Rubber Compound

Ref Price:
Loading Port:
China Main Port
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
-

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Natural Reclaimed Rubber :

Specifications: Heating on Loss≤1.0%
Ash≤10%
Acetone Extract≤22%
Density≤1.24%
Door Adhesion Ml (1+4)100≤80
Tensile Strength Mpa≥9.0
Elougation≥360%
Fineness passed to 40 mesh
Note: Special requirements should be decided through negotiation between the seller and the buyer.

Reclaimed Rubber Grades: Butyl, NBR, Natural Reclaimed Rubber, etc.

Usage: mainly used tires, belts, shoe rubber, with a wide range usage and comprehensive capabilities.

Butyl Reclaimed Rubber :

Name and Target

Butyl Reclaimed Rubber

100

(mesh)

60

(mesh)

CIIR/BIIR

Water Contnet % ≤

0.5

0.50

1.00

ASH % ≤

8.00

8.00

48.00

Acetone Extract % ≤

10.00

10.00

20.00

Tensile Strength MPa ≥

8.00

8.00

4.00

Elongation % ≤

480

480

500

Mooney Viscosity (ML1+4100) ≤

40±5

45±5

75

Density (g/m3 ) ≤

1.20

1.20

1.45

The product is reclaimed rubber that has inner tube of butyl and capsule of butyl as raw materials. The products are refined and non-particle. It is suitable for inner tube of butyl.

NBR Reclaimed Rubber :

Name and Target

NBR Reclaimed Rubber

Water Contnet % ≤

1.00

ASH % ≤

20.00

Acetone Extract % ≤

20.00

Tensile Strength MPa ≥

5.00

Elongation % ≤

150

Mooney Viscosity (ML1+4100) ≤

70

Density (g/m3 ) ≤

1.40

Note: Special requirements should be decided through negotiation between the seller and the buyer.

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:With a i3-2100 desktop computer about how much money. To have a separate graphics card. Give a configuration alone, no more than 4000
The length of the cable bracket is determined by how much the cable is
Q:What is the difference between a pre-branch cable and a punched clip?
The structure of the PV cable is shown in the table. The difference between the ordinary cable and the PV cable is analyzed: The common cable can be seen from Table 1 that the conductor and the PV cable used are consistent. ordinary cable insulation and sheath can be seen from Table 1 different from the photovoltaic cable. Ordinary cable is only suitable for use in general environment. the advantages of photovoltaic power cable: high temperature, cold, oil, acid and alkali salt, anti-ultraviolet, flame retardant, environmental protection, photovoltaic power cable is mainly used for harsh environment, the service life of more than 25 years.
Q:Power Cable Check Well b-type covers show what?
Indicating the carrying capacity of the covers, according to "People's Republic of China town construction industry standards" to understand that: steel fiber reinforced concrete inspection covers are divided into A, B, C, D four
Q:Calculation method of wire and cable outer diameter
(In accordance with the power cable, single-core cable sheath of the nominal thickness should not be less than 1.4mm, multi-core cable nominal thickness should be not less than 1.8mm), the thickness of the jacket, 2. On-line measuring sheath thickness: Sheath thickness = (circumference after extrusion of the jacket - circumference of the jacket) / 2π or sheath thickness = (circumference after extrusion of the jacket - before the jacket Circumference) × 0 .. Insulation thickness of the most thin point: Nominal value × 90% -0.14. Single core sheath the most thin point: Nominal value × 85% -0.15. Multi-core sheath thinnest point: Nominal value × 80% -0.26. Wire armor: Number of roots = {π × (inner sheath outer diameter + wire diameter)} ÷ (wire diameter × λ)
Q:How high voltage armored power cable is grounded
Insulated isolation of the double shield control cable is the outermost armor layer should be grounded at both ends, the inner shield one end of the ground, is conducive to the rapid release of induced current.
Q:How to determine whether the square of the cable is standard
Horizontal laying of the cable within the cable, generally do not need fixed, natural laying can be. Vertical laying section of the cable within the bridge, with the need to match the line card, the use of tied rope (multi-purpose single insulated wire) one by one fixed cable, fixed spacing should meet the requirements. According to the control cable and the power of the different layers of laying, if the power cable to be multi-layer need to have 300mm spacing (or load capacity is large enough), if it is control cable, casually laying, if the laying of power cable laying below Layer, above the laying of control cable, but not too much affect the power cable cooling. If the high-voltage cable and low-voltage cable in principle do not allow common laying.
Q:What type of cable is the power cable?
It seems to have not heard of our unit to do the professional cable bridge to the current domestic ranking before 3 I did not see we have this certification ah there is a professional health and safety management system has an environmental management system and other quality management system Science and technology innovation patent what a lot did not see the CCC
Q:How to convert the computer's audio and video to cable TV signals. Through the cable television transmission to the 40 TV (hurry)
In general, a 42U cabinet to 200 information points within the appropriate
Q:The UV lamp is fitted with ozone and no ozone difference
Clean the copper wire to be welded, and dip a little solder paste or rosin before welding.
Q:Construction of hydropower embedded pvc pipe after the solidification of the pipe after the flat tube
Cable model NHYJV3 * 25 + 2 * 16 its name is: fire-resistant cable. NH ----- on behalf of fire. YJV ----- XLPE insulated PVC sheathed power cable. 3 * 25 ----- 3 cable cross section is 25 square (for 3 phase line with). 2 * 16 ----- 2 cable cross section is 16 square (one for the neutral line, one for the ground line). Fire-resistant cables are generally used for TN-S power supply systems (five-wire).

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range