Standard Size: 595mm*595mm, 605mm*605mm
Standard Thickness: 9, 10, 12, 14, 15, 18mm
Edge Detail: Square Edge, Tegular Edge (≥12mm)
Technical Data of Mineral Fiber Ceiling:
Fire resistance: Class B1 (standard GB 8624-1997)
Moisture rate (%): ≤3.5 (40℃,70%RH)
Light reflect: 0.70-0.80
Sagging resistant properties: ≤0.35mm
Humidity Resistance: ≥85%
Typical Application Areas of Mineral Fiber Ceiling:
Hotel Lobbies and Corridors
Offices and conference rooms
Hospitals and other Public areas
- Q:I would like to ask what software is usually used to draw?
- Carved hollow pattern, it is recommended to use Wentai can, very simple. After the pattern is opened, select the right mouse button, there is a modified graphics parameters, can be used to modify the size of the graphics.
- Q:Uv decorative plate how long does not fade
- You can buy outdoor UV board installed in the room, then the fade rate will be reduced a lot, fade mainly because the sun color
- Q:Plastic wood exterior wall decoration board specifications is how much
- This specification is not uniform, and generally each factory will have their own production of several fixed specifications for consumers to choose
- Q:Li Mei diatom decorative plate more than one square meter
- For those who want to renovate, it can be said is a big advantage, 100 square meters of the house, just a few carpentry, rough can be on the wall, within 1 week can be completed, compared to the traditional decoration, the province More than 70%, cost savings of more than 60%. And that equipment that is easy to disassemble, can also be recycled several times, the provincial workers to save money!
- Q:What kind of material is good?
- See the landlord's preference;
PVC material: affordable, easy to install, but not fire;
Gypsum board material: the use of a wide range of refractory tide resistance is gypsum board outside the latex paint or wallpaper finishes;
Wood material: wooden grass-roots board outside the color plate ---- I do not like, too cumbersome friends, the cost is high.
- Q:workout for baseball ?
- Those are what you want to do during the offseason). If you think you're starting to lose some of it, then go up to 2. Endurance training only needs to be stimulated two or three times a week. At the end of practice, go do your sprints, ultra-short interval training. The next day, go for an hour run. Next day or so, USIT again. Next week switch it up, so hour run, USIT, hour run. As for nutrition, it depends on the athlete (principle of individuality, everyone is different), but a general rule is complex carbs (because they are absorbed and released more slowly than simple carbs, which provides a sustained high energy release. They are also high in minerals, vitamins, and fiber, while low in fat and cholesterol.) should comprise at least 60% of the diet, protein 15-20%, and fat 20-25%. This should be implimented 2 days before a game, and up to breakfast and lunch (if the game is in the evening). 2-3 hours before the game, make sure you consume a high carb, low-fat meal, and make sure you stay hydrated. You could have some whole-wheat bread or muffin, cereal, low-fat milk, and some bananas. Or a light lunch of some lean meats and some water. You should also follow that 3:1 Carb to Protein ratio 24 hours after the game, as it speeds up recovery. If you have a game the following day, just keep with the same ratios. Otherwise, a normal diet would be about 50-55% carbs, 15% protein, and 30-35% fat. It should support the highest energy demands for baseball. Supplements aren't needed if you are eating properly. If you're not, they're nice to have, but your inproper eating habits are still hindering. There is no convincing evidence that viatmins supplements are necessary for players who consume a high-energy athlete's diet that contains mainly natural and unprocessed foods. For water intake, you should have at least .5 liters before the game (not 10 minutes before the game), 100-200 ml every 15 minutes during the game, which is about .5 liter per hour.
- Q:I've been exposed to Asbestos, how concerned should i be??
- youll be fine, it takes years of working around it everyday for you to have a problem
- Q:Restaurant wall decoration board generally use what material
- Each material has advantages and disadvantages, the specific conditions can be selected according to actual conditions.
- Q:Pvc decorative plate line making machine how much money
- Polystyrene referred to as GPPS, also abbreviated as PS, is made of styrene polymerization. GPPS has the characteristics of light weight, low cost, low transparency, low water absorption, and is used in the manufacture of daily necessities. However, the disadvantages of GPPS are obvious, fragile, low strength, poor heat resistance, Taste and so on.
- Q:Can the decorative board be on the floor?
- 8mm trim panels The composite floor is 8mm, but that is the floor, not the trim panel. Decorative panels are to paint the paint, the floor is not painted paint, decorative panels without the floor so hard.
SERENITY,is a large company which produces light mineral wool acoustic board. It displays a good combination of production , manufacture, supporting sales and international trade.Its products cover more than twenty varieties of six categories, including knurling board, relief-embossing board, printing board, spraying board, stereo-molding board, etc.
1. Manufacturer Overview
|Annual Output Value
||US$5 Million - US$10 Million
||Japan, Italy, South- Africa ,India, Russia, Malaysia, Singapore, Taiwan and other countries and areas
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||61% - 70%
|No.of Employees in Trade Department
||30,000-50,000 square meters
|No. of Production Lines
||OEM Service Offered Design Service Offered Buyer Label Offered
|Product Price Range