Q:Using ordinary household materials can be, glass used hollow ordinary glass, doors and windows a total area of 45 square meters. Want to give a list.

Landlord is to open the window or sliding window? Recommended on the first floor with a sliding window, more than 2 floor with a flat window, because the first floor with a flat window if it is not very high window it is easy to hit people, it is recommended sliding window, Better, open space, you can also install screens and anti-theft network. Sliding window ordinary double glass price, 1.1 of about 250 to 280 or so, the high-end place to do so it is estimated that even plus 50 yuan or so. We are here to receive a single at least 350 or so will do, of course, but also to consider whether your window is easy to do, to the corner of the production will be more difficult, it is recommended to use 1.4 material window, the price is about 50, Do the door. Flat window, then the mainstream of the 50 window is better, this is easy to do where, but individuals do not like the ordinary 50 windows, basically the price and the difference mentioned earlier, may be more expensive. In fact, this can be based on the size of your window to use the material to calculate how much the cost, anyway, processing costs around 20 to 30, the installation fee is almost so much, with the loss of materials can be calculated, as long as you To understand what you want to do the weight of the profile just fine, so as not to be pit ...

Q:How best to paint a metal screen door. spray paint? What type and brand ?

krylon paint works best made for plastic and metal

Q:I mean for double protection against leakage , will a wooden door or a metal one of the cabinet where this oven is placed cut off hazardous radiations.

microwaves cannot pass through metal at all. even tin foil. the door of the microwave, as you might notice, has a sheet of metal with a bunch if round holes in it. the holes are just small enough that the microwaves cannot pass through them. as for the wood it would depend on what size. i don't believe that the microwave would pass through a piece of wood thicker than 1/2 inch. microwaves only penetrate food about a half to one inch. they cook the food by exciting the water molecules in the food and causing internal friction. the friction then spreads throughout the food. the wood should be enough to stop the waves. if you want to perform a science experiment put a glass of water in a wooden box and microwave it. the wood might get slightly warm as there is some water in wood. but if the water does not heat up then you would have your answer.

Q:I want a new front and back door. Concerend with security. Suggestions? Is metal worth it?

If you're seriously concerned about security, then don't get a steel door that's half glass, (big window on top). They look nice, but it can be broken. A small window on top, with a peep hole in the middle of the door works well, lets in some light, but keeps intruders out. They can break the glass but they can't reach the knob to unlock the door. Deadbolt is a must and make sure the latch plates are securely set into the door frame, which must be of good construction. I've seen lots of steel doors where the wooden outer frame was kicked in from the outside, and it broke the wood right out.

Q:how to put wood on a metal garage door?

I'm okorder .

Q:I purchased metal spray paint for my front door. Besides cleaning, does it need to be primed? I have a interior waterbased primer sitting around, would that work? Or can I basically just clean the door, sand it and apply the spray without priming it? The current color is beige and Im spraying a hammered black. Thanks in advance.

Your door came primed from the factory. Just clean good, wipe and let dry. Lay flat on horses out of full sun. Make passes from left to right across short width of door. Don't put on very heavy. Let dry 10-15 minutes- check to make sure it's dry. Now make passes the long way of the door, short spray . It's better to put on less paint than to put on too much on a single pass. Now go back to spraying across the door and then the length. For a good job I would say if you make 3 passes each way- you should have covered all the metal and eliminated blotching. Let dry 1 day then flip and paint other side and edges.

Q:I dont need it so much for security, just keeping my toddler inside!

absolutly. just have to use self tapping metal screws found at any harware store or wal-mart/kmart. just have to use a screw gun DO NOT try to do it by hand.

Q:How to repair a bi-fold metal door it keeps coming off track?

improperly installed or adjusted! Possibly the wheels that ride on the track are worn out and can be replaced at your local home center in most instances.

Q:Does anyone know of a website or place that sells chrome/metal interior door handles for a Honda Accord 93 4D LX.I dont know if such things are even made.I only ask because the plastic ones are crap.

i'd inform you to attempt a junk backyard yet which could be a puzzling locate. i understand..attempt an information superhighway salvage backyard and tell them precisely what you want and ask for a photo formerly you purchase it.

Q:permanent mark on a metal white door.

write over it with a dry eraser maker then wipe it off