High-Voltage XLPE Insulated power cable

Ref Price:
Loading Port:
China Main Port
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
-

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

Specifications

1.up to 35kV available,factory direct sales
2. 20 years experience
3.OEM available provided

XLPE/PVC Insulated Power Cable  China Factory Supplier

Cable Construction

PVC Cable:

Cu(Al)/PVC/PVC Cable

Cu(AL)/PVC/SWA/PVC Cable

Cu(AL)/PVC/AWA/PVC Cable

Cu(Al)/PVC/STA/PVC Cable

XLPE Cable:

Cu(Al)/XLPE/PVC Cable

Cu(AL)/XLPE/SWA/PVC Cable

Cu(AL)/XLPE/AWA/PVC Cable

Cu(Al)/XLPE/STA/PVC Cable

Standard: IEC60502;BS5467:1997 with Amendment 1

Conductor: Soft annealed stranded copper wires to BS6360, class 2, concentrically stranded in successive layers, in opposite direction, to form the stranded conductor. Aluminum also available

Insulation:The conductor are insulated with a layer of extruded XLPE/PVC compound.

Filling:The assembled cable is filled with a layer of PVC compound in order to fill the interstices between the cores and render the cable round.

Armoring: Consists of single layer of Steel Tape/Galvanized steel wires of appropriate size.

Sheathing: An outer protection of extruded PVC compound is applied over the armor.

Voltage rating: 0.6/1kV,3.6/6kV;6/10KV;8.7/15KV;12/20KV;18/20KV;19/33KV;21/35KV;26/35KV

Operating temperature:

90 continuous normal operation, 130 for emergency overload condition and 250 for short circuit condition

Application:

For outdoor and indoor installations in damp and wet locations, laid direct in the ground where excessive mechanical stresses are present in sloping and moving terrains and in vertical or inclined laying, as well as in locations susceptible to sliding.

   

The data sheets below show partial  Type,Name and Application of  XLPE Insulated Power Cable:

Type Name

Application

Cu

Conductor

Al

Conductor

YJV

YJY

YJLV

YJLV

XLPE Insulated,PVC or PE S heathed Power CableFor laying in door,tunnel,channel and underground.Unable to bear external mechanical force,but bear the traction force during laid.

YJV22

YJV23

YJLV22

YJLV23

XLPE Insulated,Steel Tape Armoured,PVC or PE Sheathed Power Cable

For laying in tunels in door,tunnel,channel and underground.Able to bear external mechanical force,but unable to bear large pulling force.

YJV32

YJV33

YJLV32

YJLV33

XLPE Insulated,Fine Steel Wire Armoured,PVC or PE Sheathed Power Cable

For laying in shaft with large difference of level.Able to bear external mechanical force,and moderable pulling force.

YJV42

YJV43

YJLV42

YJLV43

XLPE Insulate,Thick Steel Wire Armoured,PVC or PE Sheathed Power Cable
Able to bear positive pressure and pulling force.

Packing:

  • In rolls for cables with cross section<10mm, wooden or iron drums for heavy cable in large quantity.

  • As per client's special request.

Our advantage:

  • 20 years professional experience since 1993

  • Better competitive price and standard quality.

  • Experienced engineering team work, latest tech R&D in cables.

  • Standardized qulity control and operation system under ISO9001-2008

  • Market-oriented management, OEM acceptable.


Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Yjv22 cable laying pipe when the casing with plastic or steel pipe
In the air defense regulations, the pipelines of the air defense zone need to be treated with the protective wing ring. The bridge frame is designed according to the cable laid in the bridge. The cable size and quantity determine the size and quantity of the casing. Increase the standby, air defense requirements casing with hot galvanized treatment, both sides of the exposed wall shall not be less than 100 mm, wing ring production can refer to rigid waterproof casing or flexible waterproof casing (explosion-proof). The general construction plans will have a clear sign, or should be presented to the Design Institute in the trial.
Q:How to connect the power cable pre-branch connector
In the pre-measured size cut out the jacket and insulation, according to the different cross-sectional size of the cable cut the size of the jacket and insulation different; with C-shaped tube corresponding to the corresponding color sequence crushing the trunk and branch lines, crimping attention to crimping The strength of the clamp, can not be too loose or too tight, too loose will cause the cable crimping off, resulting in open circuit, crimping too tight will break the conductor or cause the conductor stranded in the contact with a good conductor with polytetrafluoroethylene With the winding baking transparent, and then wrapped waterproof tape (tiger belt) can be used after the wooden hammer shrink the cable core to facilitate injection molding in the injection process should choose the appropriate mold and injection molding machine injection mold injection, the mold is too large cost Waste, the mold is too small caused by defective, bad seal at both ends of the running coke, affecting the injection effect
Q:Calculate the control cable under what circumstances the cable terminal needs to be calculated
" Why should the closed wall or protective wall closed on the second side of the closed junction box? This need to understand if you do not add this closed junction box, what kind of harm Civil air defense project in the closed wall is divided into the clean area and the area of ​​the infected area, and the wire tube in the thread after the inside is a cavity, directly through the wall to communicate with the cleaning area and exposed areas, so wartime works outside the dyeing The poisonous air can penetrate into the clean area through the cavity inside the wire tube, which is harmful to the personnel inside the project And the installation of a sealed junction box, you can thread in the line after the box filled with sealing material to block the tube cavity connectivity This is why the electrical safety pipe in the air defense project must pass the closed wall or protect the closed wall when the two sides must be closed in the closed junction box reasons
Q:150,120,95,50,25,10,4 * 1.5,2 * 1.5 how much cable to use the heat shrink tube
Hard drive is too expensive, not within thousands of dollars. 8 years to open shop experience Hotspot: 1.CPUG530 is i3's Lite, good performance, low power consumption, mainstream interface is. G530 integrated graphics chip, performance as much as ATI3000 series, Lu master test 30 points, equivalent to 200 yuan or so independent graphics card, alone was GT220 test is 60 points. 3. Motherboard is ASL, relatively old brand, this motherboard wiring and materials are good. 4. Xingyu Quan chassis work well, comes with power warranty for three years. Recommended configuration: CPUIntelCeleronG530 / bulk 1 ¥ 265 heat sink Jade Bird III25 yuan motherboard ASL H61U1 ¥ 299 memory KingmaxDDRG1 ¥ 70 hard drive Hitachi Deskstar7K1000.B320G1 ¥ 240 chassis Star Yuquan V ¥ 160
Q:"Cable laying" cable cross-sectional area refers to the cable cross-sectional area, or refers to the copper core cross-sectional area
What kind of clothes do you want to do? General to high-speed sewing machine, the most important three-line lock machine, hot Taiwan, such as a suit to buy a pressure machine, workstations
Q:PVC pipe line 6 points and 4 points which big ah?
Look at the chassis of the internal power supply is not connected to your power interface to see how many mouth ~ there is a 4-port square of the additional power socket to see there is no link that is what the link method is generally written on the motherboard ~ The word is a small look carefully ~ Corresponding to the chassis of the various plugs to see if there is no wrong plug (but the general can not start too much Gibel error) can be observed by the power indicator light (light) and observe the hard disk indicator Red (flashing) to determine the right or wrong line. There is only listen to the warning sound, the boot will be crisp ring, if there is proof of plug, there is no relationship in fact because there is no alarm, hdd hard drive, led + - white green two-wire power instructions, the above said three lines Do not plug can also be a normal boot, as long as it pw power plug can be a ~ rw restart does not affect the boot
Q:What is the radiation of the laser scanning scanner?
Semi-conductive shield The semi-conductive shield is usually disposed on the outer surface of the conductive core and the outer surface of the insulating layer, referred to as the inner semiconducting shield and the outer semiconducting shield, respectively The semiconducting shield is made of a semi-conductive material with a low resistivity and a low thickness Internal semiconducting shielding layer is to uniform the outer surface of the electric field, to avoid the conductor surface is not smooth and the core stranded by the air gap caused by the conductor and insulation occurred partial discharge The outer semiconducting shield is in good contact with the outer surface of the insulating layer and is electrically connected with the metal sheath to avoid partial discharge of the metal sheath due to defects such as cable insulation surface cracks For non-metallic jacket in the low-voltage power cable, in addition to the semi-conductive shielding layer, but also to increase the metal shield Metal shield is usually made of copper or copper wire wrapped around the main play the role of shielding the electric field
Q:Ask you a question: how the computer CD-ROM power supply 5V and 12V two lines? Another audio and video cable which group?
My computer --- right-click properties. Device Manager. Look at the USB device is not there or the number. Have to reinstall the system. Also make sure your motherboard USB interface is not good. I said the interface is plug USE jumper of the root.
Q:What is the difference between public relations firms and media companies?
The width of the cable bridge international standard: cable bridge width ≤ 150 ~ 1.0150 800 ~ 2.2
Q:What is the difference between the control cable and the compensation cable?
240MM copper cable can be, casing with DN150 load 473KW how current only 560A, a little do not understand, you are not wrong

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range