Quick Details Of High Quality Double Sided OPP Tape DSO-90Y:
|Name||High Quality Double Sided OPP Tape DSO-90Y|
|Size||1.02m x 1000m|
|Lead Time||30 days/20'|
|MinOrder||4 jumbo rolls|
|Package||packed with corrugated board|
PACKING Of High Quality Double Sided OPP Tape DSO-90Y:
Core I.D.: 3” (76mm+/-1)
Jumbo Roll：1.02 x 1000m; 80 rolls/20' without pallets
Packaging：Wrapped with corrugated cardboard.
Cut Roll: roll width 3mm up; several rolls in a plastic bag and then certain quantities into a carton, finally load cartons into container with or without pallets.
2. We could supply both white and clear adhesive on OPP film.
3. Different thickness is available according to requirements.
4. Special requirements will be satisfied after communications.
CONSTRUCTION Of High Quality Double Sided OPP Tape DSO-90Y:
Backing: white OPP film
Adhesive: Hot melt based
Liner: Silicone release PE-coated paper, white/light yellow color.
TYPICAL PHYSICAL PROPERTIES Of High Quality Double Sided OPP Tape DSO-90Y:
Thickness (BOPP film + adhesive): 90 mic±5 micron
Thickness (Release liner): 100 mic±5 micron
180° Peel Adhesion to steel: > 1.5kg/25mm (PSTC-1)
Tack rolling ball:<5 cm/14# (PSTC-6)
Holding power: >5 hrs/25mm (PSTC-7)
- Q:I would like to ask Heroes: I would like to register trademarks, double-sided tape
- Typewriters and office supplies (excluding furniture), educational or teaching activities (except apparatus), plastic materials for packaging (not included in other classes), printing plate.
- Q:How do you apply double-sided adhesive tape?
- 4. The joint of the double adhesive tape should be staggered with the joint of the plate;5, with adhesive tape, it is best to use rubber scraper, in a parallel sweep way, the tape evenly affixed to the roller, in the tape and the roller can not leave the bubble; (if the bubble retained, the application needle punctured)6, in determining the location of the printing plate, should avoid the printing plate and tape premature contact, to determine the printing position, remove the tape protection layer, the plate with rubber roll, in parallel with the way on the adhesive tape;
- Q:Double sided tape how to cut it, master with automatic cutting table cut out
- Two, aspects of the tape of the material itself may be a problem, some of the material almost cut when the effect is not too good, will play a flash, or volume, complex will also affect the cutting effect, to spread the trouble, in addition, mechanical equipment has great influence, we are do the cutting device, cutting time, feed speed is that, because the first two are no problem, good automatic cut several section of cutting speed, feed, cutting, cutting paper and so on, if not cut it, only one speed in, too may the flash, uneven cut
- Q:How much is the two-sided adhesive tape for industrial use? How to choose?
- There are dozens of tapeThere are too many kinds,I don't know what you're talking aboutTape or?. TapeTwo or three dollars, one.
- Q:What is sponge double face glue?
- Different sponge base material characteristics are different, the coating of glue, most of them are acrylic, because acrylic aging resistance, good and cheap. PE PU, PVC sponge, foam, acrylic, different characteristics are not the same, for example, high temperature, chemical solvent resistance, UV resistance, soft foam itself is different, there are differences between fire, open and closed, a lot of different characteristics
- Q:How to clean the foam double-sided adhesive?
- 1, wipe the face oil coated, and wipe evenly, first use the nail to cut him off, and then take a wet towel, wipe off.2, use the hair dryer blow, the glue baking heat can be got down.3, with Fengyoujing rub, then dropped.
- Q:How to remove the remnants of double-sided adhesive left?
- Very simple, buy a roll of transparent adhesive, adhesive tape will do, paste you have double-sided adhesive place, and then put it after tearing, repeated a few times you can stick it offThis is a very good method, very simple and practical, easy to save trouble. I used, good, support
- Q:Will the double faced adhesive damage the wall?
- Traceless double-sided adhesive, since there is no trace, it will not damage the wall.Double sided tape is made of paper or cloth, plastic film substrate, then the elastomer pressure-sensitive adhesive or resin adhesive coating made in the substrate of the roll type adhesive tape is composed of base material, adhesive, release paper (film) is composed of three parts.
- Q:What about double white, white and yellow?
- The length of the screw should be fixed according to the depth of the object and the depth of the plug. Not necessarily longer than the plug, but there should be a certain depth in order to achieve fixed results;
- Q:Cement floor floor leather with thick or thin double-sided adhesive
- Usually carpet affixed with thin mesh adhesive tape, if a short time to paste, it is recommended to use "Shanghai Yu Guang 9447R double-sided adhesive tape" removed,
We were built in 2004. With over 9 years of experience. We now have become a professional enterprise with excellent product development capability, state-of-the-art manufacturing facilities, and a dedicated sales and marketing team. We have over 5 state-of-the-art production lines for BOPP tapes and more than 4 production lines for masking tapes.
1. Manufacturer Overview
|Annual Output Value
||Above US$ 1 Million
||25.00% North America
15.00% South America
20.00% Eastern Europe
10.00% Northern Europe
15.00% South Asia
15.00% Western Europe
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||15% - 20%
|No.of Employees in Trade Department
||Above 6，000 square meters
|No. of Production Lines
||BOPP tape，PE foam tape, EVA foam tape, cloth tape, masking tape, PET tape, packing tape,double sided tissue tape，
|Product Price Range