Home Dehumidifier DX-958D 58L/Day
- Loading Port:
- Shanghai
- Payment Terms:
- T/T
- Min Order Qty:
- 2 Units unit
- Supply Capability:
- 3000 Units per Month unit/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
INTRODUCTION:
Dehumidifier of our company own such advantages of nice appearance, compact
structure and easy operation. It is widely applied to research and medical products,
commodity storage, underground project, kitchen, bathroom, archives, and warehouse
for dehumidification. With this dehumidifier, loss caused by damp, erosion and
corrosion of apparatuses and instruments can be prevented. The core part of desiccant dehumidifier is cellular structure desiccant rotor, formed by special ceramic fiber composite and silica gel. The rotor is divided into two area by a seal device, one is process area(dehumidification area), the other is reactivation area. When the dehumidifier is in operation, two streams of air pass through
two areas simu 14.4L/D 200M Desiccant Industrial Dehumidifier ltaneously
.
MODEL
FEATURES
1.30% efficiency more than other.
2.Silica gel molecular sieve composite dehumidification acrylic.
3.Proflute Rotor wheel, imported from Sweden.
4.Economical, energy-saving, and easy operation.
5.Error locator system. Low dew point conditions
6.Washable air filters help improve the quality of air in process air inlet and regeneration air inlet.
FAQ
Q 1.Okorder Quality Control?
We hold a very strict quality control system to check every connector of our products for
your safety.
Q 2: How do you care for your kitchen appliances?
A: Keep good Ventilation indoor. Open the doors of the kitchen appliances, if not. There
will be some mildew on cutting board and other kitchenware, because the water vapor can not
evaporate easily.
Keep clean of all the appliances. Each kitchen has its special cleaning fluid,please go to
Kitchen cleaning stores buy some clean them on time.
Q 3: Which one do you use the most of kitchen appliances?
A: Assuming you mean small appliances .I say too many! At one time we would buy every one
that came along; including a hot dog machine, pizza maker, elec. carving knife, elec.,
toaster oven,. Most have been garaged sale (sold) or are stored in the garage. Most used;
coffee maker, microwave, blender and mini food processor. OK?
- Q:What are the methods of use of the dehumidifier?
- The main characteristics of liquid desiccant: air humidity reduction range, at lower temperatures can also achieve good results. However, the concentration of hygroscopic agent should be adjusted in time, and the corrosion inhibitor shall be added with corrosion inhibitor to prevent corrosion of the equipment
- Q:What is the future development of dryers?
- The future development of dryer will be developed and improved in depth study of drying mechanism and drying characteristics of materials, and grasp the optimal operating conditions for different materials
- Q:What is the working principle of the dryer?
- The heat from the heat source in a variety of ways to wet materials, the material surface moisture vaporization and escape into outer space, thus the moisture content difference in the material surface and internal. Internal moisture diffusion and evaporation to the surface, so that the moisture content of the material continues to decline, and gradually complete the drying of the whole material
- Q:What are the components of a microwave dryer?
- The resonator, the heater, is a device that performs the interaction of microwave energy with the medium. The usual forms are case type, waveguide type, radiation type and surface waveguide type
- Q:What are the cautions in the use of dryers?
- Desiccant should not be placed too much so as not to stain the bottom of the crucible
- Q:What are the drying agents that are often placed in the dryer?
- Silica gel, montmorillonite, molecular sieve, mineral, fiber, activated carbon, lime and so on
- Q:What's the difference between freeze dryer, micro heat regeneration dryer, non thermal regeneration dryer and waste heat regeneration dryer?
- Waste heat regeneration dryer - as the name suggests, use other equipment or boiler heat to take over, will be heated again heating, in order to achieve better regeneration purpose, at the same time waste heat utilization to achieve energy saving purposes
- Q:When the automobile air conditioner is used, why is the dryer hot?
- The dryer is mounted behind the condenser and the compressor compresses refrigerant to produce a high temperature, high pressure gas into the condenser. A semi fogging refrigerant, which is cooled by a condenser to about 70 degrees, enters the dryer. So the dryer is very hot and hot
- Q:What are the common breakdowns in the automotive dryer?
- When the compression pressure reaches the required standard value, the exhaust valve D of the dryer can not stop under normal working conditions, indicating that the piston is caused by a foreign body, a strain or a dead card. The small piston and the sealing 0 ring shall be removed or checked or replaced promptly
- Q:What is the cause of the dryer blockage?
- The refrigeration system is not cleaned before assembly and welding.
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
Home Dehumidifier DX-958D 58L/Day
- Loading Port:
- Shanghai
- Payment Terms:
- T/T
- Min Order Qty:
- 2 Units unit
- Supply Capability:
- 3000 Units per Month unit/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Hot Searches
Related keywords