Q:Water heater hose 4 points and 6 points difference

4, in charge of and 6 in charge, from the caliber is obvious to see out, 6 in charge of greater than 4 in charge. Inside diameter 4 inches, have 13.2 millimeter about, 6 inches are 19.8 millimeter, 6 inches of pipe than 4 inches big. 6 points in diameter 1.6cm, 4 points in diameter 1.2cm, see thickness can be distinguished, 4 branch pipe diameter is 20mm, and 6 points water pipe diameter is 25mm, general heating with 6 points, slightly thick. The tap water is 4 inches fine.

Q:Why should the high pressure hydraulic tube peel off the outer skin?

High pressure hose is generally relatively thick, there are steel wire layer, the purpose of peeling is to connect the tooth and steel layer close combination, the joint is more solid. But not all high-pressure hose needs peeling. Now many large companies do not need peeling. For example, pike.

Q:Production process and raw material of rubber

Process selection: the tensile strength is the limit ability to characterize products can resist tensile failure. The main factors affecting the tensile strength of rubber are: the main valence bond, intermolecular force and polymer chain flexibility of macromolecular chains.

Q:Hydraulic hose joint configuration

Self locking hose joint: a new type of hydraulic transmission, simple chemical package, easy maintenance and improved applicability. It has the advantages of convenient assembly and disassembly and wide adaptability. It is widely used in connecting all kinds of hose.

Q:Which is better for binding files with rubber tubes and cotton threads?

In fact, the most suitable binding file is the file department I twine, such units are preserved, just to have you asked, hope to adopt

Q:What is the rubber sleeve flange connection sleeve?

Ram direction of motion perpendicular to the direction of the fluid, valve can only be fully open and fully closed, can not be adjusted and the throttle valve flange. Gate has two sealing surface, the most commonly used mode gate valve of the two sealing surface to form a wedge, wedge angle with valve parameters vary, usually 50, medium temperature is not high when 2 degrees 52'. Wedge gate valve can be made into a whole, called the rigid gate; can also be made to produce micro deformation of ram, in order to improve its process of deviation, make up the sealing surface angle in the process, the gate is called the flexible gate.

Q:Must the hose for the cooker be made of oil resistant rubber hoses?

Yes, the rubber hose link range is required for oil resistance, because of the smoke in the kitchen, a long time will be attached to the rubber pipe, if it is not oil resistant hose is vulnerable to corrosion, resulting in a safety hazard.

Q:What kind of material does hose screw protection cover have? What are their advantages and disadvantages?

Hose cover is usually made of nylon or polyethylene

Q:What does rubber soft joint "KDTF" mean?

Rubber flexible joint KDTF is a flexible single ball rubber joint.

Q:Is the rubber pipe joint installed in the middle of the pipe and pump for shock absorption?

According to the pumping station environment, the noise source is not close to the pump house for sound insulation treatment, the noise of the pumping room will be taken sound absorption / sound insulation treatment, doors and windows should do sound insulation treatment, and so on.