PP Diaphragm Pump

Ref Price:
Loading Port:
China Main Port
Payment Terms:
TT or LC
Min Order Qty:
1 unit unit
Supply Capability:
1000 Per Month unit/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Details for PP Diaphram Pump

 

1, Package and delivery of PP Diaphram Pump

1) Packed with standard exporting wooden case, requested package will be acceptable.

2) Delivery date will be within 30 days after receiving the prepayment.

 

2, Technical specification of PP Diaphram Pump

Working Principle:

Double Diaphragms

Main applications:  

Oil, Water, Chemical, Foodstuff, etc.

Driver:

Air operated (Penumatic)

Power Specs:

380/415 V 3phase;  50hz/60hz etc.

Max. permissible fluid temperature:

150°C

Type of connection:

Flange, Thread, Quick Coupled.

Installation position:

Connect to compressor

Casing/Inner parts material:

C.I, S.S, PP, Aluminium /PP, PTFE, PVDF.

Shaft seal type:  

O-rings in pump

Free passage:  

3mm-10mm

Maximum viscosity:

5X104CST

Maximum drive rating: 

0.2-0.7mpa  (2-7bar)

Maximum caliber:  

4 inch      (100mm)

Maximum dischrage head:

0.5mpa     (5bar)

Flow rate range: 

0.8-40 m³/h  (13.3-667l/m)

 

3, The advantages about our PP Diaphram Pump

1) Four bolts connection with very round ball, well seal and good dry suction. The actual dry suction can reach to 4~7m.

2) High roundness valve ball for use the ball mill machine.

3) Three section manifold, Flexible installation and even can simultaneously convey two different liquids.

4) Longer diaphragm life. Diaphragm material from Dopont, Exxon.

5) Pilot type air valve, low maintenance, low air consumption, so the using cost is low.

6) Wetted body: PPH, PVDF, SS304, SS316, Aluminum etc.

7) Diaphragm: PTFE, Hytrel, Santoprene, Viton etc.

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Why is the gas pump always old?
Now printing equipment mostly uses the ZYB type pump, ZYB type pump is used for unloading ring device and the air supply device, has the advantages of low noise, low wear and sufficient gas, can also be a pump, which can be used for feeder, and can be used for assisted delivery, it is widely used. However, after a long pump the operation will gradually appear, fuel injection pump (some for fume) failure, pump oil ejected from the blowing nozzle blow to the printed sheet, causing great waste, waste
Q:How to make a simple oxygen pump?
Oxygen in the water can be increased through the flow of water, not necessarily to the water filling oxygen. Just as the living creatures in the river do not lack oxygen, a reason, because the river is flowing.Understand this principle, oxygen pump is not so complicated. To get a small motor or engine, and power, then the gear in a motor with a plastic or metal sheet made of water,, fan blades and so can, anyway, let the water flow up fast. Just fine. But it's better to buy one than waste so much. Small power pump is only 56 yuan, a little more than ten yuan. At least in terms of electricity, than homemade safety..
Q:What's the difference between an air pump and a cylinder?
The air pump is used to carry the gas. The cylinder is used to compress the gas. An air pump is a device in which the cylinder is a component. The cylinder can be used as an air pump, but the air pump does not necessarily have to be made of cylinders.
Q:380V air compressor (air pump) connected to the pressure switch and AC contactor, how to connect the two thin wire?
Isn't the circuit diagram in place? The circuit design is differentIf the switch is normally closed, the series connection in the circuit may not startIf it is open parallel, the circuit may not affect the use of the circuit, regardless of which does not connect, will lose protection
Q:Is the water pump or the air pump for fish farming?
Submersible pump - circulating filter tanks, ----40 water tank - waterfall filter is enough.Add oxygen pump cylinder with water, fish -- increase the normal weather is not without the addition of oxygen - floating head,
Q:How can I solve the water in the air pump?
1. set up a slightly larger air storage tank, so that the water droplets in the compressed air and oil in the tank naturally sink, and then discharged through the valve2., there is a special water switch, as long as the things connected, the waterproof screw off, you can put the water off. The general drain screws are at the bottom of the air pump.Air compression, the release of pressure, condensation of water in the air to form water, which is a normal physical phenomenon.
Q:Should the air pump in the tank keep open all the time?
Air pump is generally not bad, I feel your cylinder density is a little big, or the air pump has been open better
Q:What lubricant does the air pump use?
Air compressor oil will do!
Q:Centrifugal fan can use as a pump? It can vacuum?
Yes, but it doesn't work. Vacuum pumps are generally used with liquid ring pumps and Roots pumps, and this effect can reach about 200-400Pa of the vacuum. If the vacuum requirement is higher, then there are other ways, including chemical methods.
Q:Air compressor or small pump is how to determine how much spray guns can be equipped with the wind?
1, determine your gas consumption (pneumatic tools can be used to obtain), gas pressure. 8 kilograms is enough2 and then select the right air compressor according to the amount of air you have calculated. Generally more than 20% of the rated gas (consider leakage, etc., of course, the choice is just right, you use those gas equipment will not use it at the same time.)3, the pressure should be slightly larger choice, because the gas pressure loss in accordance with the transmission distance4, of course, willing to spend money, with much better frequency conversion screw machine point, it can be based on your actual consumption (to change the frequency to change the motor speed, power), better scalability (if you want to have more gas, will no longer increase equipment... At most, the frequency converter is used as the power frequency machine, and the electricity saved at that time saved the converter's cost. There are some tips for choosing the main road. When you buy the equipment, you can ask the manufacturer to help you design itPiston compressor is not what you said, the rated pressure is only 7---8 kg, and its pressure range is wider than the screw machine, 200 kilograms also have!!! Screw machine, then the first level of compression will be 13-15 kilograms, two compressed 30 kg.....If the screw machine, the wearing parts are less than the piston machine.... Like the piston, often replace the piston ring, into the exhaust valve, etc., and these have special maintenance personnel to engage in trouble
The Company has considerable strength in scientific research and technical services and furthermore possesses high-precision test equipment, advanced manufacturing technique and perfect test means and moves towards the international level of pump manufacturing gradually. Our products are widely used in chemical industry, painting, foods, environmental protection and petroleum industry etc. and get a good reputation from all clients.

1. Manufacturer Overview

Location Shanghai,China
Year Established 2009
Annual Output Value
Main Markets
Company Certifications ISO9001-2008;ISO90012001

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range