Q:Led display point density is what it means

LED display density refers to the LED display per square display the number of pixels, such as P10 model LED display is 10,000 pixels per square point, P16 model refers to the display refers to 3906 pixels per square point.

Q:Led display support what video format

In fact, as long as you can play the video player, the display can be displayed! You put the display number of points set up, the video with the storm video playback, as long as the storm video to the LED display display area, the same size can be!

Q:LED display more than the size of the area must be 380v

LED display itself only need low-voltage DC power supply, whether it is 380V or 220V need to go through the buck and rectifier, which is the screen does not matter. Whether it is to use 380V or 220V depends entirely on the load balance of the power grid considerations, which depends not only on the size of the display, but also on the local grid capacity. In general, LED is weak devices, even if the display area and then large, the total power is also less than where to go, so you can use 220V single-phase power supply, but the power supply cable cross-sectional area to be larger, but the power circuit Much simpler.

Q:LED display a board dark light how is it?

Measure the power supply module voltage low, adjust the fine-tuning (power module close to the indicator light at the fine) to make the voltage to the standard.

Q:Led display brightness is not enough because of what are the reasons

Note: The above is the common cause of the LED screen dark screen, starting from the basic situation, one by one investigation, if the above can not solve your problem, please contact the warranty.

Q:Production of LED display the basic raw materials which ah?

PCB, circuit board, drive IC, resistance, exclusion, LED light-emitting diodes, row of pins, row seats, capacitors, three anti-paint, plastic sets of plastic, waterproof plastic, fine screws, copper pillars, magnets, Power cord, connector, switching power supply, frame. Control System.

Q:LED outdoor display which part of the composition

Outdoor, LED display, as the future of outdoor display advertising media new favorite, widely used in finance, taxation, industry and commerce, post and telecommunications, sports, advertising, factories and mines enterprises, transportation, education systems, stations, docks, airports, shopping malls, hospitals,

Q:Is the TV screen good for the LCD or the LCD?

Although the cost of CCFL is not high, it is about ten yuan, but the maintenance staff will certainly open a high price to help you ), The operating voltage is lower (LED in 2V ~ 4V can work, and CCFL tube needs nearly 1200V high voltage to start, so need to use a special inverter circuit to provide high voltage. Inverter circuit is easy to bad.

Q:IPS screen and LED screen difference

LED is the backlight, longer life, lower cost, with TN screen you slightly higher performance, LED performance is good, high dynamic contrast. The disadvantage is too bright, a little hurt eyes. Now the mainstream are used LED screen, short response time, suitable for playing games.

Q:Comparison between LED display and DLP splicing

DLP is a digital light processing, this technology is the first image signal through digital processing, and then the light projection. From DLP's technical principle, it has the least signal noise, accurate gray level, high reflectivity, seamless image display, high reliability and other advantages. DLP splicing screen by a number of rear projection display unit stitching, the most important feature is the patchwork small, you can control to 0.5 mm or less, we call it "seamless" splicing, which is the other two major technology LCD and PDP Can not and can not.