Q:What is the principle of a hydrogen dryer?

Adsorption at a high temperature and partial pressure of water vapor at a high temperature and low water vapor partial pressure (regeneration)

Q:What shall I do if the heating indicator of the air dryer is not extinguished?

Check to see if the temperature sensor is damaged or malfunction fails

Q:What is the mean of dryer?

Mechanical equipment for realizing drying process of materials

Q:What are the types of dryers according to heating methods?

Dielectric dryer is to use high-frequency electric field action, so that the wet material heating effect drying

Q:What are the drying agents that are often placed in the dryer?

Silica gel, montmorillonite, molecular sieve, mineral, fiber, activated carbon, lime and so on

Q:What's the difference between freeze dryer, micro heat regeneration dryer, non thermal regeneration dryer and waste heat regeneration dryer?

The freeze dryer cools the compressed air to 2-10 degrees by freezing so that the air will dew and then separate and drain the water by mechanical separation, and the compressed air gets dry

Q:When the automobile air conditioner is used, why is the dryer hot?

The dryer is mounted behind the condenser and the compressor compresses refrigerant to produce a high temperature, high pressure gas into the condenser. A semi fogging refrigerant, which is cooled by a condenser to about 70 degrees, enters the dryer. So the dryer is very hot and hot

Q:What is the principle of a spray dehumidifier?

When the temperature of the wet gas drops below the dew point, the steam condenses and reduces the humidity of the gas

Q:What are the factors affecting the dryer?

In the air around the particles, the absorption of heat and the diffusion of water molecules to the surface of the particles take a certain amount of time. Therefore, the resin supplier shall specify the time required for the effective drying of a material at the proper temperature and dew point.

Q:What is the mean of Dehumidifier？

The air can be blown through a number of metal fin tubes, with cold water in the pipe, and the surface temperature of the tube wall shall be lower than the dew point of the air, so that the water vapor in the air can be partially condensed and removed on the surface of the tube