Order On-line Tracking
1.Description of Gasket :
This results in alternating layers of filler and metal. The filler material in these gaskets acts as the sealing element, with the metal providing structural support. These gaskets have proven to be reliable in most applications, and allow lower clamping forces than solid gaskets, albeit with a higher cost.
This gasket is formed with stainless steel 304/316 and graphite,non asbestos,ptfe or other seal material. It is the best gasket for muffler pipe or flang gasket.
It could be standard style,it just formed stainless steel and graphite or non asbestos etc.
2.Features of Gasket :
• Strong stress compensation,stable and reliable sealing performance even under frequent pressure fluctuation condition.
• Perfect sealing performance.
• Normal requirement of flange surface finishing which contact with gasket.
• Easy installation and low pre-tightening stress of gasket.
• Food processing industry.
• Hot acetic and citric etc.
Wound style gasket consists of four type:basic type,with inner ring,with outer ring,and with inner and outer rings. B.Heat exchanger wound style gasket:basic type and with inner and outer rings.
4.Specifications of the Gasket:
1. Material:Stainless steel, PTFE, graphite, Carbon steel
Inner by the plastic bag, outer by the carton; or as the customer's demands.
1.A good compression ratio and elasticity.
2.With plastic appropriate, after pressing can adapt to the sealing surface and sealing surface uneven fill the gap, to ensure good sealing performance with the temperature and pressure in the system of alternating case.
3.Have sufficient strength, when external load conditions, not be crushed; at high temperature, not blown out.
Ask 1: Why some supplier give me the price much cheaper than you?
Answer:1.They wanna attract your attention,while you contact with them,they would raise the price by any reason.
2.They willn't provide the high qualities to you cause it had the cheap price.
Ask 2:What the MOQ?
Answer:The MOQ should reach 800 kilograms
Ask 3:Should i pay for it If some product need molds?
Answer:I'm afraid you should pay for it,However,We would return it back when we get the first order.
Ask 4:What's the delivery circle times ?
Answer:About 2 weeks and we would give the accurate time when we know the quantity.
Ask 5:What's the FOB port?
Anser:Our port are Shanghai and Ningbo usual.
Ask 6:Your price seems higher than others.
Answer:As you know,Price equals qualities.We have faith in our qualites.But it must be in the acceptable range
1. Manufacturer Overview
|Annual Output Value|
2. Manufacturer Certificates
|a) Certification Name|
3. Manufacturer Capability
|No.of Employees in Trade Department|
|No. of Production Lines|
|Product Price Range|