Monocrystalline Solar Module 198W

Ref Price:
Loading Port:
China Main Port
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
-

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Solar Monocrystalline (210W-225W)

Introduction of Solar Monocrystalline (210W-225W)

Solar modules use light energy (photons) from the sun to generate electricity through the photovoltaic effect. The majority of modules use wafer-based crystalline silicon cells or thin-film cells based on cadmium telluride or silicon. The structural (load carrying) member of a module can either be the top layer or the back layer. Cells must also be protected from mechanical damage and moisture. Most solar modules are rigid, but semi-flexible ones are available, based on thin-film cells. These early solar modules were first used in space in 1958.

CNBM Solar photovoltaic (PV) Panel is designed for large electrical power requirements. It is the optimal choice for both on-grid and off-grid power systems. CNBM Solar panel offers high performance of power per square foot of solar array. Monocrystalline silicon(c-Si): often made using the Czochralski process. Single-crystal wafer cells tend to be expensive, and because they are cut from cylindrical ingots, do not completely cover a square solar cell module without a substantial waste of refined silicon. Hence most c-Si panels have uncovered gaps at the four corners of the cells.

Characteristics of Solar Monocrystalline (210W-225W)

I. Solar Cell : High efficiency crystalline solar cell. Even if under the weak light, the solar module can produce maximum power output.

II. Tempered glass (toughened glass): Anti-reflecting coating and high transmission rate glass increase the power output and mechanical strength of solar module.

III. EVA and TPT: Using high quality EVA and TPT to prevent destroying and water.

IV. AI frame: Without screw, corner connection. 6 holes on the frame can be installed easily.

V. Junction box: Multi function junction box with water proof.

VI. Long lifetime: ≥25 years; Less power decrease.

VII. Good performance of preventing from atrocious weather such as wind and hails.

VIII. Resisting moisture and etching effectively, not effected by geology.

IX. The certificate issued by international authority: UL, TUV, IEC, VDE, CE.

Standard Test Conditions of Solar Monocrystalline (210W-225W)

The opto-electrical specifications shown below are stabilized values being measured at Standard Test Conditions, Irradiance: 1000W/m2, Spectrum: AM1.5 at 25°C, The info below is subject to manufacturing tolerances. Where appropriate minutes of measurement are available and are used for the dimensioning of the installation.

Advantages of Solar Monocrystalline (210W-225W)

• CNBM Solar performance guarantees for 25 years

• 10 years guarantee for workmanship

• Timeliness of delivery

• Quality Products certified (TÜV, UL, CE, VDE, ISO)

CNBM International Corporation's products including Monocrystalline Solar Panel, Polycrystalline Solar Panel have received and enjoyed famous reputation in many countries and regions in the world .As a solar panel manufacturer in China, we strive to provide our customers with excellent service, superior products and unmatched value.  


Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Any help financially to buy solar panels?
I don't believe that there is any help yet.
Q:What kind of batteries to use for a solar panel?
If you will be storing them outdoors, you can use auto batteries. Indoors, use sealed marine batteries. Number and size depends on your needs. You will need a charge controller between the solar panels and the batteries to get the maximum power out of the array and to avoid damage to the batteries. And you will need an inverter to convert the 2 or 24 volts to 20 or 240 VAC. One large lead acid battery will supply about 000 watt-hours of energy, enough for 200 watts for 5 hours. You have to look at your loads and decide on how many batteries you need. Frequently it is cheaper to buy new appliances that use less power, as that power difference can save a lot of money in batteries, inverter, charge controller and solar panels. But it sounds like a few thousand watt-hours will be enough, or 2 large batteries. The real limiting factor is how much money you want to spend for the solar panels themselves. .
Q:What would be a good battery for this solar panel?
How many batteries you will need depends on what you are planning to do with them which you did not mention? Sunforce makes a 30 amp charge controller part no. 60033
Q:What is the main material for making solar panels?
You can also according to their own needs, according to the power to buy a good package of solar photovoltaic products.
Q:Infra-red solar panels?
Solar panels work when the metals from which they are made release electrons when hit by radiation. There is a threshold that, below a certain wavelength/frequency, they do not eject electrons. As frequency increases, more electricity flows. Radio and infrared are the least energetic electromagnetic waves.
Q:Solar Panel Installation?
Wires from panels go to controller input terminals. Controller DC battery terminals to battery so that the controller will protect batteries and split power as required by demand to the inverter. Output DC on controller to inverter. Output AC or outlets on the inverter to AC appliances. One thousand watts is not very much capacity. It will keep your computer running and a lamp to read by. It won't run major appliances. A hair dryer is typically 500 watts and could not be run by this system.
Q:can i use 00 ohm /4 watt resister for 5v coming direct from solar panel?
Just connect the 5 volts out of the panel directly to the iphone via an USB connector. BUT, is the panel output always 5 volts, ±0.25 volts? Because that is the USB specification, and anything outside of those values could damage your iphone. And solar panels are known for their wide swings in voltage. Bottom line, resistor not needed, and you need to be positive you supply the correct voltage to the iphone. Best way to do that is to start with a solar panel that puts out at least 7 volts and use a LM7805 regulator. The only resistors needed are those to tie the data lines into a certain combination of resistance and voltage so that the iphone is fooled into thinking that a proper USB is connected. That would NOT involve a 00 ohm resistor. Search online for the proper values and connections. edit: are you repeating your same inane question with a different account? That is totally against the rules and could get you suspended.
Q:are solar panels worth buying?
There are different kinds of solar panels. The biggest division is between photovoltaic panels that produce electricity and thermal solar panels that produce heat for hot water and space heating. Commercial photovoltaic panels are from 8 to 24% efficient while solar thermal panels are from 60 to 80% efficient. Solar thermal panels especially for hot water have a much higher ROI (return on investment) than photovoltaic panels. A solar hot water system may have a payback period (when savings equal the investment) as short as 3 to 5 years while photovoltaic panels will typically have a payback period between 7 and 5 years. Solar panels especially in times of low interest rates may be a very worthwhile investment with a better return than you can find almost anywhere else. But they are also highly dependent upon your situation. Owning a home with a good southern exposure is a prerequisite.
Q:solar panel inverters?
Investors in this ground-breaking technology include Rockport Capital Partners, Third Point Ventures and Applied Ventures, the venture capital arm of solar equipment manufacturer Applied Materials. Enphase Energy's CEO Paul Nahi said the company raised money earlier than expected due to strong demand for its microinverters. So what are these microinverters? The Enphase Micro-inverter shifts DC to AC conversion from a large, centralized inverter to a compact unit attached directly to each solar module in the power system. Distributing the conversion process to each module makes the entire solar power system more productive, reliable, and smarter than traditional solar panel inverter systems. Usually, one single inverter is dedicated to a rooftop array of panels for a homeowner. Enphase Energy, however, have built a DC-to-AC inverter that is placed on each single panel. This makes it more reliable than a centralized inverter and more efficient, so panels can generate more electricity, Nahi said. Enphase has already started shipping its microinverters and has tied up deals with several panel distributors and installers. The future of inverters? Enphase Energy has been able to improve the DC-to-AC conversion efficiency to around 95%. Because of this, Nahi predicted more companies will turn to decentralized inverters. There's been very little question on the benefits of microinverters, but people didn't think it was possible to get the efficiency levels required, he said. Now it seems that they have. If you are looking for high quality, low price solar panel inverters please visit my UK store by clicking here. For our US store click here. To return to our solar power news page. To return to our Total Solar Energy home page.
Q:Should I buy solar panels?
Probably, however, depending on what your business does, solar panels can be a somewhat effective marketing strategy. Also you are helping the environment with your investment in solar panels. On a side note, I didn't think modern solar panels had a payback period of 8 years? From what I've heard it's more like 7 years. Oh well, I don't know much about this topic.

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range