Radial Tyre of Truck and Bus 700R16 LRP603

Ref Price:
Loading Port:
Qingdao
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
-

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Application:The Tire can be used to Truck and Bus.

Size:  700R16 LRP603

Tire Structre:All STEEL

Tyre Parameter:Play Rate    Tube Type    Standard Rim    Load Index     Speed Symbol      Section Width

                        14/16           TT               7.0                   141/139                    K                        259

Other Available Sizes :

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Which brand is the best for truck tires?
No best. Are based on personal use of road conditions, travel time, many factors to constant.Foreign companies such as Michelin, Bridgestone, Goodyear tires these good quality, but the price is relatively high.
Q:What kind of industry does the tire belong to?
Can be, for example, my tire is the auto rip, I want to publish classified information, I will find the car, then the car supplies, finally is the direct tire.
Q:Auto tires 102H what do you mean?
Tire 102H: the maximum speed of the car at 102 load is 190km/hThe meaning of H and T:H/T is the speed levelThe maximum speed at which the H is under the load of the tire is 210km/hThe maximum speed at which the T is under the load of the tire is 190km/h
Q:How often do they need to be replaced?
If the left tire tread groove depth at or below 1.6 mm (tire longitudinal straight groove with indicator indicating the depth), the tire must be replaced, because the drainage capacity of the tire has decreased greatly, the vehicle would be more dangerous driving in wetland.
Q:How often do they need to be replaced or when they need to be replaced?
1, to improve the understanding of tire safety, usually to check the tires, especially on high speed, we must be fully detailed examination, in addition to outside pressure, but also to observe whether there is a side of the tire, tread wear, found hidden should be excluded.2, regular correction wheel balance, wheel imbalance is excessive, high speed will produce high frequency oscillation, causing tire partial wear, is not conducive to driving safety. After the tire repair, should go into the action balance test adjustment, the tire side dynamic balancing test value should be less than or equal to 40 grams.3, carry out regular tires, in order to maintain the same car tire wear uniform, vehicle traveling 5000 kilometers each should make a tire rotation, every 5000 ~ 10000 km for a four round of positioning, in order to avoid the tire abnormal excessive wear, are not allowed to install tires of different types or larger differences in the same old a shaft.
Q:Truck tire distance
If you have access to the site of the road on both sides of the wheel is not the kind of collapse, middle high raised serious rutting under the condition of your vehicle by car (or as long as the width of the lateral width of the tire on both sides of the body) can, do not need to consider the track.
Q:How do I change the tires?
Just simple tyre transposition, the four wheel alignment doesn't need to be done;4, tire prices afraid of pits, find more than a few tire shop comparison
Q:Is the front and rear tires the same?
The general case is the same, such as our common red flag, Audi, golf, Jetta, Passat, polo and so on; but there is not the same as: Mercedes Benz CLS350 245/40 R 18Y 275/35R [18Y], Benz E350, BMW X5 3.0i and so on, the front and rear tire is not the same, later than in front of the wide.
Q:Does the car tire come within or without
With tyre lever to pry into the tire, note the tyre lever cannot be inserted too deep, avoid punctured tube and pry off the bead bead.5. tire rim loading, should check and adjust the valve and align the wheel hub, inflated tire rotation, the valve position adjustment.6. tire rim and the rim wall should be uniform contact, should not be to one side, can be in the semi inflated tire will hit the ground or peripheral hammer blow to adjust.
Q:In what case do you need to change the tires?
Tread loss approaching wear markAny brand of tyre will have a wear mark at the bottom of the tread groove. The wear mark height of the general car tire is 1.6 millimeters (this height is also the minimum groove depth of the legal tyre), and the abrasion mark on the heavy tire is 2.4 millimeters.

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range