Standard Size: 595mm*595mm, 605mm*605mm
Standard Thickness: 9, 10, 12, 14, 15, 18mm
Edge Detail: Square Edge, Tegular Edge (≥12mm)
Technical Data of Mineral Fiber Ceiling:
Fire resistance: Class B1 (standard GB 8624-1997)
Moisture rate (%): ≤3.5 (40℃,70%RH)
Light reflect: 0.70-0.80
Sagging resistant properties: ≤0.35mm
Humidity Resistance: ≥85%
Typical Application Areas of Mineral Fiber Ceiling:
Hotel Lobbies and Corridors
Offices and conference rooms
Hospitals and other Public areas
- Q:How to buy decorative plates, decorative plates to buy basic knowledge
- Decorative sheet from the PVC film and polymer substrate through the high temperature hot melt composite extrusion, no formaldehyde, mildew, anti-moth, waterproof, flame retardant, is the traditional decorative panels of the latest generation of environmentally friendly energy-saving products, but also you use Green products.
- Q:Stainless steel decorative plate where there are?
- General stainless steel decorative plate types are 201,301,302,304, and so on
- Q:Audi a6d column decorative board total disassembly
- This is a direct stuck in the above with a little bit of pry can be paved out of the board
- Q:Embossed decorative board which is good?
- Embossed paint spray powder, know a OKorder country Yun technology, specializing in the production of this, as embossed decorative plate, then, should be the kind of embossed paint spray powder spray directly on the composite board it!
- Q:How can be fixed in the pvc decorative panel roof racks!
- Plywood must be more fixed a few points, but also to thick point, a lot of clothes racks are doing so.
- Q:Marble uv board decorative plate is not science and technology stone
- Belong to the board like marble
- Q:Insulation decorative plate of the new insulation decorative panels
- The new insulation decorative plate is different from the traditional insulation decorative plate is a new type of insulation decorative panels mainly to inorganic materials for the decorative panels, prefabricated or cast, and other new insulation materials or inorganic insulation materials made of new wall materials The Including but not limited to the OKorder Bailida Group production of GRC energy-saving insulation board, OKorder Fumei soft porcelain production of MCM flexible stone insulation decorative version, OKorder state-made production of fiber cement board inorganic composite insulation decorative panels.
- Q:what does AMF ceiling tiles mean?
- I believe it means Acoustic (or Acoustical) Mineral Fiber. It's used throughout the construction industry in a different array of materials for wall, insulation, & ceilings. Just Google it & you'll see many results.
- Q:Imitation marble wall decoration board how much money a square
- This depends on your specific requirements
- Q:How to use the wall decoration board
- The size of the entire decorative plate is 2440 mm × 220 mm. Install the first size according to the design of cutting, the board cut into the required specifications, the cutting point must be straight. The wall and decorative panels on the back of the brushing adhesive, pay attention must be fully coated, do not have the part of the brush, the wall should be pre-play a good control line pavement, compaction, until the adhesive dry hard, with silicon Patching or pressing. There is the mouth of the decorative plate width of 90 mm or l65 mm, the length of the general 2440 mm, should be used vertically, the installation should first press the design size of the material, the need for parquet should be cut on the flower after the puzzle Cutting. Before installation, the wall and the back of the board should be coated with adhesive, the adhesive in the upper, lower and middle parts can be painted, the installation of vertical compaction compaction, until the adhesive dry, with wood line pressure side closure. After installation of the wall decoration board, it is necessary to clean the extruded glue in time to prevent contamination of the board. Wall decoration board can be used after installation, no need to paint varnish and other surface decoration. Wall-mounted decorative panels are required to be flat, hard, clean and dry, and the treatment is the same as the wooden dado.
SERENITY,is a large company which produces light mineral wool acoustic board. It displays a good combination of production , manufacture, supporting sales and international trade.Its products cover more than twenty varieties of six categories, including knurling board, relief-embossing board, printing board, spraying board, stereo-molding board, etc.
1. Manufacturer Overview
|Annual Output Value
||US$5 Million - US$10 Million
||Japan, Italy, South- Africa ,India, Russia, Malaysia, Singapore, Taiwan and other countries and areas
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||61% - 70%
|No.of Employees in Trade Department
||30,000-50,000 square meters
|No. of Production Lines
||OEM Service Offered Design Service Offered Buyer Label Offered
|Product Price Range