Q:lost my original 7A cable and the uk wire is 2.5A

The slim is a two prong power cable however the fat one has a three prong.

Q:I've looked on the internet, but it doesn't seem that the power cable for this printer is sold anywhere! Does anybody know if I'm able to buy it? And if so, where? I'm desperate. I don't want to buy a new printer. Even though this printer, actually, sucks. Let me know..........

www.okorder /... This will get you started in the right direction it is the hp parts store and yes apparently you can buy one. didn't know if you meant the cord or power block thingie.

Q:keep in mind this is a 6 yr old machine, the old roms connected the old way, I don't even know the name of the old cables.....

that okorder /

Q:i have a sata hard drive that i wont to put in an older mb. i purchased an adpater but i do not know what the larger sata cable if for. there is no place to put it.

There's a third connector you might have noticed, which is the jumper pin settings. You don't need to play with that -- the jumper pins are there for you to set your hard drive into 1.5 GB and 3.0 GB speed modes. By default, it's set to 3.0 GB. You change it to 1.5 GB if your motherboard demands it.

Q:Power cable, the wire yellow line green line red line black line blue line why the line?

This is the wiring of the cable wiring formulas: the next five is 10 square below the current per square 5A current wiring, one hundred and twenty is more than 100 square per square 2A, 25335 three circles, meaning 10 (Excluding) or more, 25 square feet per square 3A wiring, 35 square (inclusive) or more, 100 square (excluding) the following per square 4A line, that is, 25 square feet, 35 square feet per square by 3A or 4A wiring line.

Q:I lost the power cord and USB cable to my HDD case. The company of the case is Intex. On a sticker is says, Intex HDD Case T-350 SA.This was posted a long time ago by someone, but it's the only place I can find the photo.Serious answers only please, I'm not asking if I should get a new one. I just want to know the information on the power cord and cable.

It's a regular USB 2 cable. No idea what sort of power it takes. Can't be a very special power though. Your best bet is to get one of those switchable supplies from Radio Shack and try the voltage one at a time until the drive works. If you go under the drive won't run, so you can't do it that way if you start low and move higher.

Q:a few of the amp power cables in the recording studio got mixed around, and I'm not sure which is mine. My amp is a Fender Mustang III, (100-120V, 50/60 Hz, 310W) and I'm wondering if there is a specific power cable that I CANNOT use for the amp, like one that fits into the plug in the back but has too much voltage, and so on.

The power cable for that amp should just be a piece of wire...nothing else. The voltage is determined by what you're plugging it in to. Any standard IEC C14 power cable will work for you. Good luck. Greetings from Austin, TX Ken

Q:Does it need the PCI-e power cable on the PSU

No maximum mom forums are huge-spread in they want the ATX 24pin significant plug. The could also want the 12v AUX too. regularly there's a mixture of molex and SATA connectors. maximum production unit machines do not use a extreme end video card so the wont have the PCIe video card connectors you should actually get a PSU that has extra skill than the cardboard needs AND that it comes with each and every of the connectors you want.

Q:Hi,I have a set of Sony speakers that are a few years old. They have no power cable (nowhere to plug a cable in either) and the aux cable has no jacks. It is just two split wires. How can I connect them to my TV?Thanks,Aaron

Your unpowered (standard) speakers do not Plug in to a TV. They Plug in to an amplifier/receiver like all other standard speakers in this world do. Your speaker wires are not AUX cables, they are eh, speaker wires. speakers left over from all in one movie disc player/radios wont match up with normal recievers. You throw them away with the defunct disk player (HTiB). I do not believe for a second you do not know what a speaker is, or how normal speakers connect. This technology has been around for a century.

Q:If you look at a power line it is hanging down in the middle why is that

gravity. Power lines are not light. If you try to pull them tighter, to reduce the amount of sag you can break the line itself, or put tremendous strain on the support towers.