Standard Size: 595mm*595mm, 605mm*605mm…
Standard Thickness: 8, 9, 10, 12, 14, 15mm…
Edge Detail: Square Edge, Tegular Edge (≥12mm), Concealed Edge (Customized)
Technical Data of Mineral Fiber Ceiling:
Fire resistance: Class B1 (standard GB 8624-1997)
Moisture rate (%): ≤3.5 (40℃,70%RH)
Light reflect: 0.70-0.80
Sagging resistant properties: ≤0.35mm
Humidity Resistance: ≥85%
Main advantages of Mineral Fiber Ceiling:
High humidity resistance properties
Excellent light reflectance
No content of asbestos
Zero release of CH2O
Typical Application Areas of Mineral Fiber Ceiling:
Hotel Lobbies and Corridors
Offices and conference rooms
Hospitals and other Public areas
- Q:Side Effects of Asbestos?
- Lung cancer is one of them.
- Q:TV wall with UV decorative board good? What are the advantages?
- The angle is also called the corners of the corners of the corners or the corners, which is a decorative line for the 90 degree lap angle of the tile. The floor is made of the bottom surface and the 90 degree fan-shaped surface is made of PVC, aluminum, stainless steel. The bottom plate has a non-slip tooth or hole pattern, easy to fit with the walls and tiles, fan-shaped edge of the edge of the limited edge of the ramp, used to define the location of the installation of tiles or stone. According to the thickness of the tile, the angle is divided into two sizes, the sun angle and the small angle, respectively, adapted to 10mm and 8mm thick tiles, the length of more than 2.5 meters. The angle is widely used because of its simple installation, low cost, effective protection of tiles, reduced collision damage caused by 90 degree lobes.
- Q:Wave board decorative plate where to sell
- A lot of the general plate market has more than one hundred round one, four or eight feet.
- Q:How is the medium density decorative plate fixed on the wall
- The wall first to do a layer of closed paint, and then use glass glue or adhesive tape plus adhesive, you can at least 20 years without falling.
- Q:How do the van side of the van?
- Remove the glass lifter handle the handle, the door of the hand,
There is a small plastic buckle inside the door. You can use a flat-blade screwdriver to open.
- Q:Outside the wall decoration board
- 1. Insulation insulation, energy saving Jin Kima metal insulation decorative panels with excellent thermal insulation properties, and the traditional wall panels and other building materials, compared with excellent cold insulation properties. Greatly reducing the heating and cooling energy consumption, thus saving energy expenditure. Jin Kima metal insulation decorative board products cost-effective, in the metal wall insulation decorative panels and other materials products show an absolute advantage. (0.15W / mk) 75mm, fiber cement board (0.17W / mk) 85mm, cement mortar (1.3W / mk) 650mm; and the thermal insulation coefficient and the same insulation effect material thickness comparison of autoclaved aerated concrete block Jin Kima metal insulation decorative plate thickness of 16mm, thermal conductivity was 0.020W / mk, far better than other insulation materials.
- Q:Li Mei diatom mud decorative plate Shenyang have it
- High prices also do not play the role of diatom mud original air purification. It is recommended to look at the manufacturers test report on the formaldehyde, toluene and other purification efficiency.
- Q:Toyota Highlander tail door trim how to dismantle
- Look carefully at the back of the little lid there is no Rose
- Q:Dpx interior wall decoration board in the clean board is made of fiber cement board?
- Yes, ah, clean board substrate is a lot, it can be a cement board, it can be glass magnesium board, calcium silicate board
- Q:What kind of decorative plate is the nail on the wall?
- Jin Kima metal insulation decorative board is a kind of high pressure, earthquake, moisture, water, fire, noise, insulation, low thermal conductivity, beautiful, durable, energy saving, simple construction, environmental protection and so on a series of excellent performance of the new Building materials, can be widely used in schools, hospitals, hotels, railway stations, villas, the old building appearance transformation, mobile board room, post booths, kiosks, power facilities, light steel structure,
1. Manufacturer Overview
|Annual Output Value
||US$5 Million - US$10 Million
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||61% - 70%
|No.of Employees in Trade Department
||30,000-50,000 square meters
|No. of Production Lines
||OEM Service Offered Design Service Offered Buyer Label Offered
|Product Price Range