Coolant Automotive Rubber Hose for Gas and Oil
- Loading Port:
- Tianjin
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1000 pc
- Supply Capability:
- 1000000 pc/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Product details
Basic Info.
Model NO.:1/4"-12"
Material:Nitrile Rubber
Color:Black
Capability:Rubber Oil Hose
SAE Standard:ID From 6mm to 127mm
DIN Standard:ID From 6mm to 127mm
API Standard:ID From 51mm to 152mm
Export Markets:Global
Product Description
High Pressure Rubber Hose
CONSTRUCTION:
This hose consists of an inner tube of oil synthetic rubber, mutipule wire braid or spiral as reinforcements, and an oil and weather resistant synthetic rubber cover.
APPLICATIONS:
Hose range suitable to carry hydraulic fluids such as glycol, mineral oils, fuels, lubricants, emulsion, hydrocarbons etc.
WORKING TEMPERATURE: From -40° C up to +100 ° C
Standard: SAE, DIN, API, GB/T3683, GB/T10544 GB/T24145
This is the intercooler intake hose, which contains the material silicone and fluorine. The inner tube
uses the FKM and the outer one with the VMQ. The reinforcement is aramid.Our products are well produced and we have done such test programs:
1)Test items:Performance
2)Hardness:60±5 Shore A
3)Tensile strength:≥12Mpa
4)Elongation:≥200%
5)Burst strength:≥1.0Mpa
6)Adhesive strength:≥3.0KN/M
7)Pulse capability:The inner temperature190
- Q:Where is the rubber gasket in the door handle of the K3?
- The best is two times of infusion, and should not go together, because cephalosporins itself after dissolving the stability is relatively poor, so in preparation is made of powder, now equipped with, after the dissolution is immediately placed infusion, the longer the stability and drug decomposition rate is high.
- Q:General car ordinary car had a puncture can continue to open it, most can run far?
- The tyre is not recommended to continue under low pressure. (please check the cause of the tire depression; for example: nail sticking, cutting, rubber aging, cracking, etc.).
- Q:3M window lubricant reducer and car seals, maintenance cream which good?
- First clean. If you don't clean the car's seal ring for a long time, there will be dirt in the car sealing ring, groove and slide rail, which will affect the sealing effect of the automobile sealing ring. Owners are advised to clean the seal every one or two quarters.
- Q:Could you tell me how to remove the glue mark on the door of the car?
- So the adhesive composition can use hair dryer heating and then wipe cloth, or use solvents to dissolve the glue, like wind, gasoline and automotive beauty inside the peptizator etc..
- Q:Full coverage of car mats that kind of material better?
- The fully covered floor mat is developed on the basis of large surround and is now the most popular car floor mat. Fully enclosed mat Market, the use of synthetic leather or microfiber skin, natural rubber synthetic PVC, natural environmental protection synthetic rubber XPECommon automotive full cover mat materials are leather, rubber, VSQ, PVC, environmental protection, XPE and super fiber skin.
- Q:Ask the construction principle, under the action of the ball and dust cover
- The cover is made of thermoplastic elastomer thermoplastic rubber dust, also known as, is a polymer alloy material between rubber and thermoplastic between ball and dust on the axle, when the cover is cracked or damaged when there is dust and grease leakage.
- Q:What are the categories of rubber products, rubber raw materials and rubber products?
- Hose type: pure hose, clip fabric hose, cotton woven hose, steel wire braided hose, steel wire winding hose, suction hose, etc..Tape products: rubber boat, lifeboat, vest, diving suits, anti wear, resistance to acid rain coat, ray clothing, lifting bag, storage water heater, air duct, inflatable, inflatable bed, raincoat, aircraft fuel tank.Rubber shaft roller: all kinds of plastic shaft, printing rubber roller, printing and dyeing rubber roll, paper, rubber roll, etc..Cable wires: all kinds of cables and wires made of rubber.
- Q:What are the patterns of electric tyres?
- The three most important functions of tread patterns are: lifting grip, noise reduction and increased drainage. However, these three are in themselves contain each other, or even conflict, it is impossible to reach the so-called "excellent match."". Therefore, tire manufacturers in tread pattern design, it is necessary to each tire according to different product positioning, research and design of different pattern design.
- Q:Does automobile rubber mat cause harmful substances when heated?
- Is usually made of polymer material, called a PVC soft flat bottom, because the polymer adsorption ability, can play a non slip effect.
- Q:The car tire is pressing on the stone, the rubber of the tire is all broken, the heroes see can still use?
- After repair, can also be used, but because of the roadside repair shop rubber quality uneven in quality, some tire repair shop in order to use the cheap inferior rubber strip, the thinner, the service life is short, prone to slow leak, strip off. Therefore generally do not recommend using this method.
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
Coolant Automotive Rubber Hose for Gas and Oil
- Loading Port:
- Tianjin
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1000 pc
- Supply Capability:
- 1000000 pc/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Related keywords