Q:Wash basin basin faucet how to do, the handle joints leak

It is basically the faucet inside the seal is broken, it is recommended for a new faucet!

Q:New to buy the faucet and bathroom basin does not match, feel some water leakage how to do?

A few days ago to the building materials market, saw some attachments, seven seven eight eight plus a lot of money, and do not underestimate these accessories, if the quality is not good, the future may have infinite trouble.

Q:I got a new faucet with sink and the faucet is not positioned over the drain, also water cloudy. Kindly advise...

It doesn't matter where the faucet is positioned as long as the water goes into the basin. The cloudy water is probably the result of air in the waterlines from being turned off to install the faucet. It will go away. Another reason could be if you didn't have an aerator on the previous faucet and you are now noticing the air that is put into the water.

Q:Kitchen pots hot and cold faucet water hose connector how to unscrew? Nuts in the deeper position of the valve body, wrenches and stretch does not go, hand screw is not OK, too tight. Is the faucet with the hose connection joints, can only cut? Leading water leakage to change it. What tools are there?

First connect the hose and the angle valve with a wrench. And then move the handle in the direction of rotation, that is, to screw the direction of rotation, which is the faucet below the nut will be loose, holding a rag, into the pool below, touch the faucet nut, you under the nut. When the faucet will pull out the whole, and then I would not have to say it! The

Q:The position of the leading hole in the basin

Look at what kind of pots and faucets you buy. The principle of opening the faucet dripping dripping in the basin, the water can not be sprayed to the largest basin. But also with the smooth.

Q:Faucet with the basin of the screw how to take, no position wrench no place to put, hand and twist fixed

Can be stretched into the kind of building materials to wear the supermarkets are sold if you do not understand to add my buckle

Q:Is the basin faucet to the angle valve?

Can not do, installed the angle valve, then easy to repair the tap point, directly off the angle valve can be off the water, and no angle valve can only go to the total gate

Q:How do you competely shut a leaking faucet?

I'm not a plumber, but I think if you want to completely shut a leaking faucet, you have to make sure that the faucet is screwed on real good.....if it still leaks....then the screws are stripped, and you will need NEW screws for your faucet.....or you will need a NEW faucet....one or the other.

Q:What is the size of the faucet mounting hole in the sink basin?

The mounting hole of the standard mounting table should be 35mm in diameter.

Q:I've never had one placed there. Are there any pros or cons?

Some sinks are made for faucets to go to one side or another. Offset sinks have a smaller bowl on one side. This is helpful if you have limited space for the faucet. Just make sure your faucet comes out far enough to reach both bowls or has a pull out sprayer. I have and offset with a sprayer faucet and it has been working fine for me. Here are links to show you what I mean.