The hose consists of an inner tube of oil resistant synthetic rubber,two wire braided reinforcement,and an oil and weather resistant synthetic rubber cover. Working temperature from -40°C up to+100°C.
- Q:Can the spring hose joint be connected to the tap?
- 1 use dry cloth or paper towels to wipe the elbows of the pipe, and also to dry on the bottom;2, more than 10 minutes, in the use of dry towel on the elbow section, pay attention to observe, if the paper towel is wet, the exemption proved that the site leaks. If there is no problem with the elbow, use the same method to test the lower part of the elbow and locate the leaking part.
- Q:What is negative pressure rubber shock proof joint? Is vacuum piping available?
- With high pressure, good elasticity, large displacement, balance pipe deviation, absorbing vibration and noise reduction effect, convenient installation, but also can greatly reduce the noise and vibration of the pipeline system, which can solve all kinds of line interface displacement fundamentally, axial expansion and concentricity problems, mainly installed in the pump inlet the vacuum pump inlet, or large, can solve the 100% rubber joint suction flat phenomenon.
- Q:How can I keep the rubber tube for stethoscope?
- I don't think this question should be considered purely from the point of view of sound transmission.
- Q:Will the outside of the brake hose of the car burst apart?
- There is a potential safety hazard to the outside rubber skin. It is possible to slam on the brake. The brakes are not trivial, so I suggest you replace them in time.
- Q:Three yuan ethylene propylene rubber hose, hydraulic oil and oil?
- Finally, NBR (Ding Jing rubber), ACM (acrylate), FKM (FKM) can be non polar medium.
- Q:Aging of natural gas pipeline
- 1, when in use, should always pay attention to the color of the fire. Orange flames indicate incomplete combustion of gas, and in this case carbon monoxide is released. The fire can be adjusted by adjusting the air door at the bottom of the stove, and the flame is blue.2, soup or water, containers should not be overfilled, nor unattended, so as to avoid the fire was spilled soup, water and water leakage.3, in a stew or soup, some people love the flame was very small, this can easily lead to leakage or incomplete combustion. Therefore, in the use of gas stoves, the fire can not be too small.Between the 4, and gas appliance hose inlet connector to connect closely, preferably with a pipe clip.5, in the same room, strictly prohibit the simultaneous use of two kinds of fire sources.6, the family is best equipped with dry powder fire extinguishers, so as to be prepared.
- Q:The difference between silicone tube and rubber tube
- First of all, we can find the difference between the material of silicone rubber tube and rubber tube. Smell it with your nose. Silicone doesn't taste. Rubber has a flavor. Silicone is generally more flexible, and rubber is more mechanical.Silica gel tube has high and low temperature (-60 ~ 200 DEG C), environmental protection, non-toxic, excellent heat aging, ozone aging resistance, light aging and aging resistance, soft, arc resistance, corona resistance.
- Q:Is the electric water heater well connected with the metal hose?
- On the other hand, the utility model can effectively avoid the frequent switch of the water heater power switch because of the two grounding. Therefore, the metal pipe connection does not meet the safety and installation specifications.
- Q:What advantages does the Parker hose have in comparison with other hydraulic hoses?
- Parker hose and other hydraulic hose advantages compared to:First: from the price point of view, the price of PAKER is the most expensive industry. High popularity.Second: if from the quality point of view, the quality of stability, high degree of recognition.Third: from the point of view of use, the difference is not obvious. PAKER things match well.Fourth: strong pressure resistance, rated 400bar hose, blasting pressure can reach close to 1000ba
- Q:How can the rubber tube be used properly and how to use it properly?
- Hose selection and installation caused by improper hose rupture. When replacing the hose, the hose wire length, number, shape and size of the joint should be reasonable, and should try to reduce the degree of bending in the hose; tighten union nut, do not make the hose distorted, excessive bending and twisting will reduce the service life of the hose greatly; some easily friction parts should take protective measures to prevent the hose due to wear and burst.
1. Manufacturer Overview
|Annual Output Value
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
|No.of Employees in Trade Department
|No. of Production Lines
|Product Price Range