Q:Do the rubber joint and Y filter need flange connection?

Rubber hose joints are usually externally threaded, and type Y filters are internally threaded and are directly connected to the same caliber.Flange connection also has ah, according to demand

Q:Access toilet water inlet hose joints, how to repair water?

You try to put the connector aside, hold some force in the toilet hole, or add a person to press it with your hand, then swivel the pipe joint and maybe open it.

Q:High pressure hose crimping connector, pressed on what position can effectively prevent the head off?

The amount of compression in the joint core or material needs to be improved. If the joint can not be changed, can try to head off premise, reduce the withholding amount, to avoid excessive damage to the hose wire crimping.

Q:What kinds of pipe joints can be divided into? What are the differences between the so-called one - piece pipe joint and other types of pipe joint?

Card sleeve type, welding type, flaring type, attached thread pipe joint, cone seal, flexibility, hand clamp, fast change, etc., the first three kinds are more used.

Q:What is the method of making large diameter rubber joint?

Method for making large caliber rubber parts:Mold making: external shell, internal steam box, steam, internal core, hydraulic cylinder do support (two years earlier, with Jack) and high strength rubber cord wrapped into the mould, after high-temperature steam curing, eventually forming.

Q:The rubber tube of the gas cooker is aging. It's leaking. Can you change it for yourself?

You see what your gas range is, it is best to go with a metal hose, the province later by the mouse bite. My father is quite understand, our family's Hengtong metal hose was changed just the year before last, it's really much better

Q:How to determine the tensile strength of GB rubber joint?

The cutting of sample can be done by punching machine. When punching sample, the following points should be paid attention to.The cutting force is uniform, not too large, and with mild soap and water and clean tap water wet specimens (or tools), if a sample cut down, it should be abandoned, not to repeat the old mark for cutting.The direction of specimen cutting should be consistent with the direction of tension and the direction of rolling.

Q:What glue can glue rubber tube?

Location: in the face and then drop a little sticky rubber JL-330 iron speedglue, immediately bonded, and keep to the hardening, hardening time ranging from a few seconds. About 30 minutes to reach practical strength, 24 hours after the maximum intensity.

Q:How about rubber transfusion hose?

Then the outer layer of glue in the extruder, type coating, and then wrapped with lead or sulfide protective layer can be.

Q:Flexible rubber joints. What do they mean by flexing?

Stainless steel bellows are not a kind of rubber joint.Flexure generally means that it can be bent repeatedly.The rubber joint mainly plays the axial and angular compensation displacement, and withstands the mechanical vibration, protects the pipeline not to burst.Stainless steel bellows can also be flexible, but the performance of vibration proof is better than that of rubber joints. If the requirements of the engineering drawings are rubber joints, it is better to be careful. Don't change it indiscriminately. Otherwise, the service life will be affected