Q:What is the density of plywood?

usually with odd-level veneer, and the adjacent layer of veneer Of the fibers are perpendicular to each other.

Q:Further processing of the plywood

veneer plywood overlaid plywood. Plywood plywood, wood, paper, impregnated paper, plastic, resin film or sheet metal plywood.

Q:What are the processing defects of plywood?

Patched Plywood Repaired plywood Defects Plywood that has been repaired with a filler or veneer patch.

Q:One of the commonly used materials for furniture is a wood-based panel

With the veneer after the wood by the direction of the criss-cross the composition of the slab, heated or not heated under the conditions of suppression

Q:Ordinary plywood is divided into four categories

Wood fiber or other plant fiber as raw material to be pressed into a density of 0.50 ~ 0.88g / cm3 plate

Q:What is the amount of construction works used for this plywood?

The second type of plywood is water resistant plywood, can be immersed in cold water and short time hot water immersion;

Q:The difference between the multilayer board and the plywood is as follows

Commonly used plywood, plywood and other multi-layer board. Multilayer boards can improve wood utilization and are a major way to save wood

Q:The basic principle of plywood

but the symmetrical center plane in any two layers of symmetrical veneer on both sides and the same thickness. The panel does not allow the same species.

Q:Commonly used plywood, pallets and so on

Is the destruction of the physical properties of the wood itself, which played a leading role in the composition of the plastic

Q:Multilayer plywood with what method is fixed

Plywood is cut from the wood section into a veneer or cut from the wooden square cut into thin wood, and then made of adhesive glue from the three or more layers of plate-like materia