Q:How to make the effect of LED light belt fixed?

The re purchase controller (usually flat 4 line controller 10 yuan), there are generally 8 kinds of adjustable mode, there is something you need to achieve the effect, and a controller with a maximum of 40 meters with lights on the line

Q:60 bead LED lamp with power supply, can be used on 120 bead LED lamp belt?

Power LED lamp with power supply must be rich, namely power LED lamp power supply should be greater than (not less than) the total power with all the lights, if the lamp with total power over the power supply provided by the power supply, and burned due to overload.

Q:What are the differences and connections between LED lights, light strips, hard lights, flexible lights, neon tubes, etc.?

Let's put it this way. Neon and LED lights are two different sources of light. LED light is a light source applied by PN junction of crystal diode. The neon tube is attached to the tube by a high pressure gas plus fluorescent powder.

Q:How many watts are there in one meter, 70 bead, LED lamp?

Take SMD5730 patch LED wick as an example. The 70 wick is 35W.

Q:How do I connect the two LED light bands?

Connect two LED lights, you need to see what kind of LED light belt, and some light belt itself has reserved lights, with serial plug, they can be directly inserted together.

Q:Led how to connect the light belt?

If you buy high lights, then only need a connection head on it; if you are buying a low-voltage lights, need to use a power converter, high voltage into low voltage, and then connected with lights, it will light up!

Q:Connect the LED light belt to change the electric wire!! the result electrify! The electric wire heating, the interface is electric hot, how to return a responsibility?

After the LED lamp is switched on, the wires heat up. It is possible that the new wires are smaller in diameter. After the LED lights are transmitted, the working current exceeds the safe current that the wires can carry. Recommended for a thicker wire (for example, is now 1 square wire, replacement of 1.5 square wire, specifically to see the lights with LED is the number of meters, the load is much, select the appropriate wire); or the LED lamp with cut part, so that the existing wire can be left with LED lamp the safety of power supply.

Q:What should I pay attention to when installing LED soft light belt?

Notes on installation of LED lamp band:Compared with the traditional LED lamp with lighting, or are in the development of new products, so many consumers on how to install the LED lamp belt is not very understanding, in the installation process may occur in a variety of problems led lights with LED can not be used, the correct use and installation of LED lights, LED lights with prolonged service life. We also need to understand the problem. LED lamp belt at the time of installation, must be in accordance with the concise, use the correct method to carry out the installation, if excessive distortion or incorrect use of the installation method, are easy to light with losses, reduce the lamp with the use of time, is not conducive to the maintenance of the lights. Provide you with the following details should be noted when installing the light belt:

Q:How many watts does the LED light have?

The band of lights in your picture is high voltage 220V's 5050 meter 60 lamp band. In theory, one meter is 14.4W, but the actual measurement is not so much.

Q:LED flexible light band width minimum, how much can be done?

3528 of the lights with 10mm width, I do not know if there is no finer.