IEC 60502-1, GB/T 12706-2008, VDE2071
Max. Rated conductor operating temperature is 70°C
PVC ( polyvinyl chloride )
PVC (polyvinly chloride)
- Q:Is the patch panel in the weak battery a telephone and network wiring cabinet?
- Can not, air compressor trachea will be heat, will damage the cable, too many pipelines buried together, after the maintenance will be a lot of trouble.
- Q:What are the characteristics of Teflon heat shrink tubing
- Appendix B Construction Division (sub-division) project, sub-project division B.0.1 Construction Division (sub-division) project, sub-project can be divided according to Table B.0.1Appendix B Construction Division (sub-division) project, sub-project division B.0.1 Construction Division (sub-division) project, sub-project can be divided according to Table B.0.1
- Q:Wireless network receiver access USB extension line did not respond!
- In the low-voltage circuit below 36V, the cross-sectional area of the conductor is not simply considering the safe current-carrying section, taking into account the line drop caused by the length of the transmission line. The cross-sectional area of the wire must also meet the rated voltage supplied to the load side after the voltage drop
- Q:Can KVV control cables be used for home heating?
- Try to do the cable in the other pipelines above, if it can not do so, then the cable can be in the following. Crossing with different pipelines requires different processing. For example, with the thermal pipeline cross, the thermal line in addition to the original insulation layer, the intersection also need to add insulation tube. No matter what the pipeline intersects the cable, either at the cross or the cable is covered with a protective tube, or other piping plus a protective tube, plus an isolation layer such as a cement tile. For details, please refer to the National Standard Atlas. The intersection in accordance with the national standard to maintain the required distance, the general cable from the other pipeline is greater than 0.5 meters distance.
- Q:Is the RVV power cable also called a cable?
- Must be reserved! Spare to stay, the normal use of the bad, spare can be used directly, such as fiber
- Q:The threading tube is punctured. The The What can the wire be used?
- There are signal lines and color lines, the most important thing is that he is shielded,
- Q:The working principle of the new force seeking the magnetic proximity switch
- Both use different. . fire bridge for 10KV following power cables, as well as control cables, lighting wiring and other indoor and outdoor overhead cable trench, tunnel laying. The fireproof bridge is mainly composed of glass fiber reinforced materials, inorganic binder composite fire board, and metal skeleton composite and other fireproof material composition, the outer layer plus fire retardant coating. Fire bridge after the fire will not burn, thus blocking the spread of fire. Fireproof bridge has a very good fire fire effect, but also has a fire, oil, corrosion resistance, non-toxic, non-polluting, the overall installation and so on. Fire retardant coating has a thin, high fire resistance, strong adhesion characteristics. . galvanized bridge, the main application in the wet, corrosive environment. According to the different production processes, divided into hot-dip galvanized and galvanized (ie, cold galvanized) two. Hot-dip galvanizing process: The process and method of forming zinc-iron alloy or zinc and zinc-iron alloy coatings on the surface of steel or castings immersed in molten zinc solution. Cold galvanized process: the surface of the steel chemical cleaning treatment into the plating solution, electroplating solution containing zinc oxide. DC a pole connected to the steel, a pole connected to the plating solution in the zinc plate. After the application of zinc to the molecular state of displacement to the steel surface. If the brightener passivation, then embodies the cloud-like bright coating. Application of galvanized steel in the general anti-rust effect is not very good, mainly galvanized capacity is not reached, and galvanized uneven, generally two or three years on the rust phenomenon, poor quality exposed to humid environment More than a few days on the rust. Hot galvanized coating thick, strong corrosion resistance. Cold galvanized galvanized layer is hot and bright, but thinner, corrosion resistance is weak.
- Q:What is the difference between a power cable and an ordinary wire?
- 3 EPDM recycled rubber; EPDM recycled rubber with high and low temperature resistance, anti-aging, high insulation, ozone resistance, anti-erosion and other physical properties, is widely used in wire and cable sheath, hose and other industries to go
- Q:What are the national standards involved in mining cables?
- The first, the size of the embedded hole should be designed in the bathroom before the decoration; second, leakage protection switchgear wiring should be installed before the shower room to consider good, so as not to rework; Third, the shower room style according to the bathroom layout Fourth, the shower room must be connected with the building structure to be strong; Fifth, if the installation of the shower room has been installed before the water supply system and tiles, the best custom shower room.
- Q:What is the relationship between the splitter and the fiber?
- The high power load is taken out of the separate loop. The other close to find the power connection.
Along with the development of the market, now our trade range becomes wider and wider. We really hope you can work together with us, and we will give you the best service and the best product quality.
1. Manufacturer Overview
|Annual Output Value
||Above US$100 Million
||Southeast Asia 0.3%
Africa 0.5 %
Domestic Market 99.2%
||ISO 9001:2000;ISO 9001:2008
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||21% - 30%
|No.of Employees in Trade Department
||5,000-10,000 square meters
|No. of Production Lines
||OEM Service Offered Design Service Offered Buyer Label Offered
|Product Price Range
||High and/or Average