FAQ Q 1.Okorder Quality Control? We hold a very strict quality control system to check every connector of our products for
Q 2: How do you care for your kitchen appliances? A: Keep good Ventilation indoor. Open the doors of the kitchen appliances, if not. There
will be some mildew on cutting board and other kitchenware, because the water vapor can not
evaporate easily. Keep clean of all the appliances. Each kitchen has its special cleaning fluid，please go to
Kitchen cleaning stores buy some clean them on time.
Q 3: Which one do you use the most of kitchen appliances? A: Assuming you mean small appliances .I say too many! At one time we would buy every one
that came along; including a hot dog machine, pizza maker, elec. carving knife, elec.,
toaster oven,. Most have been garaged sale (sold) or are stored in the garage. Most used;
coffee maker, microwave, blender and mini food processor. OK?
Send a message to us:
Q:What are the components of a microwave dryer?
Waveguide device is completed microwave transmission, interconnection, coupling and reversing transmission effect of microwave heating, often with long hollow metal tube section. Excitation and coupling effects of the waveguide device are required to set up the electromagnetic mode in the waveguide. Another non reversible transmission device is used for circulator connect the microwave source of the resonant cavity, when the resonant cavity for the material can not absorb all of the microwave power, part of the reflected power through the circulator into a terminal of the load, in order to protect
Q:How do I choose the dryer?
Operating performance and economic index of dryer
Q:What is the working principle of a commonly used fluidized bed dryer?
The bulk solid material by the feeder into fluidized bed dryer, filtrated clean air is heated by the blower into the fluidized bed at the bottom of the distributing plate in contact with the solid material, the formation of heat fluidized gas solid exchange reached
Q:What are the methods of use of the dehumidifier?
Ventilation and humidity reduction: it can send air into the room which is lower than the indoor air and the humidity is high, so that the humidity can be eliminated. The purpose of ventilation and humidity reduction can be achieved. Its disadvantage is that it can not adjust the indoor temperature
Q:What are the remarkable characteristics of CMD membrane dryer?
A more reliable and economical drying compressed air can be obtained
Q:How to install the car air dryer?
Installation location: away from the heat radiation source, well ventilated, close to the gas road system, the first use of gas tank, drying tank top should leave 30 ~ 50mm space, in order to replace desiccant
Q:What is the working principle of the dryer?
In the drying process, the heat and mass (wet) transfer are needed to ensure that the material surface is wet and the vapor partial pressure (concentration) is higher than the wet steam partial pressure in the outer space, so that the heat source temperature is higher than the material temperature.
Q:What are the factors affecting the dryer?
In the dryer, the wet air is removed first so that a very low residual moisture (dew point) is contained. The relative humidity is then lowered by heating the air. At this point, the steam pressure of the dry air is low. By heating, water molecules in the particles escape from the bond force and diffuse to the air around the particles.
Q:What are the characteristics of a Dielectric dryer?
Dielectric heating is used in food and light industry because of its high energy consumption
Q:What is the cause of the dryer blockage?
The refrigeration system is not cleaned before assembly and welding.