Electronic Insect Killer light,
Pest Control.Mosquito trap
There are variety of aluminium insect killer for option.e.g.:40W,30W,20W,16W,12W
Electrical Insect Killer
Silver with black side(ABS)
20days after receipt of the Deposit payment
2 round pins or 2 flat pins
2*20W ultraviolet ray light
HYD-92 Aluminium Insect killer Range:
Electric Insect killer(with removable tray to collect the insects)
1.Utilizes two high quality ultraviolet bulbs to attract insects and draw them into grillsects.
Insects will be killed immediately once touching the electrical charged grid.
2.special chain holder and collection tray
3.the outer material is allumium.
4.High quality ultraviolet tube lures harmful insects to the builtin killing grids which kill off files,moths,bugs,
mosquitoes and other pests without the aid of chemical sprays.
- Q:What are the common projection lights?
- Projection lamp? Not heard, but heard the projector, hey!
- Q:Brightness is not the only standard. How can I buy projection light bulb?
- Bulb, as the only consumable material of projector, is an important factor that must be taken into consideration when choosing projectors. At present, projectors are generally used metal halogen lamps, UHE bulbs, UHP bulbs, these three light sources. The metal halogen bulb has the advantage of being cheap, and the drawback is that the half-life is short, and the brightness is reduced to about half of the total time it takes about 1000 hours. And because of high heat, the projector cooling system requirements, it is not suitable for a long time (more than 4 hours) projection use. The advantage of the UHE bulb is its moderate price and the brightness does not decay almost 4000 hours before use. Due to low power consumption, it is customarily referred to as a cold light source. UHE bulb is an ideal light source widely used in mid-range projectors. The UHP bulb has the advantage of long service life, and can normally be used for more than 4000 hours, and the brightness attenuation is very small. UHP bulb is also an ideal cold light source, but because of its high price, it is generally used in overhead projector.
- Q:Why do some projection lights go on and not immediately?
- The metal halide lamp work, if off immediately opened it takes a few minutes to light up, this is normal, because the temperature of the inner liner is light metal halide lamp is very high, this time off to re open it, inside the high pressure
- Q:How to make homemade starlight projection lamp?
- A lamp that will change the crystal ball and many water chestnut will add "chronic small motor small electric fan motor can be five yuan a
- Q:LED advertising projection lamp which has production? Usually, which would be better to choose which one to buy?
- The house is so light efficient that it really feels convenient to use it. To buy such a product, choose this one directly.
- Q:I want to sell the star projector, but I don't know where to buy it
- Mine is pirated, genuine, do not know, to purchase channels, but also do not know, can only tell you the quality of general
- Q:Projection lamp market is good?
- Its unique and unique display and low price, as well asPowerful features will make your environment dramatically change in very few places and with minimal cost, and it has the advantage of pattern contentYou can change at any time, want to play what hit what pattern size can be small or large, the utility model has the advantages of other lighting or other advertising display mode can not be compared,It can be used in supermarkets, franchised stores, shopping malls, office buildings, specialty restaurants, coffee shops, bars, nightclubs, cinemas, exhibitions and so on.
- Q:How to scientifically maintain the light bulb of projection lamp and prolong the service life?
- The bulb of the projection lamp is maintained as follows:1, according to the procedures of the normal switch machine, switch machine interval is generally greater than 5 minutes;2, the use of the process should not frequent power outages, as far as possible to ensure that the work process of power supply reliability;3, each work time is best not more than 4 hours, in the process of using a larger time interval, it is best to shut down for some time;4, the use of ambient light is not too bright, reflecting the brightness of the projector will lead to an increase in the bulb;5, as much as possible the power of identity, the nominal value of the power voltage, grounding and polarity, and matching the projector.
- Q:Which led projection lamp is better? Ask for an introduction
- In the projection products industry, especially high-tech LED projection lamp and high-power outdoor projection lamp field, Le Di photoelectric will be your reliable and powerful partner. We not only provide customers with full service from product selection, installation, training and customer service tracking, but also provide a private customized services for customers from all over the world, to meet the individual needs of different customers. Le Di photoelectric projection, creative advertising, science and technology and art interpretation!
- Q:What about "replacing the projector lights and cleaning the screen" on the screen?
- That means that the aging of the projection lamp, or the screen is too dirty and the effect is not good, automatic detection ah, you can clean it again and again, but it is best to find a professional master yo,
we are able to fulfill customers' specifications in a positive manner, and the diversification of our products has brought us more opportunities and competitive advantages in both domestic and foreign markets.
Presently, we are looking forward to even greater cooperation with overseas customers based on mutual benefits. Please feel free to contact us for more details.
1. Manufacturer Overview
||Shantou, Guangdong, China (Mainland)
|Annual Output Value
||US$2.5 Million - US$5 Million
||North America; South America; Eastern Europe; Southeast Asia; Africa; Oceania; Mid East; Eastern Asia; Western Europe
||ISO 9001:2008; RoHS Verification of Conformity; EC DECLARATION OF CONFORMITY
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||81% - 90%
|No.of Employees in Trade Department
||3,000-5,000 square meters
|No. of Production Lines
||OEM Service Offered
|Product Price Range
||High and/or Average