Navigation Warning Light
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1 Set pc
- Supply Capability:
- 3000 Sets per Month pc/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Obstruction light for a wide variety of cranes used in Harbors, Metallurgies, Towers (Telecom, GSM), Smokestacks, Buildings
Main fuctions and features:
• Use Fresnel lens, high utilization of light, valid keeping light beam in the scope as required
• Based on LED technology, low power consumption, and high effecience
• Die casting aluminum enclosure with powder-coat paint finishes, providing corrosion resistance and durability
• Extremely Reliable – Major Maintenance Cost Saving
• G3/4”pipe is available, ease of mount
• EMC Compliance, No RF Radiation
• Self-contained compartment, with stainless steel wire which is used to secure the unit against falling in operation, and ease of mount
• Lamp housing – Polycarbonate, with good anti-impact strength, thermal stability, high transmittance
• Built-in photocell can switch ON/OFF the light at dawn and dusk (optional)
• Steady burning or flashing type (no need external controller).
Specification
Standard | Compliant to the ICAO(Aerodromes Annex 14) and FAA-L810 | Vertical degree | ≥10 |
Light source | LED | Horizontal degree | 360 |
LED color | Aviation red | Flashing rate | Steady burning or flashing(flashing rate can be selected) |
Operating voltage | AC110V~AC240V(Option:DC48V) | LED life | ≥100,000h |
Power consumption | 6W | On/off level | 500Lux |
Intensity | ≥32.5cd | ||
Operating temperature | -30C ~ +70C | IP Protection | IP65 |
Relative humidity | 10% ~ 95% (no condensing) | Weight | 1.0kg |
Material | Base:Die casting aluminum, housing: PC |
Installation and operation
• Check whether the supply voltage does comply with the rated voltage of the lamp (Pay attention to the polarity in case of DC voltage).
• Insert the power cable through the bottom of lamp holder, and connect them to the terminals in the base respectively
• Select the flashing mode as required
• Tighten the screws between lamp housing and base
• Screw the lamp on the G3/4” ( G1”) threaded pipe, which should be fixed on a smooth surface with enough mechanical strength. Or you can select our mounting bracket: PJ024, PJ028 and PJ030 (installing diagram), special bracket can be customized.
• Verify whether the power cables are well connected before power on.
- Q:Is the wall wiring for fire emergency lights and safety exit signs piping or iron pipes?
- the fire separation zone must install fire doors must be equipped with double automatic system, with the fire regulations.
- Q:Emergency lighting supply time?
- fire fighting areas, such as fire control room, power distribution room, water pump room and other emergency lighting, at least continuous power supply 180min.
- Q:Is there a standard for the installation of emergency lights?
- according to the general direction of emergency right stick installation, the installation specification for space non defined, practical installation
- Q:What's wrong with fire emergency lamp fault alarm?
- . At this point, breaking off the power or troubleshooting, you can cut off the alarm sound;
- Q:Emergency light wiring diagram
- Two wire system and three wire emergency lamp can be unified on special power supply.
- Q:What is the expiration date of the fire emergency lamp? How long is mandatory abandonment?
- manufacturers marked with shelf life, in the shelf life has been, and the performance can not meet the requirements of use
- Q:Does the kindergarten classroom install fire emergency lights?
- smoke proof staircase and elevator room, fire elevator room or other rooms combined atria
- Q:Fire emergency lights how to use, led fire emergency lights circuit diagram
- the user to connect the power supply fire emergency lights, as long as the fingers press the test button two will also fire emergency lighting lamp lights lit.
- Q:What batteries are used in the fire emergency lights?
- Lead acid battery (VRLA) is a kind of electrode, mainly made of lead and its oxide. Electrolyte is the accumulator of sulfuric acid solution.
- Q:What is the standard for the installation distance of fire emergency lights and exit lights?
- Evacuation routes of longer distances should be guided by fire department or in accordance with emergency luminaire
1. Manufacturer Overview |
|
---|---|
Location | Shanghai,China (Mainland) |
Year Established | 2009 |
Annual Output Value | US$50 Million - US$100 Million |
Main Markets | South America 3% Southeast Asia 6% Africa 8% Mid East 2% Western Europe 80% |
Company Certifications | ICAO Certification; CE Certificate; CE Certificate; CE Certificate |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | 31% - 40% |
No.of Employees in Trade Department | |
Language Spoken: | English, Chinese |
b)Factory Information | |
Factory Size: | 5,000-10,000 square meters |
No. of Production Lines | Above 10 |
Contract Manufacturing | Design Service Offered |
Product Price Range |
Send your message to us
Navigation Warning Light
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1 Set pc
- Supply Capability:
- 3000 Sets per Month pc/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Related keywords