Q:Please refer to the following

(1) the nature of the wire cutting discharge machine, the presence of dust in the air, will make the machine screw suffered serious wear and tear, thus affecting the service life; (2) line cutting discharge machine belonging to the computer control, the computer used disk

Q:What is the specific processing of wire cutting?

3, regardless of the hardness of the workpiece, as long as the conductive or semi-conductive materials can be processed.

Q:What is the metamorphic element?

The results show that the content of molybdenum content in the metamorphic layer is increased by the use of the molybdenum wire electrode in the molybdenum wire electrode. The content of the molybdenum element in the metamorphic layer is increased by the use of the copper wire electrode.

Q:The characteristics of EDM wire cutting

(2) Although the object to be machined is mainly a planar shape, except for any restrictions other than the minimum diameter R (metal wire radius + discharge gap) of the inner foot of a wire diameter, any complicated opening may be

Q:Line cutting ground wire is not easy to break the line

Increasing the tension of the wire can reduce the influence of the filament vibration, thereby improving the accuracy and cutting speed.

Q:Line cutting waste cutting fluid dirty, and would like to quickly precipitate follow-up, what is a good way?

Line cutting waste cutting fluid dirty can be purified recycling,

Q:Wire cut the parameters of cutting a repair two

The new machine is not the same as the old machine ...

Q:Line cut short after the automatic retraction of 30 minutes why the tube kept

, Compared to the current when the left and right commutation.

Q:How to effectively remove the whitening layer after discharge processing

EDM mold parts of the main processing means of its physical nature of the decision to use the means of processing mold surface surface of the surface of the metamorphic layer of the surface layer of metamorphic layer, metamorphic layer mold quality of life impact of the analysis and policy

Q:Line cutting high-frequency intermittent discharge processing, discharge work properly, do not discharge the table to stop running, how to do

High frequency part from your point of view, the machine is relatively large problem.