Q:The wireless network signals received by the computer are weak. Can the central repeaters be enhanced?

Repeaters (Repeater) work at the physical layer of the OSI, the center of all nodes on the LAN, which amplifies signals, compensates for signal attenuation, and supports remote communications.

Q:What are the differences between switches and repeaters, and what are the common functions?

Repeaters are designed to solve this problem. It completes the connection of the physical circuit, amplifies the attenuated signal and remains the same as the original data. In general, both ends of the repeater are connected to the same media, but some repeaters can also do the switching of different media. In theory, the use of repeaters is unlimited, and the network can therefore be indefinitely extended. In fact, this is impossible, because the network standards are specific to the delay range of the signal, the repeater can only work effectively within this set of regulations, otherwise it will cause network failure.

Q:What does the subway rep repeater mean?

Increases the maximum number of nodes.Each segment can use different communication rates.Improved reliability. When a network fails, it usually affects individual segments only.Performance has been improved.The disadvantage is that the relay increases the delay when the received signal is restored (restored) to the state at the time of transmission.The MAC sublayer of the CAN bus does not have the flow control function. When the load on the network is very heavy, it is possible to overflow due to insufficient storage space in the buffer in the repeater, resulting in frame loss.If a repeater fails, it will have an impact on the work of the two adjacent subnets.

Q:What is often referred to as' repeaters' in network communications?

In fact, there are many names of devices that usually act as repeaters in network hardware devices. For example, active hubs (multi port device active Hub LAN transmission signal amplification) of the "active" (active regeneration) relay center although sometimes also called multi port repeater, but more commonly called repeaters (Shu Niu).

Q:How do you build bridge repeaters with Tenda and fast routers?

Home network cabling:1, there is a telecommunications cat: Telecom cat ---- router WAN port; router LAN port ---- computer;2, did not get Telecom cat: Cable ---- router WAN port; router LAN port ---- computer;

Q:What is the difference between a WiFi signal amplifier and a wireless repeater?

Operational amplifiers are widely used devices. They are connected to an appropriate feedback network and can be used as precision AC and DC amplifiers, active filters, oscillators and voltage comparators.Repeater: OSI (Repeater) works on the physical layer of the network. It is the center of all nodes on the LAN. Its function is to amplify the signal, compensate the signal attenuation, and support long distance communication.

Q:The mobile phone connection repeater always shows that the IP is not connected

1, determine the line router, set the proper connection2, determine 1 no problem, restart the router, cell phone, router or mobile phone DHCP service hang up

Q:My routing repeater, I want to hide my hot spots, hide ssld, show this

It doesn't matter much, because WPS is sometimes not safe and people can run pin code to crack it

Q:How do Apple phones act as WiFi repeaters?

The use of mobile phone or computer to be relayed to the wireless router, wireless router TP-LINK for example, enter the router settings page, view the running state of the router, the router has to ensure network, if the router does not relay network, the wireless relay is also unable to access to the internet.

Q:What are the differences between a bridge and a repeater?

1) data link layer, the two local area network (LAN) together, according to the MAC address (physical address) to transmit the frame, can be seen as a "low-level router" (routers in the network layer, such as the network address IP address forwarding).2) it can effectively connect two LAN, restrict the local communication to the network segment, and forward the corresponding signal to another segment. The bridge is usually used to connect the same type of network segment with a small number of connections.3) bridges usually have two categories: transparent bridges and source routing bridges.