CNBM Polycrystalline Solar Panels with low price

Ref Price:
Loading Port:
Payment Terms:
Min Order Qty:
26 pc
Supply Capability:
100000 pc/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:


Characteristics of Polycrystalline Solar Panel

I Solar Cell : High efficiency crystalline solar cell. Even if under the weak light, the solar module can produce maximum power output.

II Tempered glass (toughened glass): Anti-reflecting coating and high transmission rate glass increase the power output and mechanical strength of solar module.

III EVA and TPT: Using high quality EVA and TPT to prevent destroying and water.

IV  AI frame: Without screw, corner connection. 6 holes on the frame can be installed easily.

V Junction box: Multi function junction box with water proof.

VI Long lifetime: ≥25 years; Less power decrease.

VII Good performance of preventing from atrocious weather such as wind and hails.

VIII Resisting moisture and etching effectively, not effected by geology. .


Standard Test Conditions of Polycrystalline Solar Panel

The opto-electrical specifications shown below are stabilized values being measured at Standard Test Conditions of multicrystalline silicon Solar Panel, Irradiance: 1000W/m2, Spectrum: AM1.5 at 25°C, The info below is subject to manufacturing tolerances. Where appropriate minutes of measurement are available and are used for the dimensioning of the installation.

Currently,We have 250w-300w solar panel stocks in Both West and East Coasts made in Vietnam,India,Korea,Malaysia and Japan.Meanwhile,we also arrange production line in Wisconsin,USA.If you're interested,please contact us soon.

Thanks for your time.


Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Does It really cost that much to Install solar panels?
It depends on the number and size of the panels. The minimum charge for a small bungalow would be at least $20,000 labor and material.
Q:can a light bulb power a solar panel?
This Site Might Help You. RE: can a light bulb power a solar panel? can u use a light bulb instead of the sun to power a solar panel
Q:Cost and energy generated by solar panel?
A little more than 0 watts per square foot, so that size panel would generate 250 watts under ideal conditions, which is noon on a sunny but not too hot day, near the equator. That's about /3 horsepower, or the same power as a man working hard. That is larger than needed to keep the battery of the car charged, unless you plan to run a laptop or something off it at night. The power is also too small to power the car for driving. If it's an electric car, you could get maybe another 2 miles per day out of the car, again, under ideal conditions. An RV store might have an idea of how much installation would cost. They would be accustomed to solar panels for RV's, but probably not small cars. A panel of that size would cost perhaps $500-800 just for the panel.
Q:Pls is it ok to connect a 0watt and 20watt solar panel together into a charge controller port?
Tobi, generally yes, solar panels are like beer, all the europeans get along fine, you can put two Belgiums in the same room as one German and three Englishman. As long as the panels have roughly the same open circuit voltage, usually around 8 volts, then go for it. If you're not sure about this, or the panels voltage disagrees dramatically, then they can still work through the same charge controller, the only other thing you need is a bypass diode in the junction box on the back of each panel. Most modern panels come with these already installed. They are simply electrical check valves, allowing current flow in one direction but not the other. The reason these matter is when the sun is first coming up, the higher voltage panel can force its power backwards through the lower voltage panel, at least until they both reach a voltage higher than the charge controller is set at. This is not a desirable thing to have happen, the 20 watt panel, if its voltage is higher, can damage the 0 watt panel without these diodes if the 20 watt has a much higher open circuit voltage, or Vmax. Look on the back of the panel for these ratings. The only other concern is maximum current. A charge controller has a maximum current it can handle, they are generally model numbered this way, a Xantrex C-60 for example has a 60 amp rating. Add up the Imax numbers on the back of all your panels, this is the maximum amperage the panel should put out. As long as it is not above 80% of your charger controllers maximum amperage, your good. Take care, Rudydoo
Q:Why are solar panels placed on the roof of houses?
Solar panels are placed on the roof because many times the roof has good exposure to the sun providing the roof is not blocked by trees or something else so that sufficient sunlight wouldn't be absorbed. Also the panels would more likely not get damaged on the roof opposed to being in the yard. If they were mounted on the windows, how could you see? And, the windows could easily break and then what would happen to the panels? Placing the solar panels on the floor would not be practical. A lot of sunlight is needed for the cells to produce electricity and how much goes on the floor? Most roofs are at an angle which could perhaps improve the amount of sunlight the panels would get, and roofs provide a lot of unused space. The roof is the best place. Furthermore, roof solar panels are available now to blend in better with the roof so that they are more pleasing to the eye. Even if you have a small roof, some panels could be placed there provided the roof is not blocked so that the sunlight it gets would be sufficient (about 4 or 5 hours of sunlight a day is needed). And, if you needed addition panels, they could be mounted in your yard as long as the mount was close to your power box and received sufficient sunlight. I applaud your desire to use solar panels. You could possibly save 50 - 90% on your electric bill and help your environment at the same time! A Win - Win situation!!
Q:Why do solar panels stop working?
If they get smashed, they won't work. Keep them clean, and they will last many years. I suppose there is a 'limit' to the effectiveness of the cells lifespan, but it must be more than 25-30 years. Just glass, metal frame and silica. No moving parts. Seems like a good deal.
Q:How long does it typically take for solar panels to pay for themselves?
Solar Panel Break Even
Q:Questions about Solar Panels and Battery back ups.?
Q:Making solar panels bad for the environment?
Sure your proper, sunlight panels (photovoltics) could be used to make electricity for small electronics. Proper now sun cells are on many calculators, and even flashlight. However the trouble is the lenght of time the cells take to charge the gadget, verses the vigour demand. I don;t consider the scale of the panels, and the period of time needed to charge the device are sensible. One think i've been thinking is that all should have a photovoltaic panel to charge a battery. Then, use the battery to cost phone telephones, MP3 palyers. The panel and the battery would be in regards to the 8 x eleven inches, and could sit down in window, or on a dash board to get charged, then utilized in doorways over night to charge contraptions.
Q:Will a 2W, 2V mono solar panel power up a laptop battery?
I'm afraid neither of these panels will do much for charging or running your laptop. If the power brick is supposed to emit 5 volts at 5 amps, that's 75 watts. Neither of those panels provides enough voltage and the power output is obviously far too small. The capabilities of solar power are vastly overestimated for small panels. Sunlight is limited to about kilowatt per square meter under ideal conditions (summer time, clear blue sky, for a few hours around noon in the US southwest). But consumer panels top out at about 5% efficiency, so your limit is 50 watts per square meter - in other words you would need about half a square meter, or about six square feet, of panel to provide 75 watts. And even under ideal conditions you will only get that much for a few hours each day. Also, the panel's voltage output is not regulated, so even if you find a panel that emits 5 volts (this would actually have to be made up of groups of 30 cells in series, as they emit half a volt each at most) you can't just connect the panel output into your laptop's DC in. You'd need a regulated DC-to-DC supply, and since that is not 00% efficient it will cost a bit of the power... now you need even more panel area. All in all, not really a practical thing to carry along on a camping trip.

1. Manufacturer Overview

Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range