Q:How do I remove glue on paper?

Well, believe that your idea is to ensure that the newspaper intact, can try to use the hair dryer blowing warm air will soften it, gently rub, stubborn soft blowing

Q:How do you apply double-sided adhesive tape?

7, in the printing process to clean the printing plate, should avoid cleaning solvents, contact tape, so as not to damage the tape;8 when the plate is removed from the tape, the angle between the plate and tape shall be no more than 90 degrees.9, the interface version of the place to stay 5mm or so, the use of 3M 1600 electrical insulation tape seal version of the effect is good, you can effectively avoid wiping the plate caused by the interface version of the resulting ink pollution, and very economical.10, double-sided adhesive over repeated use can produce overprint bad phenomenon, especially in the new situation, and used for a long time in registering are likely to happen.

Q:The advantages and disadvantages of the mesh double sided adhesive tape, and the influence of the density of the mesh on the adhesive tape.

What material should be divided into mesh adhesive tape, the substrate is different, advantages and disadvantages are different, the main use is also different.

Q:Construction method of butyl adhesive tape

The joint of profiled steel sheet and cement wall is leaking(1) remove all the original silicone glue from the profiled steel sheet and the cement wall joint;(2) and then press the steel plate and cement wall joint clean; requirements of cement metope can not rise sand, there isConditions should be painted base treatment agent.(3) the joint of the metal plate and the cement wall is adhered with one side aluminum foil, and the Yongxing adhesive tape is pressed and repaired according to the orderMake the Yongxing adhesive tape of the single face aluminum foil bond firmly at the joint.(4) daylighting board roofing construction method.

Q:The double-sided adhesive thickness 0.05~3mm, similar to A3, the A4 paper size? One by one?

You can cut, but the product is generally sandwich, two pieces of paper from the double-sided adhesive.

Q:The foam on the wall will not tear off the double foamIt is convenient to ask for a rib

4, you can try a rubber. But in the beginning may feel more and more dirty, but rub a little longer, you will see the effect, this method is relatively tired, have perseverance.5, with blisters, put a little detergent, and then brush with an old toothbrush just fine.6, with a cloth with alcohol or Erguotou wipe.7, with a letter of sodium and water a wipe off, or can also use paint thinner.

Q:What is an engraving tape?

2., the use of rubber synthetic glue, viscosity more durable, to ensure the stability of the engraving plate, to ensure the accuracy of engraving3. rubber system glue, more temperature, suitable for four seasons, never degumming, scrub free,

Q:How to fill in the property when releasing adhesive tape?

Hello! At present, there are many kinds of adhesive tape on the market (such as sealing tape, printing adhesive tape, double sided adhesive tape and stationery tape,

Q:The door frame is glued on both sides of the curtain. Now the curtain doesn't work. It can't be cleaned on both sides. How can it be removed? But it doesn't break the paint on the door It's a little bit on the wall, too.

2, with cotton swabs stained with alcohol, wipe in the doorframe double adhesive position, repeated wiping, because alcohol evaporates quickly, see no, wipe again.

Q:How to remove the double adhesive on the tile completely?

1, with soap and a little ammonia and turpentine mixture, you can remove a lot of dirt, and make the glass surface more gloss (this applies to tiles, ceramics, glass, etc.).2, with sticky good transparent glue repeatedly sticky tear, you can remove some of the surface