For Whole Sale Bopp Packing Tape 50micron

Ref Price:
Loading Port:
China Main Port
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
-

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

CONSTRUCTION:

Carrier: BOPP film

Adhesive: Water based acrylic adhesive.

TYPICAL PHYSICAL PROPERTIES:

Total Thickness (adhesives + carrier): 50 ± 2 um

Initial Tack (11mm steel ball): ³ 18#

180O Peel Adhesion (to steel): ³ 0.5 kgf /25mm

Holding Power: ³ 24 hrs

Tensile Strength: ³ 30 N/cm

Elongation: 180%

PACKING:

Core I.D.: 3” (76mm±1)

Jumbo Roll1280mm x 4000m

Cut Roll: As per customer’s requirements

Application:

Carton sealing & packing, Light duty packaging, bundling, holding, and other office & household use.

REMARKS:

1.     The data above are typical results and subject to change without notice.

2.     Tolerance: Weight and Thickness: ±10%; Width: ±3mm;

Length: Cut Roll & Log Roll ±0.3m, Jumbo Roll ±0.5%.

3.     The products should be stored at room temperature and be kept away wet and/or heat source.

4.     It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied must be clean, dry, and free of grease and oil.

5.     The users should take test and do trial-application on the above products before coming into application so as to witness and ensure suitability for their special purpose and technique.

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Flexo printing tape, what are the common, what are the advantages and disadvantages?
3 application noticeFor the foam adhesive tape, the effect of the binding process depends on every process of the printing process. The correct use of the adhesive tape can greatly improve the printing quality of the flexo printing. Therefore, in the use of foam dip tape, should pay attention to the following points.(1) the temperature has a great influence on the application of the adhesive tape, so all the operations of the adhesive tape should be carried out at room temperature, so as to avoid the adhesive force of the adhesive tape due to temperature.(2) the surface of a printing plate and a printing cylinder (or a binding plate sleeve) shall be kept clean before printing. This is because dust, rust, ink and other dirt will damage the adhesive force of the adhesive tape, resulting in poor printing plates, and the emergence of warped version. Clean plates and pasted sleeves should be subject to high concentrations of alcohol because other chemical solvents may cause corrosion to the plates and to the mounting sleeves.
Q:Sealing tape sales skills and knowledge, please explain to professionals! Help, please
Sales strategy.What do you sell in the sales process?Answer: myself1, the world's first car sales Jo Gilad said: "I do not sell my Chevrolet car, I sell myself."";
Q:Selection of tapes
For colored tapes, how to distinguish between good and bad? For the colored adhesive tape, it is usually yellow and khaki. Will be sticky, pinched, and then quickly opened, you can pull one side of the adhesive off, you can see the purity and transparency of the original film. You can also look at the thickness of the glue. If no glue is pulled or pulled apart, there's a lot of impurities in it, and the glue has no cohesion. Two is too much moisture, has been volatile, at this time, the tape has already dropped a lot of adhesive force, feel can distinguish. In fact, there are many ways to distinguish between good and bad tape, as long as the life of more attention, you can distinguish between good and bad adhesive tape.
Q:Why should the sealing tape of the packing outer box be sealed with the word "worker"?
Then a new one, according to the above (the specified maximum stacking layers * 1.5) integer layer digital on the product box, standing for 4 hours. If the two experiments are not so that the outer box breaks, your carton is in line with the requirements of the. Note: because there is no standard at all, it represents only personal views, but personal experience.
Q:What is the profit margin of the transparent tape for packaging?
Factory profits higher, up to 20%, but the pressure is more severe, dealers only 3%-7%, payment is generally cash.
Q:When the box is sealed, the tape is very noisy and very harsh. What shall I do?
General adhesive tape is a taste, the size of the taste depends on the formula of glue, low molecular weight content, taste will be larger, once adhesive tape, it has a very small taste tape, we have been using.
Q:How does the sealing tape judge its viscosity?
Adhesive tape testing methods are mainly1, tack: the test tape is stuck to the initial ability of the adherend size, general method is to use the standard ball into the natural roll tape 45 degree angle on the tilt, increasing the size of the ball, the ball can stick to the greater, the greater initial viscosity
Q:Is the insulating tape waterproof?
Similar to plastic, it's waterproof. But it's insulated, too
Q:How can I use the belt cutter? It's the cutter for sealing the tape.
But do not attach the tape to the sealing machine and put it away. There is no machine, or else let you have a look
Q:Has anyone done a tape cut? What about profit?
I do not know where you belong, but the overall profit is not high, if it is sold to dealers, profits are generally 2.5 to 3 cents a square or so (not deducted from the cost)

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range