Over Heat Protection Electric Kettle
Specification of Over Heat Protection Electric Kettles:
Inner wall of the label
304 Stainless Steel
Features of Over Heat Protection Electric Kettles:
1. 360 Degrees rotation base, cordless body;
2. Cord storage design;
3. Indication light at the bottom;
4. Automatic shut-off when water boils;
5. Boil-dry & Overheating protection;
6. 100% boiled water;
7. Press button controlfor cover open.
Units / Carton
QTY LOAD 20'
QTY LOAD 40'
QTY LOAD 40'HQ
Certification: CE /ROSH /LFGB
- Q:The electric kettle is broken. After opening it, I don't know where it is broken. Somebody show it?
- 1. turn on the power, the indicator is not lit, check the power line is intact. 2., open the handle shell, check the thermostat contacts and switch parts because of water and rust, resulting in poor contact, if the water is rusty, you can wipe off the corrosion part, so that it is in good contact. 3., the use of water can not be too much, otherwise the water will overflow into the handle after corrosion, damage to the device. 4., check the above second key points, the worst possibility is bad here. 5, this electric kettle is not expensive, if the bad serious, there is no repair value, simply replace the new, both safe and easy to use.
- Q:How can you remove the kettle rust from the electric kettle?
- 1 white vinegar and water, with a 1:10 component, or add a little vinegar brine, overnight with a soft brush to remove; also can use wheat tea dregs with 1/3 pot of water, shake up and down repeatedly, can be eliminated.2 supermarkets sell special rust remover.
- Q:Hemisphere electric kettle after power on, the indicator light is not bright, not heating, how come?
- First open the pot, check whether the line open circuit; secondly, check whether 220V has entered the switch, if the switch, check whether the switch fault; if none of the above problems, check the lights and indicator lights are fault resistance. I have encountered several lights, that piece is a problem, the direct removal of the indicator light and the indicator current limiting resistance, the lights will be connected to both ends of the line, the end of the package can be used. Several have been repaired, all of them.
- Q:The electric kettle is burnt out. Will it be repaired?
- I'm from research and development. I have been designing electric kettles for 2.5 years!Kettle dry burned out, plug can not be reused, usually three components reasons.1 is the fuse burned down the connector. Can not be simply repaired, can only change connectors. 2. is the electric heating tube resistance wire burning, need to replace the electric heating tube. The 3 is the original manufacturer of electric heating tube in the assembly and the contact surface switch double metal shrapnel or poor contact thermal paste uneven smear or non locking screws, causing second melt connector protection fuse.The above analysis is to re configure the relevant components, and I understand, the market generally does not sell individual parts drops, or suggest Louzhu buy a new bar?!
- Q:There is a stink in the electric kettle chassis. What's the matter?
- Well, does that look like a short circuit, or a water problem? I've never had a problem like this, or it's a bad plug
- Q:Induction cooker heating, electric kettle heating, which save electricity? Please explain the principle!
- The electromagnetic oven is by converting electrical energy into magnetic energy, through the principle of electromagnetic induction, the iron wok inside the molecular collision between the heat generated in the heating pan so also off a lot of heat. The heat efficiency of the electromagnetic oven is the highest in the United States cooker (model cu201) up to 94.36%.The electric kettle is heated by the heating tube or the electric heating plate at the bottom of the kettle, and the heat is absorbed by the water directly
- Q:What are the requirements of the highest water level of an electric kettle?.
- 4706, there is a tilt angle test, as long as the water at the maximum water level, tilt test can not overflow, and in the water pot is always open will not automatically overflow
- Q:The electric kettle has been burning hot water for two hours. Can I use it?
- You can still use it
- Q:Where is the temperature control section of the electric kettle?
- The temperature controller of the electric kettle is arranged on the heating plate at the bottom of the kettle, and the base of the kettle is opened.The middle part of the thermostat is the thermostat.The water doesn't turn off automatically, not the thermostat.The steam switch is broken.
- Q:I want to buy an electric kettle for my mother, but I don't know whether to buy it with heat or without heat. Please buy some opinions about it! Which one is better?
- Electric kettle power is generally relatively large, 1000 watts are very common, generally around 1500. So high power, boil a pot of water, or 3 minutes (1.5 liters), if you want to warm, I do not feel meaningful, after all, it is not a long pot burning.Also some electric kettle with heat preservation, but generally large capacity (2 liters or more), large capacity kettle, if the home guests, boil a pot of water, three people can drink tea for several rounds. However, if less than 2 liters, it is not necessary to buy thermos bottle, after all, it is not a long pot burning.
we located in Cixi, Zhejiang Province, where the world-famous Hangzhou Bay Crossing-Sea Bridge originates. Established in 2010 ,is an environmental-friendly and high-tech company that specializes in the design, development, production and sales of air purifiers, as well as fruit & vegetable facial mask device and efficient vegetable washers.
1. Manufacturer Overview
|Annual Output Value
||Above US$16 Million
Mid East；Western Europe；North America
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
|No.of Employees in Trade Department
||Above 5,000 square meters
|No. of Production Lines
||OEM Service Offered；Design Service Offered
|Product Price Range