Q:What is the density of plywood?

With the veneer after the wood by the direction of the criss-cross the composition of the slab, heated or not heated under the conditions of suppression.

Q:What are the plywood specifications?

structure. The texture of the adjacent veneer should be at right angles; the center layer is symmetrical with respect to the center layer, and the thickness of the layers is the same;

Q:For the plywood environmental advice?

Phenolic glue: moisture, excellent resistance to boiling, weather resistance / can be used for outdoor or indoor, can withstand outdoor wind and rain.

Q:Plywood in the decoration works how to use

The number of layers is generally odd, and few are even. Vertical and horizontal direction of the physical and mechanical properties of small differences.

Q:Why is the plywood commonly used in the singular layer

and take a vertical put a then put the plastic in the horizontal put a then In the vertical put a piece into a plywood

Q:What is the general use of plywood in decoration works?

Plywood is cut from the wood section into a veneer or cut from the wooden square cut into thin wood, and then made of adhesive glue from the three or more layers of plate-like material

Q:Multilayer board, also known as three plywood and plywood

different layers of different names. According to the thickness of 3-9 cm, can also be called 3-9 PCT board

Q:The basic principle of plywood

First, symmetry; Second, adjacent layers of single-board fiber perpendicular to each other

Q:What are the defects of the plywood?

dead dead knots formed by the dead branches of trees, knots surrounded by the surrounding wood together, or even only part of the length of its cross-section of the length of about 1/4 or less than 1/4 , Texture hard or soft, and sometimes fall off the formation of empty.

Q:What is the type of plywood editing?

In order to make full use of forest resources to develop plywood production, make the best use of our country's newly developed national standards (draft approval) according to the use of adhesive pull