gas leakage accident / Xi accounted for more than 30% of all gas accident.

Q:Is flexible rubber joint and telescopic device a kind of thing?

The main features of metal pipe telescopic device are telescopic, large compensation and high temperatureUnder great pressure.And flexible rubber joint is a product!

Q:Standard for implementation of type KXT-1 rubber joints

This product can reduce vibration and noise, and can be compensated by thermal expansion and cold contraction due to temperature changes. It is widely used in various piping systems. Rubber joint manufacturing standard CB-T 965-95 CJT208-2005 to take over the compensation rubber flexible rubber joint CJT 3013.1-1993 KST flexible rubber joint