Q 1.Okorder Quality Control? We hold a very strict quality control system to check every connector of our products for
Q 2: How do you care for your kitchen appliances? A: Keep good Ventilation indoor. Open the doors of the kitchen appliances, if not. There
will be some mildew on cutting board and other kitchenware, because the water vapor can not
evaporate easily. Keep clean of all the appliances. Each kitchen has its special cleaning fluid，please go to
Kitchen cleaning stores buy some clean them on time.
Q 3: Which one do you use the most of kitchen appliances? A: Assuming you mean small appliances .I say too many! At one time we would buy every one
that came along; including a hot dog machine, pizza maker, elec. carving knife, elec.,
toaster oven,. Most have been garaged sale (sold) or are stored in the garage. Most used;
coffee maker, microwave, blender and mini food processor. OK?
Send a message to us:
Q:What are the components of a microwave dryer?
The energy leakage suppressor is arranged at the material inlet and outlet of the heater, so as to prevent the electromagnetic wave in the resonant cavity from leaking out and injure the human body
Q:What are the characteristics of a conduction dryer?
The surface temperature of the material can be from below freezing point (freeze drying) to 330 DEG C; it is easy to operate under pressure and inert atmosphere, and volatile solvent can be recycled
Q:What's the difference between freeze dryer, micro heat regeneration dryer, non thermal regeneration dryer and waste heat regeneration dryer?
Micro heat regeneration dryer - also called tepefaction regeneration dryer, 2 adsorption tower, every 2 hours to switch to a AB tower, A tower rotation adsorption, adsorption and regeneration tower B 2 hours 2 hours, whereas the B A adsorption tower adsorption tower regeneration is the water suction down air drying, but because of the adsorption so long as the regeneration to be heated to completely clean, renewable water is adsorbed to the water tower with its own air after heating
Q:What are the factors that affect drying effect of dryer?
In the air around the particles, the absorption of heat and the dispersion of water molecules to the surface of the particles require certain moments. Therefore, the resin supplier shall specify the time at which all the necessary drying of a material is dried at the proper temperature and dew point
Q:What is the principle of a spray dehumidifier?
When the temperature of the wet gas drops below the dew point, the steam condenses and reduces the humidity of the gas
Q:What are the characteristics of a convection dryer?
The quality of water vaporization units with energy conduction type dryer high end products, especially when moisture content is low
Q:What are the common types of fluidized bed dryers?
The fluidized bed is dried in accordance with the dry material and is suitable for granular material
Q:How to install the car air dryer?
Installation: vertical, sewage (gas) mouth down, the slope shall not exceed the requirements of product specifications
Q:What are the clogging problems in dryer?
After the compressor starts running for a period of time, the condenser is not hot, no air cooling is blown out, hand touching the dry filter, chills, condensation or frosting, and the compressor sends out a muffled and overloaded sound
Q:What is the cause of the dryer blockage?
The refrigeration system is not cleaned before assembly and welding.