Q:H3-h476841-TS6-H11 is the Honda civic civic gasket auto parts which part?

12 Honda wiper spray bottle, need to search Amoy treasure shop shop: * * Jushi sector 5068

Q:Installation requirements for gaskets

4, when sealing gasket is pressed, it is better to use torque wrench. For large bolts and high strength bolts, it is better to use hydraulic tightening devices. The tightening torque shall be calculated by calculation according to the given gasket. The size of the hydraulic pressure of the hydraulic tightening device shall also be determined by calculation.5. When installing the gasket, tighten the nut in sequence. However, the design value should not be screwed once. Generally should be recycled at least 2~3 times so that the gasket can be evenly distributed.6, the flammable and explosive medium pressure vessel and piping, replacing gasket should be used to avoid security tools, tool and flange bolts or collide, sparks, causing a fire or explosion accident.7, if there is leakage of the pipeline, it is necessary to reduce the pressure, then replace or adjust the installation of gasket, strictly prohibited with pressure operation.

Q:SUPOR electric pressure cooker lid off the gasket, how to install, how to install?

Is a small rubber ring on the exhaust valve, if it is pressed into the line.

Q:What is the difference between the sealing ring and the dust cap on the bearing?

Bearing belt, dust cover and sealing ring, two different performance. Refer toOne is dustproof and the other is sealed. Dust prevention is to prevent dust from entering the inside of the motor; the seal is not only not allowed by outside dust, but also not easy to flow out of the inner fat. Grease that is not clean is not easy to flow through. In practice, there is a difference between the two, but not too much. Bearings are generally internal and external oil cover, has played this role, only under certain conditions only need. Dust proof is indicated by Z and sealed by S. (felt ring seal is expressed by FS; rubber seal is expressed by LS).

Q:What kind of material does the gasket usually use?

PTFE gasket clamp and PTFE envelope gasket is made of rubber, asbestos, non asbestos, etc. soft pad and PTFE coated sheet combination, has excellent corrosion resistance and good compression resilience, PTFE seal is widely used in all kinds of strong acid, strong alkali, strong oxidation, chlorine and do not allow pollution medium. It is usually applied to middle and low pressure parts

Q:Is the cylinder ring ring the same as the cylinder liner?

The cylinder ring sealing ring is divided into static and dynamic seals to bear the pressure. The sealing ring of the cylinder liner will have O ring, U ring, Y ring and other forms of sealing ring. And the gasket is a static seal. The main section is square, and there are other forms. If you don't understand, you can ask me again.

Q:How do you get that washer in the lid of the beauty cooker?

Try to buy a beautiful electric cooker. Ask the waiter and let her show you

Q:What's the difference between a sealing washer and an elastic washer?

As far as the distinction is concerned, from the model point of view, the O ring has a fixed model name. For example, 3.1*50., and gaskets have fixed models, such as oil seals, 45*60*7.

Q:Explosion proof thread box plus GASKET?

It is not the key to add or not to encrypt the sealing ring, mainly to see if your cable can be sealed to meet the requirements of protection and to prevent the pulling of certain torque.

Q:I would like to ask how that kind of sealing gasket is made and processed. That's the kind of gasket that is thin in the bottle lid. What kind of PE material can be worked out with a machine and a grinding tool? ~ thank you ~!

The mould calculates the size of the gasket according to the bottle cap, then opens the mold according to the size of the gasket, then puts the raw material of the gasket into the mold, applies the press to the pressure, and finally processes the gasket