Q:LED display power supply how to configure how many units with the plate is calculated.

Upstairs are said that the P10, if you do not use the P10 it I tell you how to calculate the power of a board. Generally you take a lamp beads 0.02A to count, a board on the total lamp beads * 0.02, if the board is 4 sweep with the band / 4,8 sweep of the 8, the static is not removed to get a board of power

Q:How do I choose the dot pitch of the LED display?

Installation classification: lifting, hanging, seat, inlay, rotating bracket hanging;

Q:What is the thickness of the led display?

The thickness of less than 75mm, with the aluminum. Can also be thinner but the material is not easy to find.

Q:What is the difference between an LED display and an LCD monitor?

LCD LCD liquid crystal display LCD full name, mainly TFT, UFB, TFD, STN and other types of liquid crystal display.

Q:LED electronic display and P have anything to do

P generally represents the pixel pitch, and P followed by the value of the two mainly refers to the distance between the pixels, usually called the point spacing. And the smaller the value of this point spacing, the higher the unit pixel, the more clear the display screen.

Q:LED display how to install it?

LED display according to the application of different areas, divided into a variety of installation methods, there are: fixed installation, rental hoisting, stadium fence installation.

Q:LED display a board dark light how is it?

Measure the power supply module voltage low, adjust the fine-tuning (power module close to the indicator light at the fine) to make the voltage to the standard.

Q:Production of LED display the basic raw materials which ah?

LED display (LED panel): LED is light emitting diode, LED abbreviation, referred to as LED. It is a kind of control by the semiconductor light-emitting diode display, the approximate look is by a lot of usually red light-emitting diodes, light off the light to show the characters. Used to display text, graphics, images, animation, market, video, video signals and other information display screen.

Q:Comparison between LED display and DLP splicing

DLP is a digital light processing, this technology is the first image signal through digital processing, and then the light projection. From DLP's technical principle, it has the least signal noise, accurate gray level, high reflectivity, seamless image display, high reliability and other advantages. DLP splicing screen by a number of rear projection display unit stitching, the most important feature is the patchwork small, you can control to 0.5 mm or less, we call it "seamless" splicing, which is the other two major technology LCD and PDP Can not and can not.

Q:LED display power can not be displayed properly

Make sure that all hardware, including the control system, is fully powered up. (+ 5V, do not reverse, then wrong)