electric transfer pumps with big flow, high pressure. It can transfer diesel oil, gasoline, hydraulic oil, engine oil, water. The stainless steel barrel & drum pump is suitable for milk, vegetable oil, honey, wine, alcohol, acid, and some corrosive liquid transfer. The engineering plastic barrel & drum pump is special for strong acid and high corrosive chemical transfer.
- Q:Where does the engine oil from the oil pump go?
- Let me add, the larger engine oil pump - the cooler - the main oil road - to the other oil ducts
- Q:Audi a6l2.0 engine oil pump timing, right?
- This newspaper, engine type, check the information I gave you
- Q:Engine oil pump is blocked when the chain would ring
- 1, the phenomenon is generally rhythmic sound, the sound is on the side of the camshaft, the noise is more than when the gear meshing uneven sound sharp. At low engine in speed, sound obvious and clear; increase the solar term door opening, the sound increases and becomes messy. In a few cases, a very heavy "click" sound can be heard, as if the camshaft bearings are seriously loose.2, reason oil pump shaft, distributor drive shaft bending or axial clearance is too large: oil pump drive main and driven gear, distributor drive, driven gear, crash or wear and tear deformation.3, check and judge this sound "fire test" test is invalid, you can touch the stethoscope at the lower end of the distributor body auscultation. If the noise is obvious, the body has a slight vibration, can be repeated from idle to low, medium speed throttle test. If the sound changes, as mentioned above, it may be this sound. If you hear a heavy click or click, as if the camshaft bearings are loose and loose, it is possible that the oil pump is broken.
- Q:In the 1 to 2 seconds when the vehicle is started, does the oil pump inject engine oil into the engine?
- 1, the pump is driven by the engine, has not formed the oil pressure, ah, fuel injection ah. 2, no oil pressure, lubricating oil does not work, using the starter to drive the engine, and more can not help lubrication, you think it is a motorcycle ah?. In addition low temperature starting, oil pressure has not reached, and the oil temperature is low, poor mobility, no fuel injection, in order not to affect the lubrication oil does not flow through a filter, so the oil containing impurities, if the vehicle is harmful to the engine oil pressure, so only the lamp before driving, hot to hot oil and reached the normal working temperature.
- Q:How to identify the motorcycle engine oil pump is normal?
- Start the engine first and see if there's any white smoke
- Q:The oil pump light is on all the time
- Low oil pressure time lamp is bright, the cause of the low pressure oil pump is a bad may have no pressure, pressure sensor two is broken there is no pressure signal, then the oil filter is blocked and no pressure, although the oil chamber has no pressure oil but also can burn out bush. In short, there must be a fault, but have to go to the factory as soon as possible to check it.
- Q:How can I know the motorcycle oil pump?
- The cylinder head four nuts is a yellow pad with a copper pad, is generally the lower right corner, it is the oil check screw, take it off, start the engine soon after oil runs out, if there is no oil outflow or outflow rarely, that oil pump may be a fault or is the blockage of the oil pump, but the general problems can cause the camshaft, rocker arm, cylinder wear, plug, ring, will not affect the ignition instability, if it is bad to can affect the ignition instability point, the parts would wear a different sound. If the ignition is unstable, it is better to find the reasons for the carburetor, the sealing of the valve, the valve clearance, and the spark plug.
- Q:How tight is the screw for the car engine oil pump?
- Hello, usually 50 to 70 or so,
- Q:The motorcycle oil pump is broken. Can the oil be added directly to the tank?
- Motorcycle oil pump broken, oil can not be directly added to the tank.If the proportion of 40:1 in gasoline engine oil, that's not what relationship, does not affect the use, if down a lot, recommend cleaning oil, because the oil will cause the combustion of coke, when the cleaning nozzle is 200 if ovo, higher proportion, even fire are not, ultimately only cleaning.
- Q:6140 lathe oil pump, no fuel injection, what is the problem?
- Replacing an oil pump can be easy and inexpensive
Our main products are all kinds of centrifugal pumps, displacement pumps and vacuum pumps, such as oil pumps, multi-phase pumps, single stage and double suction centrifugal pumps, horizontal split case pumps, multistage pumps, axial-flow pumps, mixed flow pumps, petrochemical pump and submersible pumps. Besides, our company also manufactures electric motors and sells electric motors, building materials, indoor decoration materials, civil electric equipment, devices and instrumentation, as well as exports our mechanical and electric products.
1. Manufacturer Overview
|Annual Output Value
||US$5 Million - US$10 Million
||59.00% Mid East
8.00% North America
8.00% Southern Europe
5.00% Eastern Asia
2.00% Southeast Asia
2.00% Western Europe
2.00% South America
2.00% Central America
2.00% Northern Europe
2.00% Eastern Europe
2.00% South Asia
2.00% Domestic Market
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||51% - 60%
|No.of Employees in Trade Department
||Above 100,000 square meters
|No. of Production Lines
||OEM Service Offered Design Service Offered Buyer Label Offered
|Product Price Range
||High and/or Average